Accurately measuring the thickness of the oxide film that accumulates on nuclear fuel assemblies is critical for maintaining nuclear power plant safety. Oxide film thickness typically ranges from a few micrometers to several tens of micrometers, necessitating a high-precision measurement system. Eddy current testing (ECT) is commonly employed during poolside inspections due to its simplicity and ease of on-site implementation. The use of swept frequency technology can mitigate the impact of interference parameters and improve the measurement accuracy of ECT. However, as the nuclear assembly is placed in a pool for inspection, a cable several dozen meters in length is used to connect the ECT probe to the instrument. The measurement is affected by the transmission line and its effect is a function of the operating frequencies, resulting in errors for swept frequency measurements. This paper proposes a method for precisely measuring oxide film thickness based on the swept frequency technique and long transmission line impedance correction. The signals are calibrated based on a transmission line model of the cable, effectively eliminating the influence of the transmission cable. A swept frequency signal-processing algorithm is developed to separate the parameters and calculate oxide film thickness. To verify the feasibility of the method, measurements are conducted on fuel cladding samples with varying conductivities. It is found that the method can accurately assess oxide film thickness with varying conductivity. The maximum error is 3.42 μm, while the average error is 1.82 μm. The impedance correction reduces the error by 66%. The experimental results indicate that this method can eliminate the impact of long transmission cables, and the algorithm can mitigate the influence of material conductivity. This method can be utilized to measure oxide film thickness in nuclear power maintenance inspections following extensive testing and engineering optimization.

Download full-text PDF

Source
http://dx.doi.org/10.3390/s25020579DOI Listing

Publication Analysis

Top Keywords

oxide film
28
film thickness
24
swept frequency
20
impedance correction
12
based swept
8
transmission cable
8
nuclear power
8
long transmission
8
film
7
thickness
7

Similar Publications

Photothermal/photodynamic synergistic antibacterial Nanocellulose film modified with antioxidant MXene-PANI Nanosheets.

Int J Biol Macromol

January 2025

Jiangsu Co-Innovation Center of Efficient Processing and Utilization of Forest Resources, International Innovation Center for Forest Chemicals and Materials, College of Light Industry and Food Engineering, Nanjing Forestry University, Nanjing 210037, China. Electronic address:

TEMPO-CNF film modified by two-dimension transition metal MXene has certain antibacterial properties. However, the problem of long-lasting stability greatly restricts the feasibility of long-term use of the composite film. Here, we introduced polyaniline (PANI) as a modifying molecule, which was electrostatically adsorbed on the surface of the MXene nanosheets to prevent its self-stacking and delay its oxidation.

View Article and Find Full Text PDF

Enhancing curcumin stability and bioavailability through chickpea protein isolate-citrus pectin conjugate emulsions: Targeted delivery and gut microecology modulation.

Int J Biol Macromol

January 2025

School of Food Science and Technology, Shihezi University, Shihezi, Xinjiang 832003, China; Key Laboratory of Characteristics Agricultural Product Processing and Quality Control (Co-construction by Ministry and Province), Ministry of Agriculture and Rural Affairs, Shihezi University, Shihezi, Xinjiang 832000, China; Key Laboratory for Food Nutrition and Safety Control of Xinjiang Production and Construction Corps, Shihezi University, Shihezi, Xinjiang 832000, China. Electronic address:

The limited solubility, rapid metabolism, and poor bioavailability of curcumin restrict its application. In this study, we synthesized chickpea protein isolate (CPI)-citrus pectin (CP) conjugates to prepare an emulsion delivery system that enhances the stability and bioavailability of curcumin. The CPI-CP emulsion achieved a curcumin encapsulation efficiency of 86.

View Article and Find Full Text PDF

Impact of Combined Thermo- and Photo-Oxidation on the Physicochemical Properties of Oxo-Biodegradable Low-Density Polyethylene Films.

Polymers (Basel)

January 2025

Unidad de Materiales, Centro de Investigación Científica de Yucatán, Calle 43 No. 130 Col. Chuburná de Hidalgo, Merida 97205, Mexico.

This research addresses the study of the combined effect of two abiotic treatments, a thermo-oxidative treatment followed by a photo-oxidative treatment with ultraviolet light, on the physicochemical properties of commercially available low-density polyethylene films with an oxo-degradant additive (OXOLDPE) and without (LDPE). The change in the oxidized film properties was characterized using FTIR, XRD, TGA, GPC, and SEM analytical techniques. The results indicated that the increment in carbonyl index (CI) and crystallinity percentage (X) was higher for those films that received the combined oxidative treatments compared with those that received only one of them, thermo- or photo-oxidative treatment.

View Article and Find Full Text PDF

: This study aimed to evaluate the therapeutic effects of combined 5% lifitegrast (LF) and tocopherol (TCP) eye drops in a murine experimental dry eye (EDE) model. Female C57BL/6 were divided into seven groups: untreated controls, EDE control, EDE + 0.05% cyclosporin A (CsA), EDE + tocopherol (TCP), EDE + 5% LF, EDE + 5% LF + TCP (once daily), and EDE + 5% LF + TCP (twice daily).

View Article and Find Full Text PDF

(1) Background: Surra is a debilitating disease of wild and domestic animals caused by (), resulting in significant mortality and production losses in the affected animals. This study is the first to assess the genetic relationships of in naturally affected buffaloes from Multan district, Pakistan, using ITS-1 primers and evaluating the effects of parasitemia and oxidative stress on DNA damage and hematobiochemical changes in infected buffaloes. (2) Methods: Blood samples were collected from 167 buffaloes using a multi-stage cluster sampling strategy, and trypomastigote identification was performed through microscopy and PCR targeting RoTat 1.

View Article and Find Full Text PDF

Want AI Summaries of new PubMed Abstracts delivered to your In-box?

Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!