Purpose: This article introduces a simple and reproducible classification of the degree of atrophy in fractures of the atrophic edentulous mandible, and evaluates the results of treatment in 84 consecutive fractures based on this classification.
Material And Methods: Eight-four fractures of the edentulous mandible, with a height at the fracture site of < or = 20 mm, were included. Using the ratio of actual plate width to plate width on the postoperative radiograph, the actual height of the mandible at the fracture site was calculated. Twenty-five fractures (30%) were in the Class I atrophy group (height at the fracture site 16 to 20 mm), 33 fractures (39%) occurred in Class II atrophic mandibles (height 11 to 15 mm), and 26 fractures (31%) were seen in extremely atrophic Class III mandibles (height < or = 10 mm). The treatment was performed by compression plating without any postoperative MMF. Primary bone grafting was used in six cases (7%) because a partial bone defect was present at the fracture site.
Results: In 81 (96.5%) of the 84 fractures an uncomplicated, solid, bony union was achieved. Three major complications occurred: one osteomyelitis and two nonunions. The two nonunions occurred in bilateral fracture of an extremely atrophied mandible (Class III atrophy). Minor soft tissue infections, without interference with fracture healing, were observed in six cases (7%).
Conclusions: Because there is an obvious relation between the height of the mandible and the incidence of complications in fracture healing, a special classification of the degree of atrophy is needed. In fractures of the extremely atrophic mandible (Class III atrophy) periosteal degloving should be avoided and supraperiosteal placement of plates is recommended. Compression osteosynthesis has proved to be a successful method, with minimal impairment of the patient and a low frequency of serious complications.
Download full-text PDF |
Source |
|---|---|
| http://dx.doi.org/10.1016/s0278-2391(96)90733-8 | DOI Listing |
Publication Analysis
Top Keywords
Similar Publications
Full mouth rehabilitation with fixed teeth supported prosthesis following hobo twin stage technique - A Case Report.
J Biol Methods
September 2024
Department of Prosthodontics, SRM Dental College, Bharathi Salai, Ramapuram, Chennai, Tamil Nadu, India.
Background: Worn dentition is a common problem encountered by most people in the last decade. Rehabilitation of a full mouth needs individual attention and proper treatment planning, which is very challenging for partial edentulous cases where bilateral teeth are missing and collapsed vertical dimension leaves inadequate restorative space. Treatment of these cases is complex and needs to apply standard principles while designing and fabricating prostheses.
View Article and Find Full Text PDFThe influence of prosthetic treatments and implant-supported prostheses on posterior mandibular ridge atrophy: a retrospective cohort study.
BMC Oral Health
January 2025
Division of Restorative Dentistry, Periodontology and Prosthodontics, Department of Dental Medicine and Oral Health, Medical University of Graz, Billrothgasse 4, Graz, 8010, Austria.
Aims: Bone preservation is a requirement for long-term stability of dental prostheses, which is all the more important in the posterior mandible, given the particular challenges these areas pose to prosthetic treatment. The objective was to investigate the implications of different prostheses on the atrophy of posterior alveolar bone after tooth loss.
Materials And Methods: A total of 457 treatment cases were retrieved from the medical documentation and information network.
Retention of CAD-CAM locator retentive attachment insert in mandibular implant overdenture.
BMC Oral Health
January 2025
Removable Prosthodontics Department, Faculty of Dentistry, October 6 University, Giza, Egypt.
Background: The continuous development in digital prosthodontics allowed the customization of attachments and retentive inserts which offers an easy and cheap solution for regular maintenance of locator overdentures during daily practice. The present study compared the change in retention values of the fully digitally manufactured custom-made locator attachment retentive insert with the ready-made ones after insertion, removal, and masticatory cycles.
Methods: A complete denture was constructed over a mandibular edentulous epoxy model.
Long-Term Clinical Study on Sandblasted-Acid-Etched Surface Dental Implants: 12-Year Follow-Up.
Materials (Basel)
January 2025
Comprehensive Dentistry for Adults and Gerodontology, Faculty of Dentistry, University of Seville, 41009 Seville, Spain.
Sandblasting and acid etching are common procedures used to treat implant surfaces, enhancing osseointegration and improving clinical success rates. This clinical study aimed to evaluate the long-term outcomes of sandblasted and acid-etched implants. A total of 303 implants were placed in 114 partially and totally edentulous patients using a two-stage surgical technique and an early loading protocol (6-8 weeks).
View Article and Find Full Text PDFTrueness of tooth modified scan bodies as a novel technique for edentulous full arch implant supported dental prosthesis: an in vivo prospective comparative study.
BMC Oral Health
January 2025
Oral Medicine, Periodontology and Oral Diagnosis, Faculty of Dentistry, Assiut University, Assiut, Egypt.
Objective: This study aimed to evaluate the clinical performance (degree of trueness) of a novel scan body "tooth-modified Scan body" (TMSB)& conventional scan body (CSB) in implant-supported full arch screw retained cases.
Methods: Seven edentulous arches (two maxillae, five mandibles) in 6 patients were rehabilitated with monolithic zirconia screw-retained implant prostheses supported by 4 (n = 1) and 5 implants (n = 6) for a total amount of 34 implants. Implant locations were scanned by intra-oral scanner (IOS) using two types of scan bodies, conventional scan bodies (CSB) in group (1) and tooth-modified scan bodies (TMSB) in group (2).
Want AI Summaries of new PubMed Abstracts delivered to your In-box?
Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!