AI Article Synopsis

  • Automated radio telemetry systems (ARTS) can significantly enhance our understanding of animal movements by offering continuous location tracking, but localization errors are often high due to complex natural environments.
  • A study in the Colombian high Andes tested different localization methods and identified factors affecting accuracy, revealing localization error ranged from 0.4 to 1929 meters depending on the method and environmental conditions.
  • Results highlighted that improving signal strength and data smoothing could enhance accuracy, which may allow researchers to better analyze the movements and behaviors of small animals, such as high-altitude hummingbirds.

Article Abstract

Automated radio telemetry systems (ARTS) have the potential to revolutionise our understanding of animal movement by providing a near-continuous record of individual locations in the wild. However, localisation errors in ARTS data can be very high, especially in natural landscapes with complex vegetation structure and topography. This curtails the research questions that may be addressed with this technology. We set up an ARTS grid in a valley with heterogeneous vegetation cover in the Colombian high Andes and applied an analytical pipeline to test the effectiveness of localisation methods. We performed calibration trials to simulate animal movement in high- or low-flight, or walking on the ground, and compared workflows with varying decisions related to signal cleaning, selection, smoothing, and interpretation, along with four multilateration approaches. We also quantified the influence of spatial features on the system's accuracy. Results showed large variation in localisation error, ranging between 0.4-43.4 m and 474-1929 m, depending on the localisation method used. We found that the selection of higher radio signal strengths and data smoothing based on the temporal autocorrelation are useful tools to improve accuracy. Moreover, terrain ruggedness, height of movement, vegetation type, and the location of animals inside or outside the grid area influence localisation error. In the case of our study system, thousands of location points were successfully estimated for two high-altitude hummingbird species that previously lacked movement data. Our case study on hummingbirds suggests ARTS grids can be used to estimate small animals' home ranges, associations with vegetation types, and seasonality in occurrence. We present a comparative localisation pipeline, highlighting the variety of possible decisions while processing radio signal data. Overall, this study provides guidance to improve the resolution of location estimates, broadening the application of this tracking technology in the study of the spatial ecology of wild populations.

Download full-text PDF

Source
http://www.ncbi.nlm.nih.gov/pmc/articles/PMC11467373PMC
http://dx.doi.org/10.1002/ece3.70405DOI Listing

Publication Analysis

Top Keywords

automated radio
8
radio telemetry
8
telemetry systems
8
animal movement
8
localisation error
8
radio signal
8
case study
8
localisation
7
tracking small
4
small animals
4

Similar Publications

The widespread use of wireless networks to transfer an enormous amount of sensitive information has caused a plethora of vulnerabilities and privacy issues. The management frames, particularly authentication and association frames, are vulnerable to cyberattacks and it is a significant concern. Existing research in Wi-Fi attack detection focused on obtaining high detection accuracy while neglecting modern traffic and attack scenarios such as key reinstallation or unauthorized decryption attacks.

View Article and Find Full Text PDF

Congenital radioulnar synostosis (CRUS) presents a complex forearm deformity, requiring precise osteotomy planning for anatomical restoration. This study proposes an automatic osteotomy preoperative planning method for forearms with CRUS. Proximal forearm bones are first aligned with the template forearm and then a dual dimensional optimization (DDO) strategy is used to optimize the spatial transformation parameters of the distal fragment.

View Article and Find Full Text PDF

This paper presents an experimentally based study aimed at assessing the viability of employing a commercial energy harvester to develop a self-powered end-stroke and speed sensor for pneumatic cylinders. An energy-harvesting device was integrated into a cylinder end-cap to recover energy from the piston impact at the end of the stroke. The recovered energy powers a radio transmitter that communicates the reach of the end-stroke.

View Article and Find Full Text PDF

Developing a digital management system for museum collections using RFID and enhanced GIS technology.

PeerJ Comput Sci

November 2024

Department of Space and Lifestyle Design, Graduate School of Techno Design, Kookmin University, Seoul, Republic of South Korea.

Article Synopsis
  • The integration of RFID technology with deep learning has transformed IoT, particularly benefiting museums in managing their collections more effectively.
  • Traditional tracking methods are insufficient for providing real-time updates and maintaining optimal conditions, putting pressure on museum staff responsible for extensive collections.
  • This study introduces an advanced electronic management system that combines RFID and GIS, using an enhanced LANDMARC algorithm to improve the accuracy of collection tracking and environmental monitoring, while also optimizing staff management and inspection processes.
View Article and Find Full Text PDF

Modern photonic devices demand low-cost, scalable methods for creating periodic patterns over diverse surfaces including nonplanar and tipped ones, the examples of which can be readily found in fiber optics. Laser-induced periodic surface structures (LIPSS) offer an attractive route for fabricating such patterns in a single-step straightforward procedure, where the temporal and spatial locality of the self-interference effects ensure robustness against variations of the laser processing parameters. In this work, we show the LIPSS-assisted oxidation of thin titanium films by near-IR femtosecond laser pulses as a promising technology for the production of regular gratings consisting of rutile ridges.

View Article and Find Full Text PDF

Want AI Summaries of new PubMed Abstracts delivered to your In-box?

Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!