Calcium phosphate coatings were produced by pulsed laser deposition from targets of non-stoichiometric hydroxyapatite (Ca/P = 1.70) at a substrate temperature of 485 degrees C and different processing pressures of water vapour: 0.15, 0.30, 0.45, 0.60 and 0.80 mbar. The physicochemical properties of these coatings were studied using Fourier-transform IR spectroscopy (FT-IR) and energy dispersive X-ray analysis (EDX). A minimum pressure of water vapour was necessary in order to obtain a crystalline coating, as deduced from the FT-IR spectroscopy of these coatings. This analysis also revealed that when the deposition pressure of water vapour was further increased, the coatings were less crystalline and the content of hydroxyl groups, the carbonate substitution for phosphate, and the Ca/P ratio, as measured by EDX, were lower. These effects can be explained by a combined substitution of carbonate and HPO4(2-) for phosphate, being predominant the carbonate substitution at low pressures and the HPO4(2-) substitution at high pressures.
Download full-text PDF |
Source |
---|---|
http://dx.doi.org/10.1016/s0142-9612(97)00168-3 | DOI Listing |
ACS Nano
January 2025
Engineering Research Center of Forestry Biomass Materials and Bioenergy (Ministry of Education), National Forest and Grass Administration Woody Spices (East China) Engineering Technology Research Center, Beijing Forestry University, Beijing 100083, China.
Solar desalination is one of the effective means to alleviate water scarcity, in which aerogel-like evaporators have attracted extensive attention in the field of efficient desalination. However, the current preparation methods for aerogels still mainly rely on high-cost solutions, such as freeze-drying or supercritical drying. Herein, a preparation scheme for aerogels that can be realized under atmospheric pressure conditions is reported.
View Article and Find Full Text PDFBMC Med Educ
January 2025
Department of Forensic Medicine, Karnali Academy of Health Sciences, Chandannath, Jumla, 21200, Nepal.
Following the establishment of Nepal's first medical college in 1972, forensic medicine was introduced in 1978. To date, 25 medical colleges in the country have included forensic medicine as a compulsory subject in the undergraduate medical curriculum. Although this subject has been introduced into the medical curriculum, the outcome is unsatisfactory, as reflected by the poor medico-legal reports prepared by newly graduated medical students.
View Article and Find Full Text PDFEnviron Res
January 2025
Science and Technology Innovation Center of Smart Water and Resource Environment, Northeastern University, Shenyang 110819, China; School of Resources and Civil Engineering, Northeastern University, Shenyang 110819, China; Liaoning Institute of Technological Innovation in Solid Waste Utilization, Northeastern University, Shenyang 110819, China.
The preparation of low-carbon cementitious materials through the synergistic coupling of multiple solid wastes has great potential for development, which can improve the problems of resource shortage and environmental pollution. In this paper, a new type of supersulfated cement was developed by using calcium carbide residue (CCR) as an alkaline activator. The effects of CCR content on the mechanical properties and hydration behaviors of the samples under steam curing conditions were discussed.
View Article and Find Full Text PDFJ Hazard Mater
January 2025
BP Australia Pty Ltd, Melbourne, Victoria 3000, Australia.
Natural Source Zone Deletion (NSZD) is a viable long-term management option for sites impacted by petroleum hydrocarbon fuels. NSZD rate estimation methods for petroleum mass losses often use soil gas gradients of oxygen, carbon dioxide, methane or vapour concentrations through the vadose zone. Seeking greater efficiencies, we investigated if existing short-screened wells are reliable for representative sampling of soil gases in a vadose zone undergoing NSZD.
View Article and Find Full Text PDFWaste Manag
January 2025
Earth Sciences Department, University of Turin 10125 Turin, Italy.
This study investigates steam washing (SW) as an innovative pretreatment for municipal solid waste incineration fly ash (MSWI-FA) dechlorination, useful for a more effective stabilization in cementitious matrix. By using a detailed analytical approach (XRPD, XRF, ICP-MS, IRMS, SEM) and geochemical modeling, great focus is dedicated on pollutant leaching reduction and changes in ash physicochemical characteristics as a function of exposure time. The research demonstrates that SW removes up to 70 % cadmium, 17 % zinc, and 10 % lead, primarily by dissolving the soluble and carbonate/hydroxide fractions and promoting the reprecipitation and adsorption of heavy metals into more stable compounds.
View Article and Find Full Text PDFEnter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!