Objectives: To quantify CO2 removal using an extracorporeal low-resistance membrane gas exchanger placed in an arteriovenous shunt and evaluate its effects on the reduction of ventilatory volumes and airway pressures during severe respiratory failure induced by smoke inhalation injury.

Design: Prospective study.

Setting: Research laboratory.

Subjects: Adult female sheep (n = 5).

Interventions: Animals were instrumented with femoral and pulmonary arterial catheters and underwent an LD50 cotton smoke inhalation injury via a tracheostomy under halothane anesthesia. Twenty-four hours after smoke inhalation injury, the animals were reanesthetized and systemically heparinized for cannulation of the left carotid and common jugular vein to construct a simple arteriovenous shunt. A membrane gas exchanger was interposed within the arteriovenous shunt, and blood flow produced by the arteriovenous pressure gradient was unrestricted at the time of complete recovery from anesthesia. CO2 removal by the gas exchanger was measured as the product of the sweep gas flow (FIO2 of 1.0 at 2.5 to 3.0 L/min) and the exhaust CO2 content measured with an inline capnometer. CO2 removed by the animal's lungs was determined by the expired gas CO2 content in a Douglas bag. We made stepwise, 20% reductions in ventilator support hourly. We first reduced the tidal volume to achieve a peak inspiratory pressure of < 30 cm H2O, and then we reduced the respiratory rate while maintaining normocapnia. PaO2 was maintained by adjusting the FIO2 and the level of positive end-expiratory pressure.

Measurements And Main Results: Mean blood flow through the arteriovenous shunt ranged from 1154 +/- 82 mL/min (25% cardiac output) to 1277 +/- 38 mL/min (29% cardiac output) over the 6-hr study period. The pressure gradient across the gas exchanger was always < 10 mm Hg. Maximum arteriovenous CO2 removal was 102.0 +/- 9.5 mL/min (96% of total CO2 production), allowing minute ventilation to be reduced from 10.3 +/- 1.4 L/min (baseline) to 0.5 +/- 0.0 L/min at 6 hrs of arteriovenous CO2 removal while maintaining normocapnia. Similarly, peak inspiratory pressure decreased from 40.8 +/- 2.1 to 19.7 +/- 7.5 cm H2O. PaO2 was maintained at > 100 torr (> 13.3 kPa) at maximally reduced ventilator support. Mean arterial pressure and cardiac output did not change significantly as a result of arteriovenous shunting.

Conclusions: Extracorporeal CO2 removal using a low-resistance gas exchanger in a simple arteriovenous shunt allows significant reduction in minute ventilation and peak inspiratory pressure without hypercapnia or the complex circuitry and monitoring required for conventional extracorporeal membrane oxygenation. Arteriovenous CO2 removal can be applied as an easy and cost-effective treatment to minimize ventilator-induced barotrauma and volutrauma during severe respiratory failure.

Download full-text PDF

Source
http://dx.doi.org/10.1097/00003246-199704000-00022DOI Listing

Publication Analysis

Top Keywords

co2 removal
28
gas exchanger
20
arteriovenous shunt
20
peak inspiratory
16
arteriovenous co2
16
minute ventilation
12
severe respiratory
12
respiratory failure
12
smoke inhalation
12
inspiratory pressure
12

Similar Publications

In the current years, gas-liquid membrane contactors (GLMCs) have been introduced as a promising, versatile and easy-to-operate technology for mitigating the emission of major greenhouse contaminants (i.e., CO and HS) to the ecosystem.

View Article and Find Full Text PDF

The CO adsorption capacity of biochar depends on the type of biomass used and its physicochemical properties; various sorption parameters including temperature, CO concentration, and humidity affect the CO adsorption capacity. Biochar derived from defatted black soldier fly larvae (BSFL) biomass was investigated for direct CO capture and exhibited a hydrophilic/mesoporous structure that contained high concentrations of alkali and alkaline metals (>10 wt%), which contribute to CO chemisorption. The CO adsorption efficiency was higher at 25 °C compared with that at 30 °C and 35 °C, probably due to reduced Brownian motion of CO molecules at lower temperatures.

View Article and Find Full Text PDF

Oxygen vacancy-rich defective tungsten oxide (WO) modified by Prussian blue for efficient photocatalytic carbon dioxide conversion and tetracycline degradation.

J Colloid Interface Sci

December 2024

Laboratory of Alternative Energy Conversion Systems, Department of Mechanical Engineering, School of Engineering, University of Thessaly, Pedion Areos 38834, Greece. Electronic address:

The coupling of carbon dioxide (CO) with epoxides to produce cyclic carbonates is a desirable decarbonization approach, but its commercial applicability is still restricted by the costly catalysts required, as well as the need for high temperature and high pressure. Herein, oxygen vacancy-rich defective tungsten oxide (WO) rich in Lewis acid sites was modified by Prussian blue (PB), and the obtained composite reaches up to 94 % styrene carbonate yield (171 mmol gh) at ambient temperature and pressure, exhibiting outstanding advantages in the photocatalytic CO cycloaddition reaction compared with currently reported photocatalysts. It is found that the introduction of PB with photothermal properties significantly enhances the capability of WO to absorb and activate CO and epoxide, along with its light utilization ability.

View Article and Find Full Text PDF

Potential Air Quality Side-Effects of Emitting HO to Enhance Methane Oxidation as a Climate Solution.

Environ Sci Technol

January 2025

Department of Atmospheric Sciences, University of Utah, Salt Lake City, Utah 84112, United States.

Methane (CH) is a greenhouse gas with a global warming potential 81.2 times higher than carbon dioxide (CO). The intentional emission of oxidants into the atmosphere has been proposed as a geoengineering solution to accelerate the oxidation of CH to CO, thereby reducing surface warming.

View Article and Find Full Text PDF

Emerging frontiers of nickel-aluminium layered double hydroxide heterojunctions for photocatalysis.

Dalton Trans

January 2025

National Forestry and Grassland Administration Key Laboratory of Plant Fiber Functional Materials, College of Materials Engineering, Fujian Agriculture and Forestry University, Fuzhou 350002, China.

The unique benefits of nickel-aluminium layered double hydroxide (Ni-Al LDH)-based heterojunctions, including large surface area, tunable bandgap and morphology, abundant reaction sites, and high activity, selectivity, and photostability, make them extremely promising for photocatalytic applications. Given the importance and benefits of Ni-Al LDH-based heterojunctions in photocatalysis, it is necessary to provide a summary of Ni-Al LDH-based heterojunctions for photocatalytic applications. Hence, in this review, we thoroughly described the material design for Ni-Al LDH-based heterojunctions, along with their recent developments in various photocatalytic applications, , H evolution, CO reduction, and pollutant removal.

View Article and Find Full Text PDF

Want AI Summaries of new PubMed Abstracts delivered to your In-box?

Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!