The enhanced photolabeling properties of chlorinated phenyl azides are demonstrated by the synthesis and photolysis of methyl 4-azido-2,3,5,6-tetrachlorobenzoate (3) and methyl 4-azido-3,5-dichlorobenzoate (4). Photolysis of azide 3 in 1 M diethylamine/cyclohexane as the trapping medium gave 34% NH-insertion product. Similar photolysis of azide 4 gave 35% NH insertion product. These results demonstrate that chlorinated phenyl azides are significantly better at undergoing NH insertion than nonhalogenated analogs and suggest that improvement of existing aryl azide-based photolabels might be achieved by introduction of chlorine atoms on either side of the azide group. As an application, 3-azido-2,4-dichloro-10,5-(iminomethano)-10,11-dihydro-5H- dibenzo[a,d]cycloheptene (19), an analog of the potent PCP receptor ligand IDDC (14), was synthesized and its affinity for the PCP receptor was determined to be 6.3 +/- 0.7 microM (IC50 against [3H]MK801).

Download full-text PDF

Source
http://dx.doi.org/10.1021/bc00024a018DOI Listing

Publication Analysis

Top Keywords

chlorinated phenyl
12
phenyl azides
12
pcp receptor
12
receptor ligand
8
photolysis azide
8
azides photolabeling
4
photolabeling reagents
4
reagents synthesis
4
synthesis orthoortho'-dichlorinated
4
orthoortho'-dichlorinated arylazido
4

Similar Publications

In the integrated circuit manufacturing process, reverse osmosis (RO) membranes are widely used for wastewater reclamation. However, fouling by typical surfactants significantly reduces membrane efficiency and lifespan. This study investigates the fouling mechanisms of typical surfactants-cetyl trimethyl ammonium bromide (CTAB, cationic), sodium dodecyl sulfate (SDS, anionic), and polyoxyethylene octyl phenyl ether (TX, nonionic)-on RO membranes.

View Article and Find Full Text PDF

New haloaminopyrazole derivatives differing in the number of pyrazole nuclei - and -, respectively, were synthesized and characterized by H-NMR, C-NMR, IR, UV-Vis, and elemental analysis. The single-crystal X-ray diffraction method was used to describe compounds and . When tested on normal NCTC fibroblasts in vitro, the newly synthesized derivatives were shown to be non-cytotoxic at a dosage of 25 μg/mL.

View Article and Find Full Text PDF

The development of new protocols for stereospecific and stereoselective halogenation transformations by mild reaction conditions is a highly desirable research target for the chemical and pharmaceutical industries. Following the straightforward methodology for directly transforming a wide scope of alcohols to alkyl bromides and chlorides using substoichiometric amounts of thioureas and N-halo succinimides (NXS) as a halogen source in a single step, we noticed that in apolar solvents bromination of chiral secondary alcohols did not produce the expected racemates. In this study, the stereochemical aspects of the bromination reaction were examined.

View Article and Find Full Text PDF

A novel hybrid compound-2-(4,5-dihydro-1-imidazol-2-yl)phthalazin-1(2)-imine () was synthesized and converted into di-substituted sulfonamide derivatives - and phthalazine ring opening products-hydrazonomethylbenzonitriles -. The newly prepared compounds were characterized using elemental analyses, IR and NMR spectroscopy, as well as mass spectrometry. Single crystal X-ray diffraction data were collected for the representative compounds , , , , and .

View Article and Find Full Text PDF

Consumer products are important reservoirs and sources of organophosphate tri-esters and di-esters: Characteristics, mass inventory, and implication for waste management.

J Environ Sci (China)

May 2025

Guangdong Key Laboratory of Environmental Pollution and Health, School of Environment, Jinan University, Guangzhou 511443, China. Electronic address:

Numerous studies documented the occurrence of organophosphate tri-esters (tri-OPEs) and di-esters (di-OPEs) in the environment. Little information is available on their occurrence in waste consumer products, reservoirs and sources of these chemicals. This study collected and analyzed 92 waste consumer products manufactured from diverse polymers, including polyurethane foam (PUF), polystyrene (PS), acrylonitrile butadiene styrene (ABS), polypropylene (PP), and polyethylene (PE) to obtain information on the occurrence and profiles of 16 tri-OPEs and 10 di-OPEs.

View Article and Find Full Text PDF

Want AI Summaries of new PubMed Abstracts delivered to your In-box?

Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!