Scaling law for a buckled elastic filament in a shear flow.

Phys Rev E

Institute of Fundamental Technological Research, Polish Academy of Sciences, Pawińskiego 5B, 02-106 Warsaw, Poland.

Published: August 2024

We analyze the three-dimensional (3D) buckling of an elastic filament in a shear flow of a viscous fluid at low Reynolds number and high Péclet number. We apply the Euler-Bernoulli beam (elastica) theoretical model. We show the universal character of the full 3D spectral problem for a small perturbation of a thin filament from a straight position of arbitrary orientation. We use the eigenvalues and eigenfunctions for the linearized elastica equation in the shear plane, found earlier by Liu et al. [Phys. Rev. Fluids 9, 014101 (2024)2469-990X10.1103/PhysRevFluids.9.014101] with the Chebyshev spectral collocation method, to solve the full 3D eigenproblem. We provide a simple analytic approximation of the eigenfunctions, represented as Gaussian wave packets. As the main result of the paper, we derive the square-root dependence of the eigenfunction wave number on the parameter χ[over ̃]=-ηsin2ϕsin^{2}θ, where η is the elastoviscous number and the filament orientation is determined by the zenith angle θ with respect to the vorticity direction and the azimuthal angle ϕ relative to the flow direction. We also compare the eigenfunctions with shapes of slightly buckled elastic filaments with a non-negligible thickness with the same Young's modulus, using the bead model and performing numerical simulations with the precise hydromultipole numerical codes.

Download full-text PDF

Source
http://dx.doi.org/10.1103/PhysRevE.110.025104DOI Listing

Publication Analysis

Top Keywords

buckled elastic
8
elastic filament
8
filament shear
8
shear flow
8
scaling law
4
law buckled
4
filament
4
flow analyze
4
analyze three-dimensional
4
three-dimensional buckling
4

Similar Publications

Ultra-Stiff yet Super-Elastic Graphene Aerogels by Topological Cellular Hierarchy.

Adv Mater

December 2024

MOE Key Laboratory of Macromolecular Synthesis and Functionalization, International Research Center for X Polymers, Department of Polymer Science and Engineering, Zhejiang University, 38 Zheda Road, Hangzhou, 310027, China.

Lightweight cellular materials with high stiffness and excellent recoverability are critically important in structural engineering applications, but the intrinsic conflict between these two properties presents a significant challenge. Here, a topological cellular hierarchy is presented, designed to fabricate ultra-stiff (>10 MPa modulus) yet super-elastic (>90% recoverable strain) graphene aerogels. This topological cellular hierarchy, composed of massive corrugated pores and nanowalls, is designed to carry high loads through predominantly reversible buckling within the honeycomb framework.

View Article and Find Full Text PDF

Understanding he impact of dry-wet and freeze-thaw cycles on the mechanical properties of unloaded damaged rock masses in reservoir bank slopes is crucial for revealing the deformation and failure mechanisms in artificially excavated slope rock masses within fluctuation zones. To address, the study focuses on unloaded damaged samples subjected to excavation disturbances, conducting various cycles of dry-wet and freeze-thaw treatment along with uniaxial and triaxial re-loading tests. A damage statistical constitutive model was established based on the experimental results and validated using numerical simulation methods.

View Article and Find Full Text PDF

Buckling instabilities driven by tissue growth underpin key developmental events such as the folding of the brain. Tissue growth is disordered due to cell-to-cell variability, but the effects of this variability on buckling are unknown. Here, we analyze what is perhaps the simplest setup of this problem: the buckling of an elastic rod with fixed ends driven by spatially varying, yet highly symmetric growth.

View Article and Find Full Text PDF

Dynamically Tunable Chiroptical Activities of Flexible Chiral Plasmonic Film via Surface Buckling.

Small

December 2024

School of Physical Science and Technology, ShanghaiTech University, 393 Huaxia Middle Rd. Pudong, Shanghai, 201210, P. R. China.

Plasmonic nanoparticle-based chiral materials have attracted great interest due to their strong light-matter interaction and tunable resonance frequency. However, challenges remain in dynamically modulating the chiroptical activities while maintain strong signals. Here, chiral assemblies of gold nanospheres(AuNSs) are achieved via mechanical-induced surface buckling of elastic materials, in which linear chain assemblies of AuNSs transform into to 3D "S-liked" morphology along with the formation of unidirectional wrinkles during buckling.

View Article and Find Full Text PDF

Carbon atom has different bonding modes, which provides the possibility for the existence of multilayer carbon allotropes. Among these bonding modes, the sp hybrid bonding mode often causes atoms to be noncoplanar. This provides the possibility for the emergence of two-dimensional (2D) multilayer materials.

View Article and Find Full Text PDF

Want AI Summaries of new PubMed Abstracts delivered to your In-box?

Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!