Several studies have shown that meniscectomy causes an immediate, acute increase in knee joint contact pressure and that changes in pressure distribution cause remodeling of bone and soft tissue. Presumably, this remodeling in turn affects contact pressures. This study tested the hypothesis that medial compartment contact pressure increases immediately after medial meniscectomy and then decreases with time. Supporting hypotheses regarding medial compartment contact area and lateral compartment pressures also were tested. Unilateral medial meniscectomy was performed on seven adult goats. Four or 8 months later, contact pressure and area were measured in vitro in the involved joints, as well as in the contralateral joints, before and after removal of the meniscus. The medial compartment pressures of the chronically meniscectomized joints were significantly less than those of the acutely meniscectomized paired joints but remained significantly greater than those of the intact joints. For the 4 and 8 month groups combined, the mean pressures of the acutely and chronically meniscectomized joints were greater than the pressures of the paired intact joints by 70 and 42%, respectively. The mean medial compartment contact areas of the acute and chronic joints were lower than those of the intact joints by 60 and 50%, respectively; mean lateral compartment pressures remained the same. This study indicates that joint remodeling reduces joint contact pressures. It also suggests that the effectiveness of a treatment to reduce pressure concentrations may be determined only by comparison, at the same postoperative time, of the pressure with that of the chronically meniscectomized joint, since pressures decreased with time without treatment.

Download full-text PDF

Source
http://dx.doi.org/10.1002/jor.1100110604DOI Listing

Publication Analysis

Top Keywords

contact pressure
16
medial compartment
16
joint contact
12
compartment contact
12
compartment pressures
12
chronically meniscectomized
12
intact joints
12
joints
9
knee joint
8
contact
8

Similar Publications

Neuromuscular Strategies in Dominant and Non-Dominant Legs in Dancers During Dynamic Balance Tasks.

J Dance Med Sci

January 2025

Frontier Research Institute of Convergence Sports Science, College of Educational Sciences, Yonsei University, Seoul, Korea.

Ballet-based dance training emphasizes the equal development of both legs. However, dancers often perceive differences between their legs during balance or landing. There still needs to be more consensus on the functional difference between dominant (D) and non-dominant legs (ND).

View Article and Find Full Text PDF

Direct Vascular Effects of Angiotensin II (A Systematic Short Review).

Int J Mol Sci

December 2024

Department of Physiology, Faculty of Medicine, Semmelweis University, 37-47 Tűzoltó Street, 1094 Budapest, Hungary.

The octapeptide angiotensin II (Ang II) is a circulating hormone as well as a locally formed agonist synthesized by the angiotensin-converting enzyme (ACE) of endothelial cells. It forms a powerful mechanism to control the amount and pressure of body fluids. All main effects are directed to save body salt and water and ensure blood pressure under basic conditions and in emergencies.

View Article and Find Full Text PDF

Accurate analyses of contact problems for rough surfaces are important but complicated. Some assumptions, namely that all asperities can be approximated by a hemisphere with the same radius and assuming a Gaussian distribution of the asperity heights, are convenient but may lead to less accurate results. The purpose of this work is to investigate these assumptions and analyze the conditions under which they are valid.

View Article and Find Full Text PDF

Surface Hydrophilic Modification of Polypropylene by Nanosecond Pulsed Ar/O Dielectric Barrier Discharge.

Materials (Basel)

December 2024

College of Electrical Engineering and Control Science, Nanjing Tech University, Nanjing 211816, China.

Polypropylene (PP) membranes have found diverse applications, such as in wastewater treatment, lithium-ion batteries, and pharmaceuticals, due to their low cost, excellent mechanical properties, thermal stability, and chemical resistance. However, the intrinsic hydrophobicity of PP materials leads to membrane fouling and filtration flux reduction, which greatly hinders the applications of PP membranes. Dielectric barrier discharge (DBD) is an effective technique for surface modification of materials because it generates a large area of low-temperature plasma at atmospheric pressure.

View Article and Find Full Text PDF

Friction is an unfavourable phenomenon in deep-drawing forming processes because it hinders the deformation processes and causes deterioration of the surface quality of drawpieces. One way to reduce the unfavourable effect of friction in deep-drawing processes is to use lubricants with the addition of hard particles. For this reason, this article presents the results of friction tests of dual-phase HCT600X+Z steel sheets using the flat die strip drawing test.

View Article and Find Full Text PDF

Want AI Summaries of new PubMed Abstracts delivered to your In-box?

Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!