Tuning thermal and electrical properties of MXenes dehydration.

Recently, MXenes (a class of two-dimensional transition metal carbides) have attracted great attention in various applications such as humidity sensors, owing to their unique electrical and thermal properties. However, previous studies of MXenes mostly focus on their humidity-sensing characteristics such as the mechanical response, and only few reports on their electrical and thermal response are available. Herein, we present novel transient electrothermal experiments to demonstrate that a transition from a negative to a positive resistance-temperature relationship can take place when the MXene sample becomes fully dehydrated.

Partial ozonation of returned sludge via high-concentration ozone to reduce excess sludge production: A pilot study.

Partial ozonation of returned sludge via high and low concentration of ozone were compared to evaluate their efficiency in excess sludge production reduction. A pilot-scale system of anaerobic/anoxic/oxic (A/A/O) + ozonated sludge recycle (OSR) process was operated for 97 days, to investigate the effects of different ozone concentration (380 mg/L and 150 mg/L) on the nutrient removal capacity, sludge reduction rate, the excess sludge properties including settling, dewatering and anaerobic digestion (AD) performance. It was found that at the same total ozone dosage (13 mg/g MLSS, 25 mg/g MLVSS), the ozone of 380 mg/L achieved much higher organic matters and total excess sludge reduction (41.

Composition changes, releases, and potential exposure risk of PBDEs from typical E-waste plastics.

Since Stockholm Convention listed polybrominated diphenyl ethers (PBDEs) as persistent organic pollutants and banned their addition, alternative halogen flame retardants (AHFRs) have been substituted for PBDEs. This study systematically investigates the change trends of PBDEs and AHFRs from typical e-waste plastics and dust, as well as clarifying human exposure risks of PBDEs in formal and informal e-waste recycling enterprises, repair store and residential building. The results show that the PBDEs levels in five typical types of e-waste vary in the range of 1.

Self-Activated Catalytic Sites on Nanoporous Dilute Alloy for High-Efficiency Electrochemical Hydrogen Evolution.

Design and synthesis of effective electrocatalysts for hydrogen evolution reaction (HER) in wide pH environments are critical to reduce energy losses in water electrolyzers. Here, by using a self-activation strategy, we construct an atomic nickel (Ni) decorated nanoporous iridium (Ir) catalyst, which can create the reaction-favorable chemical environment and maximize the electrochemical active surface area (ECSA), enabling efficient HER over a wide pH range. By using X-ray absorption spectroscopy and theoretical calculations, the atomic Ni sites are identified as the synergistic sites, which not only accelerate the water dissociation under operation conditions but also activate the surface Ir sites thus leading to the efficient H generation.

Effect of pyrolysis temperature on the composition of DOM in manure-derived biochar.

Dissolved organic matter (DOM) plays an important role in the migration and transformation of nutrients and pollutants. Recently, DOM derived from biochar has the potential to determine the application of biochar and has attracted much researcher's attention. However, the effects of pyrolysis temperature on the composition evolution of DOM in manure-derived biochar are still unclear.

Carbon emissions under different domestic waste treatment modes induced by garbage classification: Case study in pilot communities in Shanghai, China.

The GHGs contributions (tally by carbon emissions) during treatment of domestic food waste and residual waste from pilot communities (contained 2365 families) in Shanghai, China, under different Modes induced by garbage classification were investigated. It was found that under the present condition of garbage classification in Shanghai, 51.8% of the food waste could be separated finally.

Strengthened dewaterability of coke-oven plant oily sludge by altering extracellular organics using Fe(II)-activated persulfate oxidation.

Although oily sludge has tremendous resource recovery value, its high water content has hindered its treatment and reuse. This study systematically explored the technical feasibility of using Fe(II)-activated persulfate oxidation (Fe/SO) to enhance the dewaterability of oily sludge. To identify the main factors controlling sludge dewatering, this study measured changes in chemical oxygen demand, ammonia nitrogen (NH-N) and extracellular polymeric substances (EPS).

Electrically regulating co-fermentation of sewage sludge and food waste towards promoting biomethane production and mass reduction.

Microbial electrolysis cell (MEC) was integrated into conventional anaerobic digestion (AD) system (i.e. MEC-AD) to electrochemically regulate the co-fermentation of food waste (FW) and sewage sludge (SS).

Effective gel-like floc matrix destruction and water seepage for enhancing waste activated sludge dewaterability under hybrid microwave-initiated Fe(II)-persulfate oxidation process.

