An implantable potentiostat-radiotelemetry system for in vivo sensing of glucose is described. An enzyme electrode sensor measures the oxidation current of hydrogen peroxide formed by the stoichiometric conversion of glucose substrate and oxygen cofactor in an immobilized glucose oxidase layer. The sensor current is converted to a frequency and transmitted at programmable intervals (4, 32, 256 s) to a remote receiver. Low power CMOS circuitry is employed and device operation for up to 1.5 years is predicted using two series connected 250 mAh lithium cells. Crystal controlled RF frequencies uniquely identify each sensor allowing over 10 sensors within the same 10 m radius. A custom interface card allows a PC to program the receiver and handle the transmitted sensor data using software written in Microsoft C and QuickBasic. Software control allows on-the-fly sensor addition or subtraction to the sensor group being monitored. Over 10 sensors can be tracked long-term using the longest transmit interval, or four sensors can be tracked during short-term infusion studies when the transmit interval is reduced to 4 s. The design, construction, operation, and performance of the system hardware and software are described and evaluated.
Download full-text PDF |
Source |
---|---|
http://dx.doi.org/10.1109/10.324525 | DOI Listing |
Front Robot AI
January 2025
School of Metallurgy and Materials, University of Birmingham, Birmingham, United Kingdom.
Introduction: The transition to electric vehicles (EVs) has highlighted the need for efficient diagnostic methods to assess the state of health (SoH) of lithium-ion batteries (LIBs) at the end of their life cycle. Electrochemical Impedance Spectroscopy (EIS) offers a non-invasive technique for determining battery degradation. However, automating this process in industrial settings remains a challenge.
View Article and Find Full Text PDFFront Digit Health
January 2025
Biostatistics and Research Decision Sciences, Merck & Co., Inc., Rahway, NJ, United States.
Background: Current methods of measuring disease progression of neurodegenerative disorders, including Parkinson's disease (PD), largely rely on composite clinical rating scales, which are prone to subjective biases and lack the sensitivity to detect progression signals in a timely manner. Digital health technology (DHT)-derived measures offer potential solutions to provide objective, precise, and sensitive measures that address these limitations. However, the complexity of DHT datasets and the potential to derive numerous digital features that were not previously possible to measure pose challenges, including in selection of the most important digital features and construction of composite digital biomarkers.
View Article and Find Full Text PDFACM Trans Access Comput
December 2024
University of California, Santa Cruz, 1156 High Street, Santa Cruz, California, USA.
We describe two iOS apps designed to support blind travelers navigating in indoor building environments. The Wayfinding app provides guidance to a blind user while following a certain route. The Backtracking app records the route taken by the walker towards a certain destination, then provides guidance while re-tracing the same trajectory in the opposite direction.
View Article and Find Full Text PDFCoal mining industry is one of the main source for economy of every nations, whereas safety in the underground coal mining area is still doubtful. According to some reports, there is heavy loss of life and money due to the occasional accidents in the coal mining area. Some existing researchers has been addressed this issue and approached their method.
View Article and Find Full Text PDFPolymers (Basel)
January 2025
Department of Mechanical Engineering, Faculty of Engineering, University of Porto, 4200-465 Porto, Portugal.
Smart textiles provide a significant technological advancement, but their development must balance traditional textile properties with electronic features. To address this challenge, this study introduces a flexible, electrically conductive composite material that can be fabricated using a continuous bi-component extrusion process, making it ideal for sensor electrodes. The primary aim was to create a composite for the filament's core, combining multi-walled carbon nanotubes (MWCNTs), polypropylene (PP), and thermoplastic elastomer (TPE), optimised for conductivity and flexibility.
View Article and Find Full Text PDFEnter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!