The aqueous solution cast method was used to create the biodegradable polymer nanocomposite (PNC) films from a blend of poly (vinyl alcohol) PVA and poly (vinyl pyrrolidone) PVP (70/30 wt %) and FeO nanoparticles (NPs). These PNC films were characterized using X-ray diffraction, scanning electron microscopy SEM, Fourier transform infrared spectroscopy FTIR, and ultraviolet-visible spectroscopy. XRD and FTIR results indicate that Fe NPs interact with the host polymer. Optical, electrical, mechanical, and radiation shielding measurements were performed on the PNC films. From the optical measurements, the indirect optical band gap drops from 4.86 eV for the pure blend to 4.26 eV at the greatest NPs concentration. Optical limiting characterization shows that the output power of He-Ne and solid-state green laser beams is reduced from 22.98 to 3.6 mW and 6.59 to 1.4 mW, respectively, when the FeO NPs content in the blend matrix is increased to 6 wt %. The NGCal software was utilized to calculate nuclear radiation shielding properties. The findings demonstrated that when the concentration of FeO rose, the PNC films half-value layer and mean free path decreased. Mechanical measurements demonstrate that increasing the FeO content significantly improves nanocomposite films' yield and tensile strength. Tensile strength is measured at 27.03 MPa for the composite film containing 6 wt % FeO, which is significantly higher than the 8.66 MPa of the pure (PVA-PVP) film. Compared to the other samples under examination, the 6 wt % FeO sample yielded the best results (based on the analyzed optical, electrical, mechanical, and radiation shielding properties).

Download full-text PDF

Source
http://www.ncbi.nlm.nih.gov/pmc/articles/PMC11551174PMC
http://dx.doi.org/10.1038/s41598-024-76397-8DOI Listing

Publication Analysis

Top Keywords

pnc films
16
radiation shielding
12
poly vinyl
8
optical electrical
8
electrical mechanical
8
mechanical radiation
8
shielding properties
8
tensile strength
8
optical
6
feo
6

Similar Publications

Marangoni-Induced Honeycomb Structures in Spin-Coated Polymer Nanocomposite Films.

J Phys Chem B

December 2024

Department of Materials Science and Engineering, University of Pennsylvania, Philadelphia, Pennsylvania 19104, United States.

This study investigates Marangoni effect-induced structural changes in spin-coated polymer nanocomposite (PNC) films composed of poly(methyl methacrylate)-grafted silica nanoparticles (NPs) and poly(styrene--acrylonitrile). Films cast from methyl isobutyl ketone (MIBK) solvent exhibit distinct hexagonal honeycomb cells with thickness gradients driven by surface tension variations. Atomic force microscopy reveals protruded ridges and junctions at cell intersections, where NP concentration is the highest.

View Article and Find Full Text PDF

The aqueous solution cast method was used to create the biodegradable polymer nanocomposite (PNC) films from a blend of poly (vinyl alcohol) PVA and poly (vinyl pyrrolidone) PVP (70/30 wt %) and FeO nanoparticles (NPs). These PNC films were characterized using X-ray diffraction, scanning electron microscopy SEM, Fourier transform infrared spectroscopy FTIR, and ultraviolet-visible spectroscopy. XRD and FTIR results indicate that Fe NPs interact with the host polymer.

View Article and Find Full Text PDF

Lead halide perovskite nanocrystals (PNCs) have demonstrated great potential in emerging display technologies. However, the practical application of PNCs is hindered by the inherent instability of their ionic surface. Here, we proposed a surface modification approach to enhance the stability of CsPbBr PNCs by postsynthetic treatment with aluminum phenylbutyrate (Al(PA)).

View Article and Find Full Text PDF

Production of PLA/cellulose derived from pineapple leaves as bio-degradable mulch film.

Int J Biol Macromol

June 2024

National Center of Excellence for Petroleum, Petrochemicals and Advance Material, Department of Chemical Engineering, Faculty of Engineering, Kasetsart University, Chatuchak, Bangkok 10900, Thailand; Research Network of NANOTEC - KU on NanoCatalysts and NanoMaterials for Sustainable Energy and Environment, Kasetsart University, Bangkok 10900, Thailand. Electronic address:

Mulch films were fabricated from polylactic acid (PLA) with cellulose nanocrystals (PNC) extracted from pineapple leaves. The PNC was modified by incorporating 4 wt% triethoxyvinylsilane (TEVS), designated as 4PNC, to enhance its interaction with PLA. The films incorporated varying concentrations of PNC (1, 2, 4, and 8 wt%).

View Article and Find Full Text PDF

Sensitive and Low-Noise Perovskite Nanocrystal-Organic Bulk Heterostructure X-ray Detectors Enabled by Sodium Bromide-Assisted In Situ Reparation.

ACS Appl Mater Interfaces

May 2024

State Key Laboratory of Silicon and Advanced Semiconductor Materials and School of Materials Science and Engineering, Zhejiang University, Hangzhou 310027, P. R. China.

Perovskite nanocrystals (PNCs) offer unique advantages in large-area and thick-film deposition for X-ray detection applications due to the decoupling of the crystallization of perovskite from film formation, as well as their low-temperature and scalable deposition methods. However, the partial detachment of long-chain ligands in PNCs during the purification process would lead to the exposure of surface defects, making it challenging to ensure efficient charge carrier extraction and stable X-ray detection. In this study, we propose a beneficial strategy that involves the in situ reparation of these exposed defects with sodium bromide (NaBr) during the purification process to construct CsPbBr PNC-organic bulk heterostructure X-ray detectors.

View Article and Find Full Text PDF

Want AI Summaries of new PubMed Abstracts delivered to your In-box?

Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!