Three methods for measuring ammonia in air have been evaluated. Filters impregnated with 10% (volume/volume) phosphoric acid in methanol were used for two methods. Sampling was done either with a filter cassette connected to a pump or with the filters placed in a passive monitor (Gasbadge). The filters were leached with distilled water after the sampling and analyzed with ion chromatography or colorimetry (Nessler). The third method tested was a colorimetric air-monitoring badge system (ProTek). The tests showed that the accuracy of the filter methods is good and that the results are not affected by humidity. If ion chromatography is used for the analysis, amines do not interfere. The Gasbadge monitors increased their uptake when the air velocity over the sampler was raised from 0.2 to 1.0 m/s. The accuracy of the ProTek method was poor, the method was biased, and blank samples showed high values. In field tests carried out in a foundry and at a fertilizer plant, the agreement between the filter methods was good, whereas the results of the ProTek method deviated drastically from those of the other methods.

Download full-text PDF

Source
http://dx.doi.org/10.5271/sjweh.2350DOI Listing

Publication Analysis

Top Keywords

ammonia air
8
ion chromatography
8
filter methods
8
methods good
8
protek method
8
methods
6
development evaluation
4
evaluation field
4
field methods
4
methods ammonia
4

Similar Publications

Since 2011, Caribbean territories have experienced massive and repeated sargassum seaweed inundations. Once on shore, sargassum degradation through anaerobic metabolism elicits the release of many noxious molecules, including hydrogen sulfide (HS) and ammonia (NH). HS has been long recognized as a malodorous and highly toxic gas, while chronic exposure has not been extensively explored.

View Article and Find Full Text PDF

Development of Betalain-immobilized polylactic acid nanofibers as a green and sustainable sensor for toxic ammonia.

Int J Biol Macromol

December 2024

National Research Centre (Scopus Affiliation ID 60014618), Textile Industries Research Division, Pre-treatment and Finishing of Cellulose Based Textiles Department, 33 El-Buhouth St., (former El-Tahrir St.), Dokki, P.O. 12622, Giza, Egypt.

Ammonia has been an important industrial colorless agent. Exposure to gaseous ammonia results in organ damage or even death. Herein, an environmentally friendly colorimetric detector for aqueous and gaseous ammonia was prepared utilizing vapochromic polylactic acid nanofibers.

View Article and Find Full Text PDF

Aerosol ammonium (NH) is a critical component of particulate matter that affects air pollution, climate, and human health. Isotope-based source apportionment of NH is essential for ammonia (NH) mitigation but the role of kinetic vs equilibrium controls on nitrogen isotope (δN) fractionation between NH and NH remains unresolved. Based on concurrent measurements of NH and NH in winter Beijing, we observed that the difference of δN between NH and NH on clean days (3.

View Article and Find Full Text PDF

Air pollution monitoring and modeling are the most important focus of climate and environment decision-making organizations. The development of new methods for air quality prediction is one of the best strategies for understanding weather contamination. In this research, different air quality parameters were forecasted, including Carbon Monoxide (CO), Nitrogen Monoxide (NO), Nitrogen Dioxide (NO), Ozone (O), Sulphur Dioxide (SO), Fine Particles Matter (PM), Coarse Particles Matter (PM), and Ammonia (NH).

View Article and Find Full Text PDF

This study aims to explore the redispersibility of dehydrated nanocellulose with p-toluenesulfonic acid (p-TsOH) fractionated lignin as an eco-friendly and cost-effective capping agent, to cope with the challenge of irreversible agglomeration and thus loss of nanoscale of nanocellulose upon dehydration. The intermixing of nanocellulose and p-TsOH fractionated lignin was achieved using an aqueous ethanol solution as the medium and films of lignin-blending cellulose nanofibers (L + CNF) with excellent redispersing properties were obtained after facile air-drying. With 0.

View Article and Find Full Text PDF

Want AI Summaries of new PubMed Abstracts delivered to your In-box?

Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!