Characterization of the Microstructure and Interfacial Morphology of Magnetic Pulse Welded Steel/Al Tubes.

Facing the global energy crisis and increasingly stringent environmental protection regulations, automotive lightweighting has become a core issue for the sustainable development of the automotive industry. In particular, the qualified combination of steel and aluminum alloy has become a promising development direction to achieve the aim of lightweight design. As an innovative solid-phase welding technique, magnetic pulse welding (MPW) exhibits unique advantages in joining these dissimilar metals. The 6061 Al alloy and 20# steel tubes were joined by the MPW technique in this study. The microstructure and interface morphology of the MPW steel/Al tube were characterized using optical microscopy (OM), scanning electron microscopy (SEM), and an electro-probe microanalyzer (EPMA). The microstructure in the region adjacent to the interface was similar to that of the base metals (BMs). The element transition zone could be observed at the interface. The thickness of the transition layer was approximately 6 μm. The transition layer did not possess high hardness and brittleness like the Fe-Al binary IMC layer. Therefore, the interface bonding quality and long-term stability of the MPW steel/Al joint were relatively good. The welded joint interface could be divided into three zones: the bonded zone in the center and unbonded zones on both sides. In particular, an obvious wavy interface with gradually increased amplitude was detected in the bonded zone. The interaction between the reflected wave and the welding collision point could promote the initiation of the wavy interface. In addition, the formation of the wavy interface depended on the impact velocity and angle of the MPW process. The qualified mechanical properties of the joint could be attributed to the formation of the wavy interface. The microhardness at the interface was higher than that on both sides, owing to work hardening, at approximately 226 HV.