Increasing attention to sustainability and cost-effectiveness in energy storage sector has catalyzed the rise of rechargeable Zinc-ion batteries (ZIBs). However, finding replacement for limited cycle-life Zn-anode is a major challenge. Molybdenum disulfide (MoS), an insertion-type 2D layered material, has shown promising characteristics as a ZIB anode. Nevertheless, its high Zn-ion diffusion barrier because of limited interlayer spacing substantiates the need for interlayer modifications. Here, N-doped carbon quantum dots (N-CQDs) are used to modify the interlayers of MoS, resulting in increased interlayer spacing (0.8 nm) and rich interlayer dislocations. MoS@N-CQDs attain a high specific capacity (258 mAh g at 0.1 A g), good cycle life (94.5% after 2000 cycles), and an ultrahigh diffusion coefficient (10 to 10 cm s), much better than pristine MoS. Ex situ Raman studies at charge/discharge states reveal that the N-CQDs-induced interlayer expansion and dislocations can reversibly accommodate the volume strain created by Zn-ion diffusion within MoS layers. Atomistic insight into the interlayer dislocation-induced Zn-ion storage of MoS is unveiled by molecular dynamic simulations. Finally, rocking-chair ZIB with MoS@N-CQDs anode and a ZnMnO cathode is realized, which achieved a maximum energy density of 120.3 Wh kg and excellent cyclic stability with 97% retention after 15 000 cycles.
Download full-text PDF |
Source |
---|---|
http://dx.doi.org/10.1002/smll.202410408 | DOI Listing |
J Phys Chem Lett
January 2025
Thin film Energy Storage Laboratory, Department of Physics and Nanotechnology, SRM Institute of Science and Technology, Kattankulathur 603 203Tamil Nadu India.
Manganese oxides are a promising cathode material for aqueous zinc-ion batteries (AZIBs), but thin-film configurations remain underexplored. This study investigates the electrochemical dynamics of 60 nm thin MnO thin films, fabricated via RF magnetron reactive sputtering. It addresses the highest reported capacity (25 mAh/g) in thin film form, stability over 500 cycles, effective performance across varying current rates, surpassing previous studies and challenges such as phase stability, and capacity fading over extended cycling, aiming to enhance uniformity, minimizing diffusion barriers for improved performance.
View Article and Find Full Text PDFLangmuir
January 2025
College of Materials Science and Engineering, Sichuan University, Chengdu 610064, China.
Metallic Zn is a promising anode for high-safety, low-cost, and large-scale energy storage systems. However, it is strongly hindered by unstable electrode/electrolyte interface issues, including zinc dendrite, corrosion, passivation, and hydrogen evolution reactions. In this work, an in situ interface protection strategy is established by turning the corrosion/passivation byproducts (zinc hydroxide sulfates, ZHSs) into a stable hybrid protection layer.
View Article and Find Full Text PDFCarbohydr Polym
March 2025
Institute of Zhejiang University-Quzhou, 99 Zheda Road, Quzhou 324000, China; National Key Laboratory of Biobased Transportation Fuel Technology, College of Biosystems Engineering and Food Science, Zhejiang University, Hangzhou 310058, China. Electronic address:
Cellulose has outstanding potential for application in energy storage batteries due to its high temperature resistance, high electrolyte affinity, renewability, and suppression of the shuttle effect, but single cellulose membranes still suffer from problems such as inhomogeneous pore distribution and unstable three-dimensional network structure. In this study, a green and sustainable regenerative cellulose (RC)/sodium alginate (SA) gel electrolyte membrane is developed by sol-gel process, the double crosslinked network scaffold centered on Zn was constructed by the synergistic hydrogen-bonding and metal ion- coordination network, the stable and uniform pore structure was also formed. The obtained RC-SA gel electrolyte membrane exhibits outstanding performance, featuring a dual crosslinked network with abundant pore structure and numerous polar groups that effectively enhance Zn transport, significantly improving battery cycling performance.
View Article and Find Full Text PDFMater Horiz
January 2025
School of Chemistry and Materials Science, University of Science and Technology of China, Hefei, 230026, P. R. China.
Hydrogel electrolytes are crucial for solving the problems of random zinc dendrite growth, hydrogen evolution reactions, and uncontrollable passivation. However, their complex fabrication processes pose challenges to achieving large-scale production with excellent mechanical properties required to withstand multiple cycles of mechanical loads while maintaining high electrochemical performance needed for the new-generation flexible zinc-ion batteries. Herein, we present a superspreading-based strategy to produce robust hydrogel electrolytes consisting of polyvinyl alcohol, sodium alginate and sodium acetate.
View Article and Find Full Text PDFNanoscale
January 2025
College of Science, China Agricultural University, Beijing, 100083, China.
Aqueous zinc-ion batteries are an appealing electrochemical energy storage solution due to their affordability and safety. Significant attention has been focused on vanadium oxide cathode materials for ZIBs, owing to their high specific capacity, unique layered or tunnel structures, and low cost. Compared to traditional methods for preparing and assembling electrode materials, direct current (DC) magnetron sputtering allows direct synthesis and uniform deposition on current collectors, offering advantages such as simplicity, mild reaction conditions, and strong film adhesion.
View Article and Find Full Text PDFEnter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!