Chemical conditioning before mechanical dewatering is an indispensable step to enhance the waste activated sludge (WAS) dewaterability and solid-liquid separation. Feasibility of utilizing Fe(II)/SO oxidation integrated with microwave irradiation (MW) in improving gel-like floc destruction, water seepage and WAS dewaterability was investigated. Comprehensive characterization of the treated WAS was conducted to explore the effects of MW on the catalyzing kinetics of Fe(II)/SO oxidation and reveal the underlying dewatering principle.

Three-Dimensional Nanoporous CoSP Pentlandite as a Bifunctional Electrocatalyst for Overall Neutral Water Splitting.

Significant progress has recently been achieved in developing noble-metal-free catalysts for electrochemical water splitting in acidic and alkaline electrolytes. However, high-performance bifunctional catalysts toward both hydrogen evolution and oxygen oxidation reactions of neutral water have not been realized in spite of the technical importance for electrochemical hydrogen production in natural environments powered by renewable energy sources of wind, solar, and so on. Here, we report a nanoporous CoSP pentlandite with three-dimensional bicontinuous nanoporosity for electrochemical water splitting in neutral solutions.

One-Dimensional Atomic Segregation at Semiconductor-Metal Interfaces of Polymorphic Transition Metal Dichalcogenide Monolayers.

Interface segregation is a powerful approach to tailor properties of bulk materials by interface engineering. Nevertheless, little is known about the chemical inhomogeneity at interfaces of polymorphic two-dimensional transition metal dichalcogenides (TMDs) and its influence on the properties of the 2D materials. Here we report one-dimensional monatomic segregation at coherent semiconductor-metal 1H/1T interfaces of Mo-doped WS monolayers.

Ultrarapid Multimode Microwave Synthesis of Nano/Submicron β-SiC.

This paper presents the design, development and realization of a fast and novel process for the synthesis of 3C silicon carbide (β-SiC) nanorods and submicron powder. Using SiO₂ (or Si) and activated carbon (AC), this process allows β-SiC to be synthesized with almost 100% purity in timeframes of seconds or minutes using multimode microwave rotary tube reactors under open-air conditions. The synthesis temperature used was 1460 ± 50 °C for Si + AC and 1660 ± 50 °C for SiO₂ + AC.

Simultaneous Optimization of Carrier Concentration and Alloy Scattering for Ultrahigh Performance GeTe Thermoelectrics.

In order to locate the optimal carrier concentrations for peaking the thermoelectric performance in p-type group IV monotellurides, existing efforts focus on aliovalent doping, either to increase (in PbTe) or to decrease (in SnTe and GeTe) the hole concentration. The limited solubility of aliovalent dopants usually introduces insufficient phonon scattering for thermoelectric performance maximization. With a decrease in the size of cation, the concentration of holes, induced by cation vacancies in intrinsic compounds, increases rapidly from ≈10 cm in PbTe to ≈10 cm in SnTe and then to ≈10 cm in GeTe.

Yeast-template synthesized Fe-doped cerium oxide hollow microspheres for visible photodegradation of acid orange 7.

Fe-doped cerium oxide (CeO) hollow microspheres were successfully synthesized by a simple co-precipitation route using yeast asa bio-template and nitrate as the oxide precursor. The products were characterized by scanning electron microscopy, X-ray diffraction, X-ray photoelectron spectroscopy, N adsorption-desorption isotherms and UV-Vis diffuse reflectance spectroscopy. It was found that the products had a well-defined ellipsoidal morphology and the size of the hollow microspheres was about 1.

Novel Perovskite Solar Cell Architecture Featuring Efficient Light Capture and Ultrafast Carrier Extraction.

A new perovskite solar cell (PSC) structure with a functionalized interface between perovskite and a hole transport material has been proposed in this report. The short circuit current density of PSC was notably enhanced with the novel architecture (with an increase of 8.7%), and a power conversion efficiency (PCE) of 16.

Removal of Cu(II) ions from contaminated waters using a conducting microfiltration membrane.

Efficient removal of toxic metals using low-pressure membrane processes from contaminated waters is an important but challenging task. In the present work, a conducting microfiltration membrane prepared by embedding a stainless steel mesh in the active layer of a polyvinylidene fluoride membrane is developed to remove Cu(II) ions from contaminated waters. Results showed that the conducting membrane had favorable electrochemical properties and stability as cathode.

New technology for recovering residual metals from nonmetallic fractions of waste printed circuit boards.

Recycling of waste printed circuit boards is important for environmental protection and sustainable resource utilization. Corona electrostatic separation has been widely used to recycle metals from waste printed circuit boards, but it has poor separation efficiency for finer sized fractions. In this study, a new process of vibrated gas-solid fluidized bed was used to recycle residual metals from nonmetallic fractions, which were treated using the corona electrostatic separation technology.

Ultrasmooth Perovskite Film via Mixed Anti-Solvent Strategy with Improved Efficiency.

