The process of machining the modern engineering materials, such as nickel-based superalloys, still requires improvement. This paper focuses on comparing the turning process of Inconel 625 superalloy using three types of cutting inserts to obtain the finishing process. The influence of cutting data, such as cutting speed, feed rate, and cutting depth, on the machined surface quality, surface quality were selected. The novelty of the research, described in the article, is the optimization of the machining of Inconel 625 by using the stepwise selection of parameters. The most important issue is that the stepwise method can be used in industry, where increasingly new nickel-chromium materials with more specific strength properties are used for parts.
The process of machining the modern engineering materials, such as nickel-based superalloys, still requires improvement. This paper focuses on comparing the turning process of Inconel 625 superalloy using three types of cutting inserts to obtain the finishing process. The influence of cutting data, such as cutting speed, feed rate, and cutting depth, on the machined surface quality, surface quality were selected.
Water-cooled wall tubes are susceptible to high-temperature corrosion during service. Applying high-performance coatings via laser cladding on the tube surfaces can significantly enhance corrosion resistance and extend the service life of the tubes, providing substantial economic advantages. This paper prepared YO/IN625 composite coating by means of high-speed laser cladding.
Accurate measurement of the infrared spectral emissivity of nickel-based alloys is significant for applications in aerospace. The low thermal conductivity of these alloys limits the accuracy of direct emissivity measurement, especially during the oxidation process. To improve measurement accuracy, a surface temperature correction method based on two thermocouples was proposed to eliminate the effect of thermal conductivity changes on emissivity measurement.
This paper deals with the development and characterization of an Inconel 625 (IN625) reinforced with 2 wt.% of sub-micrometrical TiC particles produced by the laser powder bed fusion (LPBF) process. IN625 and IN625 2 wt.
Directed energy deposition (DED) is a form of additive manufacturing available across a variety of laser spot diameter values, often referred to as spot sizes. However, there is no method to easily transfer process parameters across discrete spot sizes, leading to DED process parameters that are equipment specific and not widely applicable. In this study, a strategy is proposed and investigated for five spot sizes that keep the areal energy density constant while varying power, feed rate, and powder flow during the deposition of 316L stainless steel.
