Novel Treatment of 3D-Printed Short-Carbon-Fiber-Reinforced Polyamide (3D-SCFRPA66) Using Homogeneous Low-Potential Electron Beam Irradiation (HLEBI) and Ductility Enhancement.

In short-carbon-fiber-reinforced polyamide 66 articles shaped by 3D printing (3D-SCFRPA66), the interfaces between printed layers are often susceptible to damage, and the composite is excessively brittle. Therefore, a novel treatment for 3D-printed short-carbon-fiber-reinforced polyamide (3D-SCFRPA66) using homogeneous low-potential electron beam irradiation (HLEBI) to enhance tensile properties was investigated. In 3D-SCFRPA66 samples, ductility was measured based on the following parameters: strain at tensile strength (corresponding to homogeneous deformation) () and resistance energy to homogeneous deformation, a measure of toughness (), which were both substantially increased. An HLEBI dose of 43.2 kGy at an acceleration potential of 210 kV for the finished 3D-SCFRPA66 samples increased the and values from 0.031 and 1.20 MPa·m for the untreated samples to 0.270 and 6.05 MPa·m for the treated samples, increases of 771% and 504%, respectively. Higher HLEBI doses of 86, 129, or 215 kGy also increased the and values to lesser degrees. Electron spin resonance (ESR) data in the literature show that HLEBI creates dangling bonds in Nylon 6. Since PA66 and Nylon 6 are constructed of C, N, and O and have similar molecular structures, HLEBI apparently severs the (-C-N-) bonds in the backbone of PA66, which have the lowest bond-dissociation energy (BDE) of ~326 to 335 kJ mol. This shortens the PA66 chains for higher ductility. In addition, for Nylon 6, X-ray photoelectron spectroscopy (XPS) data in the literature show that HLEBI reduces the N peak while increasing the C peak, indicating the occurrence of shortening chains via dangling bond formation accompanied by increases in crosslinking with carbon bonds. However, caution is advised, since HLEBI was found to decrease the tensile strength () and initial elasticity ([d/d]) of 3D-SCFRPA66. This tradeoff can possibly allow the HLEBI dose to be adjusted for the desired ductility and strength while minimizing energy consumption.