Investigating the effects of make-up water dilution and oil presence on polymer retention in carbonate reservoirs.

The application of polymer flooding is challenging in harsh temperature and salinity conditions in Middle-Eastern carbonate reservoirs, as they can deteriorate the commonly used polymers such as Hydrolyzed Polyacrylamide (HPAM). One solution to this issue is the use of newly developed Acrylamido-Tertiary-Butyl Sulfonate (ATBS) based polymers, which can endure adverse temperature and salinity conditions. However, they also tend to adsorb onto carbonate rocks with positive surface charge. This study aims to tackle the problem of high polymer retention by employing low-salinity polymer flooding. For that coreflooding experiments were conducted on an ATBS-based polymer in salinities ranging from 400 to 167,000 ppm using fully water-saturated cores and cores at residual oil saturation (S). The single-phase retention experiments determined polymer retention values of around 25 µg/g-rock when using diluted brines, which is about half of the retention values (47-56 µg/g-rock) observed with high salinity seawater (43,000 ppm) and formation water (167,000 ppm). Furthermore, the retention of the ATBS-based polymer was further reduced by 50% in the presence of oil compared to the experiments conducted in the absence of oil. The results demonstrated that an optimal salinity threshold of 10,000 ppm and lower yields significant improvements in the efficiency of polymer flooding.