Effect of Pd and In on mercury evaporation from amalgams.

Dent Mater J

Department of Biomaterials Science, Baylor College of Dentistry, Texas A&M University System, Dallas, USA.

Published: December 1997

The amount of Hg vapor released from "synthesized" gamma 1 with 1% (wt) Pd was reported to be less than 30% of that from gamma 1 with no Pd. This study tested the hypothesis that Hg evaporation from Pd-containing amalgams decreases with Pd concentration and that In also reduces Hg vapor. Specimens (4 mm dia, 8 mm long) were prepared by triturating Ag-Sn(25%)-Cu(12%) alloy powder containing 0.5-9.0% Pd with pure Hg and by triturating 3% Pd alloy powder with Hg containing 1-5% In (all residual Hg approximately equal to 62%). The total amount (ng/mm2) of Hg vapor released at 37 degrees C from freshly prepared amalgams was measured. Pd (3-9%) in the powder significantly (p < 0.05) decreased Hg vapor release from amalgams during setting. Use of In-containing Hg also reduced Hg vapor release (5% In, p < 0.05). The reduction in the Hg vapor pressure by adding Pd and the rapid oxide film formation on the In-containing amalgam appear to work together to reduce Hg vaporization from these amalgams.

Download full-text PDF

Source
http://dx.doi.org/10.4012/dmj.16.191DOI Listing

Publication Analysis

Top Keywords

vapor released
8
alloy powder
8
vapor release
8
vapor
6
amalgams
5
mercury evaporation
4
evaporation amalgams
4
amalgams amount
4
amount vapor
4
released "synthesized"
4

Similar Publications

Botulinum neurotoxin type-A (BoNT/A), which blocks quantal acetylcholine (ACh) release at the neuromuscular junction (NMJ), has demonstrated its efficacy in the symptomatic treatment of blepharospasm. In 3.89% of patients treated for blepharospasm at Tenon Hospital, BoNT/A was no longer effective in relieving the patient's symptoms, and a partial upper myectomy of the muscle was performed.

View Article and Find Full Text PDF

Chemotherapy is still one of the major approaches in triple-negative breast cancer (TNBC) treatment. The development of new formulations for classic chemotherapeutic drugs remains interests in studies. Camptothecin (CPT) is powerful antitumor agents in TNBC treatment though its clinic applications are limited by its low water solubility and systemic toxicity.

View Article and Find Full Text PDF

Plant volatile aldehydes (PVAs) such as cinnamaldehyde (Cin), citral (Cit), citronellal (Citr), and perillaldehyde (Per) have broad-spectrum antimicrobial activity and show great potential in agricultural sustainable production. However, most PVAs not only have very high volatility but also are easily degradable in environment, which seriously restricts their wide application. To address the inherent problems with PVAs, four prodrugs based on PVAs are fabricated by conjugating individually Cin, Cit, Citr, and Per to sodium bisulfite (Sod) through a simple addition reaction and subsequently self-assembled into nanoparticles (prodrug self-assemblies) in aqueous solutions.

View Article and Find Full Text PDF

Introduction: Breast cancer, a formidable global health challenge for women, necessitates innovative therapeutic strategies with enhanced efficacy and minimal side effects. Aripiprazole (ARI), a widely used schizophrenia medication, exhibits promising potential in the treatment of breast cancer. As cancer therapy evolves towards a combination approach, multimodal nano-based delivery systems, such as ARI-loaded niosomes (NIOs) combined with Chitosan-Au nanoparticles for chemo-photothermal therapy, show promise over traditional chemotherapy alone by enhancing targeted efficacy and minimizing side effects.

View Article and Find Full Text PDF

Vaporized hydrogen peroxide uptake by tubing used for aseptic Fill-Finish manufacturing of biopharmaceutical drug products.

Eur J Pharm Biopharm

December 2024

ten23 health AG, Mattenstr. 22, 4058 Basel, Switzerland; Institute of Pharmaceutical Sciences, Department of Pharmaceutics, University of Freiburg, Sonnenstr. 5, 79104 Freiburg, Germany. Electronic address:

Aseptic filling of biopharmaceutical products requires a grade A cleanroom environment, preferably ensured by isolators in grade C surroundings. Isolators are decontaminated before the start of filling processes using vaporized hydrogen peroxide (VHP) and filling starts at pre-defined residual VHP levels (e.g.

View Article and Find Full Text PDF

Want AI Summaries of new PubMed Abstracts delivered to your In-box?

Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!