Purpose: To evaluate a computed tomographic (CT) artifact that simulates aortic dissection.
Materials And Methods: Two groups of 65 patients underwent spiral CT of the chest for reasons other than suspected aortic dissection. In each group, two series of images (10-mm sections) were reconstructed with use of a 180 degrees or 360 degrees linear-interpolation algorithm. Series of images were read by two radiologists, and variance between interpretations was statistically measured.
Results: Among series of images, artifacts were seen on 21-26 (32%-40%) with use of a 180 degrees algorithm and 41 (63%) and 44 (68%) with use of a 360 degrees algorithm. Concordance between reviewers was fair (kappa = 0.58, 0.59) or good (kappa = 0.65) with use of a 180 degrees algorithm and excellent (kappa = 0.92) with use of a 360 degrees algorithm. In one group, with use of a 180 degrees algorithm, two series of reconstructed images were separated by 5 mm; artifact was observed on seven (11%) CT studies (on both series of images) and was located along the left or left anterior side of the aorta.
Conclusion: To reduce the frequency of a spiral CT artifact that simulates aortic dissection, two series of segmented images can be reconstructed with a change of image position along the z axis of the aorta and use of a 180 degrees linear-interpolation algorithm.
Download full-text PDF |
Source |
---|---|
http://dx.doi.org/10.1148/radiology.205.1.9314977 | DOI Listing |
Purpose: overexpression/amplification in wild-type (WT) metastatic colorectal cancer (mCRC; human epidermal growth factor receptor 2 [HER2]-positive mCRC) appears to be associated with limited benefit from anti-EGFR antibodies and promising responses to dual-HER2 inhibition; however, comparative efficacy has not been investigated. We conducted a randomized phase II trial to evaluate efficacy and safety of dual-HER2 inhibition against standard-of-care anti-EGFR antibody-based therapy as second/third-line treatment in HER2-positive mCRC.
Methods: Patients with -WT mCRC after central confirmation of HER2 positivity (immunohistochemistry 3+ or 2+ and in situ hybridization amplified [HER2/CEP17 ratio >2.
Food Sci Biotechnol
January 2025
Department of Food and Nutrition, Sangmyung University, Seoul, Korea.
The characteristics of proteins extracted from two kinds of edible insects ( and , for G.B and T.M, respectively) were compared after roasting at 180 °C for 15 min and 200 °C for 10 min, respectively.
View Article and Find Full Text PDFLung
January 2025
National Clinical Research Center for Respiratory Disease, State Key Laboratory of Respiratory Disease, Guangzhou Institute of Respiratory Health, the First Affiliated Hospital of Guangzhou Medical University, Guangzhou, Guangdong, China.
Purpose: This study examined the concavity (angle β, central and peripheral concavity) of the descending limb of the maximal expiratory flow-volume (MEFV) curves to reflect various ventilatory defects, including obstructive, restrictive, or mixed patterns.
Methods: We conducted a cross-sectional study collecting spirometry data from a healthcare center and a tertiary hospital between 2017 and 2022, with additional raw flow-volume curve data from primary healthcare institutions in 2023. We analyzed differences in concavity between spirometric patterns.
Phys Rev Lett
December 2024
John A. Paulson School of Engineering and Applied Sciences, Harvard University, Cambridge, Massachusetts 02138, USA.
Two-dimensional (2D) materials that exhibit spontaneous magnetization, polarization, or strain (referred to as ferroics) have the potential to revolutionize nanotechnology by enhancing the multifunctionality of nanoscale devices. However, multiferroic order is difficult to achieve, requiring complicated coupling between electron and spin degrees of freedom. We propose a universal method to engineer multiferroics from van der Waals magnets by taking advantage of the fact that changing the stacking between 2D layers can break inversion symmetry, resulting in ferroelectricity as well as magnetoelectric coupling.
View Article and Find Full Text PDFSci Rep
January 2025
School of Electrical Engineering, Iran University of Science and Technology, Tehran, 1684613114, Iran.
Intelligent reflecting surfaces (IRS) are valuable tools for enhancing the intelligence of the propagation environment. They have the ability to direct EM Waves to a specific user through beamforming. A significant number of passive elements are integrated into metasurfaces, allowing for their incorporation onto various surfaces such as walls and buildings.
View Article and Find Full Text PDFEnter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!