The Feasibility of Condylar Screws for Occipitocervical Fusion in Arabs: Computed Tomography-Based Morphometric Study.

Study Design: Retrospective, cross-sectional study.

Objectives: Occipitocervical fusion is indicated for various conditions. Some techniques require placement of screws in the occipital condyle. The objective of this study was to analyze the morphometric features of the occipital condyle among Arabs.

Methods: Computed tomography (CT)-based morphometric analysis of occipital condyles of 200 Arab skeletally mature patients (400 condyles) was done. Axial width of at least 8 mm and coronal height of at least 6.5 mm are the cutoff values for feasibility of condylar screw placement.

Results: The mean age of the patients was 48.0 ± 18.3 years. Males were 53.5% (107) of the sample. The mean axial condylar width and length were 8.5 ± 1.5 mm and 20.3 ± 2.6 mm, respectively, while the mean axial screw angle was 35.9° ± 5.5° from midline. The mean sagittal condylar length and height were 16.1 ± 1.9 mm and 8.8 ± 1.5 mm, respectively. The mean condylar coronal height was 8.2 ± 1.4 mm. Based on axial width and coronal height measurements, 150 (37.5%) condyles could safely fit a 3.5 mm condylar screw. One hundred and four (55.9% female condyles) condyles cannot fit a screw in females, while 46 (21.5% male condyles) condyles cannot fit a screw in males.

Conclusions: Condylar screw for occipitocervical fusion is feasible for the majority of Arabs in our sample; however, this applies to slightly less than half of the female condyles. Detailed preoperative radiological planning is critical to avoid complications related to occipital condyle screw placement.