The effect of the addition of cetyltrimethylammonium bromide (CTAB) to the buffer system in capillary electrophoresis on electroosmotic flow (EOF) is examined. At a CTAB concentration of 2.5 x 10(-4) M, EOF is anodal (flow towards the positive detector column end). With bare silica columns, anodal EOF first increases with increasing pH, up to a maximum in the pH range 4-6 depending on CTAB concentration, then decreases as pH is further increased. Optimum resolution of pyridinecarboxylic acid isomers is obtained at pH 2.7 with a 10 mM phosphate buffer and 30 mM CTAB. Using the same buffer system, optimum resolution for hydroxy-substituted pyridinecarboxylic acid isomers is obtained at pH 7.5. The use of CTAB results in a dramatic improvement in peak shape. Preliminary results, using an excimer laser operated at 248 nm, show that the fluorescence intensity of isonicotinic acid is substantially enhanced with the addition of 0.3% hydrogen peroxide to the phosphate buffer system.

Download full-text PDF

Source
http://dx.doi.org/10.1016/0021-9673(93)83190-4DOI Listing

Publication Analysis

Top Keywords

pyridinecarboxylic acid
12
acid isomers
12
buffer system
12
cetyltrimethylammonium bromide
8
electroosmotic flow
8
ctab buffer
8
ctab concentration
8
optimum resolution
8
phosphate buffer
8
ctab
5

Similar Publications

A mononuclear iron(II) complex constructed using a complementary ligand pair exhibits intrinsic luminescence-spin-crossover coupling.

Dalton Trans

January 2025

State Key Laboratory of Fine Chemicals, Frontier Science Center for Smart Materials, School of Chemical Engineering, Dalian University of Technology, No. 2 Linggong Road, Dalian 116024, P. R. China.

Molecular materials that exhibit synergistic coupling between luminescence and spin-crossover (SCO) behaviors hold significant promise for applications in molecular sensors and memory devices. However, the rational design and underlying coupling mechanisms remain substantial challenges in this field. In this study, we utilized a luminescent complementary ligand pair as an intramolecular luminophore to construct a new Fe-based SCO complex, namely [FeLL](BF)·HO (1-Fe, L is a 2,2':6',2''-terpyridine (TPY) derivative ligand and L is 2,6-di-1-pyrazol-1-yl-4-pyridinecarboxylic acid), and two isomorphic analogs (2-Co, [CoLL](BF)·HO and 3-Zn, [ZnLL](BF)·HO).

View Article and Find Full Text PDF

Carbon-based hole transport layer (HTL)-free perovskite solar cells (C-PSCs) receive a lot of attention because of their simplified preparation technology, low price, and good hydrophobicity. However, the Schottky junction formed at the interface between perovskite and carbon poles affects the photogenerated carrier extraction and conversion efficiency. In this paper, 4-trifluoromethyl-2-pyridinecarboxylic acid (TPCA) is used to modify the perovskite films.

View Article and Find Full Text PDF

Natural volatile organic compounds (NVOCs) and airborne microorganisms in different stands of urban forests.

Sci Total Environ

December 2024

College of Horticulture and Landscape Architecture, Yangzhou University, Yangzhou, China. Electronic address:

Article Synopsis
  • This study investigates the presence of natural volatile organic compounds (NVOCs) and airborne microorganisms in the Zhuyu Bay urban forest, focusing on their impact on air quality and human health.
  • Researchers used gas chromatography-mass spectrometry (GC-MS) to analyze NVOCs, finding terpenes, heterocyclic compounds, and esters as the most prevalent components, with certain terpenoids exhibiting antibacterial and antioxidant properties.
  • Additionally, air moisture was found to enhance the proportion of bacteria, while the bamboo forest had the fewest culturable airborne microorganisms, highlighting the influence of urban microclimates on these factors.*
View Article and Find Full Text PDF

In this work, we applied commercially available 2-pyridinecarboxylic acid to modify cellulose by simple manipulations, and then anchored low-toxicity metal nickel onto the modified cellulose to prepare the heterogeneous catalyst (CL-AcPy-Ni). The obtained catalyst was characterized by FT-IR, TG-DSC, BET, XRD, SEM-EDS, ICP-OES, XPS, and GPC. The catalytic performance of CL-AcPy-Ni in the Suzuki cross-coupling reaction was investigated using 4-methyl iodobenzene and phenylboronic acid as the model substrates reacting in THF under 120 °C for 24 h.

View Article and Find Full Text PDF

Want AI Summaries of new PubMed Abstracts delivered to your In-box?

Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!