Acetogenic bacteria play an important role in various biotechnological processes, because of their chemolithoautotrophic metabolism converting carbon dioxide with molecular hydrogen (H) as electron donor into acetate. As the main factor limiting acetogenesis is often H, insights into the H consumption kinetics of acetogens are required to assess their potential in biotechnological processes. In this study, initial H consumption rates at a range of different initial H concentrations were measured for three different acetogens. Interestingly, for all three strains, H consumption was found to follow first-order kinetics, i.e. the H consumption rate increased linearly with the dissolved H concentration, up to almost saturated H levels (600 µM). This is in contrast with Monod kinetics and low half-saturation concentrations, which have commonly been assumed for acetogens. The obtained biomass specific first-order rate coefficients (k ) were further validated by comparison with values obtained by fitting first-order kinetics on previous time-course experimental results. The latter method was also used to determine the k value of five additional acetogens strains. Biomass specific first-order rate coefficients were found to vary up to six-fold, with the highest k for Acetobacterium wieringae and the lowest for Sporomusa sphaeroides. Overall, our results demonstrate the importance of the dissolved H concentration to understand the rate of acetogenesis in biotechnological systems.
Download full-text PDF |
Source |
---|---|
http://dx.doi.org/10.1002/bit.28904 | DOI Listing |
Int J Biol Macromol
December 2024
Department of Chemical Engineering and Technology, Indian Institute of Technology (BHU), Varanasi 221005, India. Electronic address:
This study presents an eco-friendly, cost-effective approach for synthesizing highly efficient nanocatalysts with the help of organic waste. Iron nanoparticles (INPs) were synthesized from aqueous extracts of potato, potato peel, and potato leaf and were evaluated for their photocatalytic efficiency for the degradation of methylene blue dye. X-ray Diffraction (XRD) confirmed FeO nanoparticles cubic crystal structure with the smallest crystallite size (9.
View Article and Find Full Text PDFBiotechnol Bioeng
December 2024
Department of Biological and Chemical Engineering, Aarhus University, Aarhus, Denmark.
Acetogenic bacteria play an important role in various biotechnological processes, because of their chemolithoautotrophic metabolism converting carbon dioxide with molecular hydrogen (H) as electron donor into acetate. As the main factor limiting acetogenesis is often H, insights into the H consumption kinetics of acetogens are required to assess their potential in biotechnological processes. In this study, initial H consumption rates at a range of different initial H concentrations were measured for three different acetogens.
View Article and Find Full Text PDFSci Rep
December 2024
Interdisciplinary Centre for Water Research (ICWaR), Indian Institute of Science, Bangalore, 560012, India.
This study presents the synthesis of a green polymer-based nanocomposite by incorporating green CuO nanoparticles into polyaniline (PANI) for the adsorption of Pb (II) ions from contaminated water. The nanocomposite was extensively characterized using FTIR, XRD, BET, SEM-EDX, XPS, and Raman spectroscopy, both before and after Pb(II) adsorption. Optimization studies were performed to assess the effects of key parameters, including pH, adsorbent dosage, and initial ion concentration on the adsorption process.
View Article and Find Full Text PDFCrown ether is widely used in water purification because of its ring structure and good selective adsorption of specific heavy metals. However, its high cost and difficulty in recycling limit the purification of heavy metals in water. The anisotropic [2,4]-dibenzo-18-crown-6-modified bamboo pulp aerogel (DB18C6/PA) is successfully synthesized by microwave irradiation and directional freezing technology.
View Article and Find Full Text PDFEur J Pharm Sci
December 2024
Institute of Pharmaceutical Technology, Center of pharmaceutical nanotechnology, Faculty of Pharmacy, Ss. Cyril & Methodius University in Skopje, Majka Tereza 47, 1000 Skopje, R North Macedonia.
In this study 3D printed tablets (printlets) with extended release of hydrochlorothiazide (HHT) as model active ingredient were designed and developed. Four formulations, F0.1, F1, F0.
View Article and Find Full Text PDFEnter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!