Most antisolvents employed in previous research were miscible with perovskite precursor solution. They always led to fast formation of perovskite even if the intermediate stage existed, which was not beneficial to obtain high quality perovskite films and made the formation process less controllable. In this work, a novel ethyl ether/n-hexane mixed antisolvent (MAS) was used to achieve high nucleation density and slow down the formation process of perovskite, producing films with improved orientation of grains and ultrasmooth surfaces.

Effect of Worm Predation on Changes in Waste Activated Sludge Properties.

This study explored the effects of worm predation on changes in waste activated sludge properties. Results showed that the rate by which worm predation reduced mixed liquor volatile suspended solids (MLVSS) was approximately 23.7% ± 3.

Cooperation control strategies for China's cross-region pollution in a lake basin based on green reduction cost.

Unlabelled: The cross-region water pollution issue has always been the widespread concern around the world. It becomes especially critical for China due to the imbalance relates to environmental costs that have accompanied rapid growth of economy. Though the government makes great efforts to improve it, the potential for water pollution conflict is still great.

A Bi-layer Composite Film Based on TiO Hollow Spheres, P25, and Multi-walled Carbon Nanotubes for Efficient Photoanode of Dye-sensitized Solar Cell.

Abstract: A bi-layer photoanode for dye-sensitized solar cell (DSSC) was fabricated, in which TiO hollow spheres (THSs) were designed as a scattering layer and P25/multi-walled carbon nanotubes (MWNTs) as an under-layer. The THSs were synthesized by a sacrifice template method and showed good light scattering ability as an over-layer of the photoanode. MWNTs were mixed with P25 to form an under-layer of the photoanode to improve the electron transmission ability of the photoanode.

Comparison of UV/hydrogen peroxide and UV/peroxydisulfate processes for the degradation of humic acid in the presence of halide ions.

This study compared the behaviors of two classic advanced oxidation processes (AOPs), hydroxyl radical-based AOPs ((•)OH-based AOPs) and sulfate radical-based AOPs (SO4 (•-)-based AOPs), represented by UV/ hydrogen peroxide (H2O2) and UV/peroxydisulfate (PDS) systems, respectively, to degrade humic acid (HA) in the presence of halide ions (Cl(-) and Br(-)). The effects of different operational parameters, such as oxidant dosages, halide ions concentration, and pH on HA degradation were investigated in UV/H2O2/Cl(-), UV/PDS/Cl(-), UV/H2O2/Br(-), and UV/PDS/Br(-) processes. It was found that the oxidation capacity of H2O2 and PDS to HA degradation in the presence of halides was nearly in the same order.

Hot-Injection Synthesis of Cu-Doped Cu₂ZnSnSe₄ Nanocrystals to Reach Thermoelectric zT of 0.70 at 450°C.

As a new class of potential midrange temperature thermoelectric materials, quaternary chalcogenides like Cu2ZnSnS4 (CZTS) and Cu2ZnSnSe4 (CZTSe) suffer from low electrical conductivity due to insufficient doping. In this work, Cu-doped CZTSe nanocrystals consisting of polygon-like nanoparticles are synthesized with sufficient Cu doping contents. The hot-injection synthetic method, rather than the traditional one-pot method, in combination with the hot-pressing method is employed to produce the CZTSe nanocrystals.

Ultrafine FePd Nanoalloys Decorated Multiwalled Cabon Nanotubes toward Enhanced Ethanol Oxidation Reaction.

Ultrafine iron-palladium (FePd) nanoalloys deposited on γ-Fe2O3, FePd-Fe2O3, further anchored on carboxyl multiwalled carbon nanotubes (MWNTs-COOH), FePd-Fe2O3/MWNTs, were successfully synthesized by a facile one-pot solution based method as thermally decomposing palladium acetylacetonate (Pd(acac)2) and iron pentacarbonyl (Fe(CO)5) in a refluxing dimethylformamide solution in the presence of MWNTs-COOH. A 3.65 fold increase of peak current density was observed in cyclic voltammetry (CV) for ethanol oxidation reaction (EOR) compared with that of Pd/MWNTs after normalizing to Pd mass.

Lead recovery from scrap cathode ray tube funnel glass by hydrothermal sulphidisation.

This research focused on the application of the hydrothermal sulphidisation method to separate lead from scrap cathode ray tube funnel glass. Prior to hydrothermal treatment, the cathode ray tube funnel glass was pretreated by mechanical activation. Under hydrothermal conditions, hydroxyl ions (OH(-)) were generated through an ion exchange reaction between metal ions in mechanically activated funnel glass and water, to accelerate sulphur disproportionation; no additional alkaline compound was needed.