Purpose: To assess the effect of folding procedures on modulation transfer function (MTF) and resolving power (RP) in soft acrylic intraocular lenses (IOLs).
Setting: Faculty of Engineering, Chiba University, Chiba, Japan.
Methods: Folding procedures and other manipulations were performed on +18.0 diopter soft acrylic lenses (MA60BM, AcrySof, Alcon Surgical). The IOLs were then immersed in the water chamber of a model eye and MTF and RP under veiling glare light measured. The optical surfaces of the IOLs were examined microscopically.
Results: After the IOLs had been folded for 30 seconds, MTF recovered 8 and 6 minutes after unfolding in 20 degrees C 37 degrees C balanced salt solution, respectively. Prolonged folding of 10, 20, and 60 minutes did not affect the final MTF, which was measured 30 minutes after unfolding. However, RP deteriorated after the 60 minute folding. Optic damage was observed after the 20 and 60 minute foldings. Neither parameter changed after the IOLs were tightly folded for 30 seconds; however, both deteriorated slightly after the IOLs were tightly folded for 5 minutes, and minor damage was seen on the optics. With fewer than 10 artificial linear cracks in the central 3 mm of the optic, MTF was not affected; with 20 or fewer, RP was not affected. After forceps pressure on the central optic, MTF recovered within 6 minutes.
Conclusion: The optical quality of soft acrylic IOLs are not easily affected unless extreme nonphysiological manipulations are applied.
Download full-text PDF |
Source |
|---|---|
| http://dx.doi.org/10.1016/s0886-3350(96)80098-8 | DOI Listing |
Publication Analysis
Top Keywords
Similar Publications
Two-wavelength-selective Soft Actuators Comprising Thermosensitive and Lanthanoid-ion-coordinated Interpenetrating Polymer Network Gels.
J Oleo Sci
January 2025
Graduate School of Science and Technology, Kumamoto University.
Near-infrared wavelength-selective soft actuators have attracted much attention for applications in microsystems in bioliving. It is desirable for the photothermal conversion materials in the actuators to be downsized to the molecular scale. However, in conventional actuator materials using copolymer gels composed of thermosensitive and photothermal conversion molecule-coordinated monomers, the strong cross-linking of molecules in the networks impairs the actuator deformation.
View Article and Find Full Text PDFEncapsulation of Oil Droplets Using Film-Forming Janus Nanoparticles.
Langmuir
January 2025
School of Chemistry, Key Centre for Polymers and Colloids, The University of Sydney, Sydney, New South Wales 2006, Australia.
Polymer Janus nanoparticles with one hard cross-linked polystyrene lobe and one soft film-forming poly(methyl methacrylate--butyl acrylate) lobe were synthesized by reversible addition-fragmentation chain transfer (RAFT)-mediated emulsion polymerization. The Janus nanoparticles adsorbed to oil/water and air/water interfaces, where the soft lobes coalesced, forming films of thickness between 25 and 250 nm; droplets of silicone oil could be stably encapsulated in polymer in this way. When prepared by mechanical mixing without additives, capsules of diameter 5-500 μm could be prepared, and with additives and application of heat, capsules of diameter around 5 μm were achieved, even with highly viscous silicone oil (20,000 cSt).
View Article and Find Full Text PDFDentoalveolar and Skeletal Effects of an Anterior Open Bite Treatment Protocol Using Zygomatic Anchorage.
Orthod Craniofac Res
January 2025
Department of Orthodontics, Dental School, Okan University, Istanbul, Turkey.
Objective: Primary aim was to analyse dentoalveolar and skeletal effects induced by an anterior open bite (AOB) treatment protocol for intrusion of maxillary buccal segment. Secondary aim was to investigate whether a subsequent change occurred in hyoid position.
Materials And Methods: Study group included 28 non-growing subjects treated in academic setting for correction of AOB.
A safe and robust in-situ polymerized cementitious electrolyte coupled with NiCoS@CuCoS electrode for superior load-bearing integrated electrochemical capacitor.
J Colloid Interface Sci
January 2025
Key Laboratory of Advanced Civil Engineering Materials, Ministry of Education, School of Materials Science and Engineering, Tongji University, Shanghai 201804 PR China. Electronic address:
Load bearing/energy storage integrated devices (LEIDs) featuring cementitious electrolytes have become ideal for large-scale energy storage. Nevertheless, the progression of LEIDs is still in its nascent phase and considerable endeavors concerning cementitious electrolytes and electrode materials are necessary to further boost the charge storage ability. Here, we propose a facile synchronous reaction method for preparing sodium acrylate (SA)-based in-situ polymerized cementitious electrolyte.
View Article and Find Full Text PDFSynthesis and characterization of photo-cross-linkable quince seed-based hydrogels for soft tissue engineering applications.
Carbohydr Polym
March 2025
Institute of Biomedical Engineering, Department of Pharmacology and Physiology, Faculty of Medicine, University of Montreal, Montreal, QC H3T 1J4, Canada; Azrieli Research Center, Centre Hospitalier Universitaire Sainte-Justine, Montreal, QC H3T 1C5, Canada; Montreal TransMedTech Institute, Montreal, QC H3T 1J4, Canada. Electronic address:
The convenience, versatility, and biocompatibility of photocrosslinkable hydrogel precursors make them promising candidates for developing tissue engineering scaffolds. However, the current library of photosensitive materials is limited. This study reports, for the first time, the modification of quince seed mucilage (QS) with glycidyl methacrylate (GM), resulting in the synthesis of methacrylated QS (QSGM).
View Article and Find Full Text PDFWant AI Summaries of new PubMed Abstracts delivered to your In-box?
Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!