This study presents the development of highly efficient Surface-Enhanced Raman Scattering (SERS) substrates through femtosecond (fs) laser processing of crystalline silicon (Si), resulting in mountain-like microstructures. These microstructures, when decorated with gold nanoparticles (Au NPs), exhibit remarkable SERS performance due to the creation of concentrated hotspots. The enhanced Raman signals originate from the excitation of localized surface plasmon resonance (LSPR) of the Au NPs and the multi-scale rough morphology of the Si substrates. Finite-element method simulations confirm the electromagnetic field enhancement in narrow gaps, supporting the experimental observations. The fabricated substrates show high uniformity, oxidation resistance, long-term stability, and exceptional reproducibility, making them ideal for molecular detection, especially in food safety applications. A remarkable enhancement factor (EF) of 10 is attained in the detection of Malachite Green (MG), boasting a limit of detection (LoD) as low as 10 M. This underscores the immense potential of this technique for achieving highly sensitive and dependable SERS-based sensing capabilities.
Download full-text PDF |
Source |
|---|---|
| http://www.ncbi.nlm.nih.gov/pmc/articles/PMC11547577 | PMC |
| http://dx.doi.org/10.3390/molecules29215053 | DOI Listing |
Publication Analysis
Top Keywords
Similar Publications
Insights Into the Local Heating Effects in Triple-Cation Mixed-Halide Perovskite Cells: Charge Dynamics, Coherent Phonons, Anion Segregation.
Small
January 2025
Faculty of Physics and Astronomy, Adam Mickiewicz University, Poznan, 61-614, Poland.
The behavior of triple-cation mixed halide perovskite solar cells (PSCs) under ultrashort laser pulse irradiation at varying fluences is investigated, with a focus on local heating effects observed in femtosecond transient absorption (TA) studies. The carrier cooling time constant is found to increase from 230 fs at 2 µJ cm⁻ to 1.3 ps at 2 mJ cm⁻ while the charge population decay accelerates from tens of nanoseconds to the picosecond range within the same fluence range.
View Article and Find Full Text PDFConvergent-beam attosecond x-ray crystallography.
Struct Dyn
January 2025
Center for Free-Electron Laser Science CFEL, Deutsches Elektronen-Synchrotron DESY, Notkestr. 85, 22607 Hamburg, Germany.
Sub-ångström spatial resolution of electron density coupled with sub-femtosecond to few-femtosecond temporal resolution is required to directly observe the dynamics of the electronic structure of a molecule after photoinitiation or some other ultrafast perturbation, such as by soft X-rays. Meeting this challenge, pushing the field of quantum crystallography to attosecond timescales, would bring insights into how the electronic and nuclear degrees of freedom couple, enable the study of quantum coherences involved in molecular dynamics, and ultimately enable these dynamics to be controlled. Here, we propose to reach this realm by employing convergent-beam x-ray crystallography with high-power attosecond pulses from a hard-x-ray free-electron laser.
View Article and Find Full Text PDFWe report lasing action in a femtosecond-laser-inscribed waveguide in thulium-doped barium-gallium-germanium oxide (BGG) glass. A laser cavity was assembled with this waveguide that provided a single-mode output of 62 mW when pumped at 1.6 µm.
View Article and Find Full Text PDFIn this Letter, we report an ultraflat high-power supercontinuum (SC) based on a low-loss short-length fluorotellurite fiber. A novel high-peak power dual-Raman soliton femtosecond laser is used as a pump source, which effectively extends the mid-infrared SC spectral range and enhances the flatness of the SC. Finally, we obtained a 10.
View Article and Find Full Text PDFThe emission of N lasing at 391 nm from 800 nm femtosecond laser filament in air at 1 atm presents significant challenges due to the quenching effect induced by oxygen molecules. We introduce a simple technique for the 391 nm N lasing emission induced by a corona electric field-assisted femtosecond filament in air. This technique greatly addresses the challenge of exciting a 391 nm lasing from 800 nm femtosecond laser filament in air at 1 atm.
View Article and Find Full Text PDFWant AI Summaries of new PubMed Abstracts delivered to your In-box?
Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!