Injecting HO into aquifers is a widely used chemical oxidation (ISCO) technology for groundwater remediation. Dissolved silicate was reported to decrease the reactivity of iron (Ⅲ)-bearing minerals toward HO. In this study, the effect of naturally occurring levels of dissolved silicate (≤1 mM) on the catalyzing hydrogen peroxide (CHP) with Fe(II) minerals is revaluated, and new observations that contradict with previous studies are reported. Specifically, dissolved silicate enhanced the CHP process by Fe(II) minerals. In the presence of Fe(II) minerals, siderite and ferrous oxide (FeO), which had a stronger dissolution tendency than Fe(III) minerals, dissolved silicate could prevent the dissolved iron species from precipitation through a coordinating effect, therefore reinforcing the homogeneous CHP process and the degradation of 2,4-dichlorophenol. The solution pH decreased due to the generation of degradation intermediates, and the solution acidification in turn promoted further dissolution of Fe(II) minerals. FeO particles exhibited the strongest silicate adsorption among the minerals, therefore a higher initial silicate concentration of 1 mM was needed to observe the enhancing effect. This study redefines the role of dissolved silicate on CHP process and provides clues to the design of efficient HO-based ISCO system for the remediation of groundwater.
Download full-text PDF |
Source |
|---|---|
| http://www.ncbi.nlm.nih.gov/pmc/articles/PMC11452147 | PMC |
| http://dx.doi.org/10.1021/acsestwater.2c00557 | DOI Listing |
Publication Analysis
Top Keywords
Similar Publications
Experimental Investigation of the Effect of Microstructure on Coalbed Methane Adsorption Characteristics Affected by Chemical Solvents.
Langmuir
December 2024
School of Mechanical and Mining Engineering, University of Queensland, Brisbane 4072, Australia.
Coalbed methane (CBM) reservoir modification based on chemical solvent treatment could change the coal microstructure, which further affects the adsorption capacity and flow characteristics of this clean energy. Coal samples were extracted by tetrahydrofuran (THF), carbon disulfide (CS), and hydrochloric acid (HCl). Low-pressure nitrogen adsorption, carbon dioxide adsorption, Fourier transform infrared spectroscopy, and methane isothermal adsorption test were adopted.
View Article and Find Full Text PDFResource utilization of waste solar photovoltaic panels for preparation of microporous silicon nanoparticles.
Waste Manag
December 2024
College of Environmental Science and Engineering and Key Laboratory of Environmental Biology and Pollution Control (Ministry of Education), Hunan University, Changsha 410082, PR China.
With the exponential growth of global photovoltaic (PV) installed capacity, the quantity of discarded PV modules continues to rise. This study innovatively explored the sustainable recovery and utilization of raw materials from discarded solar panels, focusing on the transformation of recycled silicon into microporous silica nanoparticles (MSN). Low toxic organic solvent ethyl acetate (EA) was for the first time utilized to reduce the viscosity of ethylene-vinyl acetate (EVA) and facilitated its removal.
View Article and Find Full Text PDFModification of iron-containing silicate tailings with oxalic acid to develop a long-efficacy utilization peroxymonosulfate-based system for the efficient decomplexation and removal of Cr(III)-ethylenediamine tetraacetic acid.
J Colloid Interface Sci
December 2024
Department of Environmental Science and Engineering, College of Environment and Resources, Xiangtan University, Xiangtan 411105, China.
Ferrous oxalate (FeCO)-based composite has been recognized as an eminent catalyst for Cr(III)-ethylenediamine tetraacetic acid (Cr(III)-EDTA) decomplexation. However, their practical application has been limited by low cycling capacity and an ambiguous mechanism. In this research, a composite catalyst consisting of biotite loaded with nano FeCO (CFS90) was prepared directly from iron-containing silicate tailing.
View Article and Find Full Text PDFNanodots of Transition Metal Sulfides, Carbonates, and Oxides Obtained Through Spontaneous Co-Precipitation with Silica.
Nanomaterials (Basel)
December 2024
Material Science, BASF SE, RGA/BM-B007, Carl-Bosch-Str. 38, D-67056 Ludwigshafen, Germany.
The controlled formation and stabilization of nanoparticles is of fundamental relevance for materials science and key to many modern technologies. Common synthetic strategies to arrest growth at small sizes and prevent undesired particle agglomeration often rely on the use of organic additives and require non-aqueous media and/or high temperatures, all of which appear critical with respect to production costs, safety, and sustainability. In the present work, we demonstrate a simple one-pot process in water under ambient conditions that can produce particles of various transition metal carbonates and sulfides with sizes of only a few nanometers embedded in a silica shell, similar to particles derived from more elaborate synthesis routes, like the sol-gel process.
View Article and Find Full Text PDFGlobal Groundwater Carbon Mass Flux and the Myth of Atmospheric Weathering.
Ground Water
January 2025
Seafloor Science Branch, US Naval Research Laboratory, NRL Code 7432, Stennis Space Center, Hancock County, MS, 39529.
Our recent steady-state mass-balance modeling suggests that most global carbonic-acid weathering of silicate rocks occurs in the vadose zone of aquifer systems not on the surface by atmospheric CO. That is, the weathering solute flux is nearly equal to the total global continental riverine carbon flux, signifying little atmospheric weathering by carbonic acid. This finding challenges previous carbon models that utilize silicate weathering as a control of atmospheric CO levels.
View Article and Find Full Text PDFWant AI Summaries of new PubMed Abstracts delivered to your In-box?
Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!