Susceptibility of Helicobacter pylori to bactericidal properties of medium-chain monoglycerides and free fatty acids.

Antimicrob Agents Chemother

Mead Johnson Research Center, Bristol-Myers Squibb Co., Evansville, Indiana 47721, USA.

Published: February 1996

Previous studies have shown that various short- and medium-chain free fatty acids (FFAs) and their corresponding monoacylglycerol esters (MGs) have antibacterial activity in vitro against primarily gram-positive bacteria. More recent studies have also shown that the growth of Helicobacter spp. is inhibited by linoleic acid and arachidonic acid. The purpose of the present study was to evaluate the susceptibility of Helicobacter pylori to the in vitro bactericidal properties of medium-chain MGs and FFAs. Incubation of H. pylori with saturated MGs, ranging in carbon chain length from C10:0 to C14:0, at 1 mM caused a 4-log-unit or greater reduction in the number of viable bacteria after exposure for 1 h. Lower levels of bactericidal activity were observed with C9:0, C15:0, and C16:0 MGs. In contrast, lauric acid (C12:0) was the only medium-chain saturated FFA with bactericidal activity against H. pylori. The MGs and FFAs were bactericidal after incubation for as little as 15 min at neutral or acidic pHs. Higher levels of MGs and FFAs were required for bactericidal activity in the presence of higher amounts of protein in liquid diets. We also found that the frequency of spontaneous development of resistance by H. pylori was higher for metronidazole and tetracycline (10(-5) to 10(-6)) than for C10:0 MG, C12:0 MG, and C12:0 FFA (< 10(-8)). Collectively, our data demonstrate that H. pylori is rapidly inactivated by medium-chain MGs and lauric acid and exhibits a relatively low frequency of spontaneous development of resistance to the bactericidal activity of MGs. Further studies are needed to establish whether MGs may be useful either alone or with other known therapeutic agents in the management of H. pylori infections in humans.

Download full-text PDF

Source
http://www.ncbi.nlm.nih.gov/pmc/articles/PMC163106PMC
http://dx.doi.org/10.1128/AAC.40.2.302DOI Listing

Publication Analysis

Top Keywords

bactericidal activity
16
mgs ffas
12
mgs
9
susceptibility helicobacter
8
helicobacter pylori
8
bactericidal properties
8
properties medium-chain
8
free fatty
8
fatty acids
8
medium-chain mgs
8

Similar Publications

Implants aim to restore skeletal dysfunction associated with ageing and trauma, yet infection and ineffective immune responses can lead to failure. This project characterized the microbiological and host cell responses to titanium alloy with or without electroplated metallic copper. Bacterial viability counting and scanning electron microscopy quantified and visualized the direct and indirect bactericidal effects of the Cu-electroplated titanium (Cu-Ep-Ti) against two different Staphylococcus aureus strains.

View Article and Find Full Text PDF

Self-Assembled Peptide Hydrogels PPI45 and PPI47: Novel Drug Candidates for Infection Treatment.

Gels

January 2025

Gene Engineering Laboratory, Feed Research Institute, Chinese Academy of Agricultural Sciences, Beijing 100081, China.

, a prevalent zoonotic pathogen, poses a significant threat to skin wound infections. This study evaluates the bactericidal efficacy of self-assembled peptide hydrogels, PPI45 and PPI47, derived from the defensin-derived peptide PPI42, against ATCC43300. The high-level preparation of PPI45 and PPI47 was achieved with yields of 1.

View Article and Find Full Text PDF

for targeting MRSA virulence: and studies.

Heliyon

January 2025

Department of Biological Sciences, Faculty of Science, Beirut Arab University, Tripoli, 1300, Lebanon.

The present study reports the characterization of the phytochemical content and the antibacterial activity of ethanolic extracts from the leaves (LE) and stems (SE) of against Methicillin resistant (MRSA. Important functional groups were determined by analyzing the FTIR spectra of LE and SE. The phytochemical profiles were analyzed by GC-MS, and these characterized the chemicals according to retention periods and peak regions.

View Article and Find Full Text PDF

Cold-Spray Deposition of Antibacterial Molybdenum Coatings on Poly(dimethylsiloxane).

ACS Appl Bio Mater

January 2025

Department of Chemistry and Biotechnology; School of Science, Computing & Engineering Technologies, Swinburne University of Technology, Hawthorn, Victoria 3122, Australia.

Despite their widespread utilization in biomedical applications, these synthetic materials can be susceptible to microbial contamination, potentially compromising their functionality and increasing the risk of infection in patients. In this study, molybdenum (Mo), an essential metal in biological systems, was investigated as a Mo-based cold-sprayed coating on poly(dimethylsiloxane) (PDMS) for its potential use as biocompatible and antimicrobial surfaces for biomedical applications. Various cold-spray parameters were employed in the fabrication of Mo-embedded PDMS surfaces to alter the surface structure of the substrate, Mo loading density, and embedding layer thickness.

View Article and Find Full Text PDF

This study aimed to investigate the impact of X-ray irradiation pretreatment at varying doses (0.5, 1.0, 1.

View Article and Find Full Text PDF

Want AI Summaries of new PubMed Abstracts delivered to your In-box?

Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!