Carbon-based electrocatalytic dual-membrane system bolsters singlet oxygen production for ultrafast water decontamination.

J Hazard Mater

State Key Joint Laboratory of Environment Simulation and Pollution Control, School of Environment, Tsinghua University, Beijing 100084, China. Electronic address:

Published: October 2023

Reactive electrochemical membranes (REMs) are promising technologies in treating pharmaceuticals and personal care products (PPCPs) in water. Herein, a novel carbon-based electrocatalytic dual-membrane system was designed to exploit the whole redox process of electrodes, in which the membrane cathode and anode were formed by carbon fibers doped with Fe and metal organic frameworks derived SnO, respectively. Propranolol (PRO) was used as a representative of PPCPs. The system bolstered singlet oxygen (O) production by the synergy of two REM electrodes, further improving the removal rate constant of PRO compared with single-electrode-dominant modes. 97.5 ± 1.7% of PRO removal was achieved in a single-pass electro-filtration at a residence time of ∼2.9 s. The generation of O and its reaction with pollutants were systematically and thoroughly explored via experiments coupled with theoretical calculation. The toxicity of the decomposition products was predicted to be reduced compared with PRO. These findings suggested that the carbon-based electrocatalytic dual-membrane system could effectively promote O production for ultrafast catalytic oxidation of PRO, providing a cost-effective solution for the development of an efficient and stable technology for PPCPs removal.

Download full-text PDF

Source
http://dx.doi.org/10.1016/j.jhazmat.2023.132787DOI Listing

Publication Analysis

Top Keywords

carbon-based electrocatalytic
12
electrocatalytic dual-membrane
12
dual-membrane system
12
singlet oxygen
8
oxygen production
8
production ultrafast
8
pro
5
system
4
system bolsters
4
bolsters singlet
4

Similar Publications

Copper-cobalt diatomic bifunctional oxygen electrocatalysts based on three-dimensional porous nitrogen-doped carbon frameworks for high-performance zinc-air batteries.

J Colloid Interface Sci

December 2024

State Key Laboratory of Reliability and Intelligence of Electrical Equipment, Hebei University of Technology, Tianjin 300401, PR China; Engineering Research Center of Ministry of Education for Intelligent Rehabilitation Device and Detection Technology, Hebei University of Technology, Tianjin 300401, PR China; Hebei Key Laboratory of Smart Sensing and Human-Robot Interaction, Hebei University of Technology, Tianjin 300401, PR China; School of Mechanical Engineering, Hebei University of Technology, 5340 Xiping Road, Beichen District, Tianjin 300401, PR China. Electronic address:

Transition-metal-loaded carbon-based electrocatalysts are promising alternatives to conventional precious metal electrocatalysts for the oxygen reduction reaction (ORR) and oxygen evolution reaction (OER) in high-performance zinc-air batteries. However, efficiently doping transition-metal single atoms onto carbon-based frameworks is a significant challenge. Herein, an improved template-sacrificing method combining a two-step carbonization process is proposed to fabricate Cu/Co diatomic sites coanchored on a three-dimensional nitrogen-doped carbon-based framework.

View Article and Find Full Text PDF

Enhanced electro-catalysis for methanol oxidation reaction performance by edge defects of ordered mesoporous carbon.

J Colloid Interface Sci

December 2024

School of Petrochemical Engineering, Lanzhou University of Technology, Lanzhou 730050, PR China; Key Laboratory of Low Carbon Energy and Chemical Engineering of Gansu Province, Lanzhou 730050, PR China.

Heteroatom-doped carbon materials are widely used to improve the electrocatalytic oxidation of methanol; however, the underlying mechanisms driving this enhancement remain poorly understood. A major challenge lies in developing non-doped carbon supports with tunable intrinsic defect types tailored for metal-based catalysts. In this study, we synthesize a series of ordered mesoporous carbon (OMC) supports with adjustable edge defect densities by varying roasting temperatures and employing a zinc (Zn) evaporation strategy to systematically investigate the impact of edge defects on methanol oxidation reaction (MOR) performance.

View Article and Find Full Text PDF

Organogel Polymer Electrocatalysts for Two-Electron Oxygen Reduction.

Small

December 2024

State Key Laboratory of Bio-fibers and Eco-textiles, Collaborative Innovation Center of Shandong Marine Biobased Fibers and Ecological Textiles, Institute of Marine Biobased Materials, College of Materials Science and Engineering, Qingdao University, Qingdao, 266071, P. R. China.

Polymer gels, renowned for unparalleled chemical stability and self-sustaining properties, have garnered significant attention in electrocatalysis. Notably, organic polymer gels that exhibit temperature sensitivity and incorporate suitable polar nonvolatile liquids, enhance electronic conductivity, and impart distinct morphological features, but remain largely unexplored as electrocatalysts for oxygen reduction reaction (ORR). To address this issue, an innovative strategy is proposed for synergistic modulation of the rigidity of mainchain molecular skeleton and length of alkyl sidechains, enabling the development of organogel polymers with a sol-gel temperature-sensitive phase transition that promises high selectivity and enhanced activity in electrocatalytic processes.

View Article and Find Full Text PDF

Silver-Catalyzed Aqueous Electrochemical Valorization of Soda Lignin into Aliphatics and Phenolics.

Polymers (Basel)

November 2024

Faculty of Mathematics and Natural Sciences, Chair of Inorganic Chemistry, University of Wuppertal, Gaussstraße 20, 42119 Wuppertal, Germany.

Transitioning from crude oil to renewable sources of carbon-based chemicals is critical for advancing sustainable development. Lignin, a wood-derived biomacromolecule, holds great potential as a renewable feedstock, but efficient depolymerization and dearomatization methods are required to fully unlock its potential. In this investigation, we present a silver-catalyzed aqueous electrocatalytic method for the selective depolymerization and partial dearomatization of soda lignin under mild, ambient conditions.

View Article and Find Full Text PDF
Article Synopsis
  • * Biochar (BC) is a promising, low-cost material for water treatment, known for its effective adsorption and catalytic properties, but its performance can be limited without modifications.
  • * This review highlights various applications of modified BC in different water treatment systems, addresses the current limitations of research primarily conducted in labs, and explores potential future advancements in the field.
View Article and Find Full Text PDF

Want AI Summaries of new PubMed Abstracts delivered to your In-box?

Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!