Data are limited on how cow hooves develop early in life and how this will affect susceptibility to lameness and claw disorders later in life. The aim of this study was to characterize individual claw growth and wear in dairy calves. A total of 90 male Holstein calves <1 wk old were enrolled in this completely randomized design experiment and monitored until wk 20 of age. Evaluation of hoof development was conducted by visual inspection, and individual claw measurements were taken with a graduated ruler. Claws were numbered from 1 to 8 to maintain consistent data collection, where front claws were numbered 1 to 4 (left to right) and rear claws were 5 to 8. Lateral claws were numbered 1, 4, 5, and 8, and medial claws were 2, 3, 6, and 7. Measurements included length from the coronary band to the end of the hoof wall and from the coronary band to the groove line, resulting in the variables claw length (CL) and groove length (GL), respectively. Hoof development was evaluated at wk 0, 5, 10, 15, and 20. All evaluations were performed by the same person throughout the study to eliminate variation between observers. Hoof growth and wear were derived from CL and GL measurements and analyzed from wk 0 to 20. Claw length at wk 0 was different across claw positions, and maximal claw length was observed in claws in positions 6 and 7 (i.e., rear medial claws). A similar growth pattern in claw length was observed when evaluated from wk 0 to 20, where a greater claw length was observed in claws 6 and 7 compared with other claws. In contrast to claw length, claw wear at wk 20 was lower in claws 6 and 7 compared with other claws. Compared with rear claws, front claws had greater wear at wk 20, and compared with medial claws, lateral claws had greater wear at wk 20. Factors associated with claw length differences at wk 0 remain to be elucidated, but the fact that this uneven claw length difference was maintained 20 wk after birth is puzzling. The complementary claw length to wear described greater wear in claws 1 and 4 (i.e., front lateral) in young calves, which is translated into lower claw length in the same claws by wk 20 after birth. Future research in postnatal hoof growth should strive to understand the potential biological significance of this effect on lameness resistance and longevity of dairy cows.

Download full-text PDF

Source
http://www.ncbi.nlm.nih.gov/pmc/articles/PMC11366044PMC
http://dx.doi.org/10.3168/jdsc.2023-0408DOI Listing

Publication Analysis

Top Keywords

growth wear
8
dairy calves
8
wear characteristics
4
characteristics individual
4
individual claws
4
claws young
4
young dairy
4
calves data
4
data limited
4
limited cow
4

Similar Publications

CAM/CAD composites are widely used as dental restoration materials due to their resistivity to wear. The purpose of this study was to determine the effect of human gingival fibroblast cells on three different computer-aided design/computer-aided manufacturing (CAD/CAM) hybrid materials with resin-based composites (RBC) and to assess their stability following cell growth. The CAM/CAD dental materials were investigated in different conditions as follows: (i) cells (human gingival fibroblasts, HFIB-Gs) incubated over the material for each sample, denoted as A; (ii) reference, the raw material, denoted as B; and (iii) materials incubated in DMEM medium, denoted as C.

View Article and Find Full Text PDF

Following implantation, infections, inflammatory reactions, corrosion, mismatches in the elastic modulus, stress shielding and excessive wear are the most frequent reasons for orthopedic implant failure. Natural polymer-based coatings showed especially good results in achieving better cell attachment, growth and tissue-implant integration, and it was found that the inclusions of nanosized fillers in the coating structure improves biomineralization and consequently implant osseointegration, as the nanoparticles represent calcium phosphate nucleation centers and lead to the deposition of highly organized hydroxyapatite crystallites on the implant surface. In this study, magnetic nanoparticles synthesized by the co-precipitation method were used for the preparation of cellulose acetate composite coatings through the phase-inversion method.

View Article and Find Full Text PDF

Recycling end-of-life wind turbines poses a significant challenge due to the increasing number of turbines going out of use. After many years of operation, turbines lose their functional properties, generating a substantial amount of composite waste that requires efficient and environmentally friendly processing methods. Wind turbine blades, in particular, are a problematic component in the recycling process due to their complex material composition.

View Article and Find Full Text PDF

The analysis of incremental marks in the enamel, dentine and cementum of extant and extinct species provides important information about the rate and pattern of tooth growth, which permits inferences about key life history traits. Traditionally, such research has mainly focused on primates, while other mammalian groups have remained relatively unexplored. In some cases, this has led to the misidentification of incremental markings and the miscalculation of dental growth parameters in non-primate taxa, which has highlighted the importance of obtaining more reliable comparative frameworks.

View Article and Find Full Text PDF

The ecological impact of tire wear particles (TWP), a significant source of microplastics pollution, is increasingly concerning, especially given their potential effects on the health of aquatic ecosystems. This study investigates the size-dependent ecotoxicological responses of zebrafish (Danio rerio) to TWP exposure, focusing on physiological, metabolic, and microbial community impacts over a 15-day exposure period followed by a 15-day excretion period. Through integrated analysis of gut microbiome composition, liver transcriptomics, and host physiological markers, we found that smaller TWP particles (< 120 μm) induced oxidative stress, evidenced by increased SOD and MDA levels, and inhibited growth by reducing body mass and gut length.

View Article and Find Full Text PDF

Want AI Summaries of new PubMed Abstracts delivered to your In-box?

Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!