Plastic pollution is becoming increasingly severe and is attracting global attention. One of its consequences is the recent discovery of micropollutant discharge into water, with Bisphenol A (BA-MP) being a typical example. This study utilizes an advanced oxidation process based on Pt-doped ZnO photocatalyst to remove BA-MP. Health concerns related to the release of BA-MP from plastic waste are discussed. Besides, the results of the photodegradation experiment show that the Pt-ZnO photocatalyst can remove 94.1% of BA-MP within 60 min when exposed to solar light. Moreover, after five reuse cycles, Pt-ZnO retains a high BA-MP removal efficiency of 71.2%, and its structure remains largely unchanged compared to the original material. The removal efficiency of BA-MP leaching from plastic waste was measured at 98.8%, confirming the suitability of Pt-ZnO for the treatment of micropollutants. Furthermore, this study also highlights the prospects and challenges of using Pt-ZnO for the treatment of micropollutants discharged from plastic waste.
Download full-text PDF |
Source |
|---|---|
| http://dx.doi.org/10.1007/s10653-024-02091-3 | DOI Listing |
Publication Analysis
Top Keywords
Similar Publications
Development of heat sealable film from tapioca and potato starch for application in edible packaging.
J Food Sci Technol
February 2025
Department of Food Technology and Nutrition, Faculty of Technology, Mahasarakham University, Maha Sarakham, 44150 Thailand.
This study aimed to fabricate edible films from tapioca (T) and potato (P) starch, assessing their physicochemical properties and biodegradation across different ratios (T100P0, T70P30, T50P50, and T30P70). The films underwent evaluation for moisture content, thickness, water vapor permeability, and color values. T100P0 and T30P70 formulations exhibited the highest film transparency at 43.
View Article and Find Full Text PDFFormulation optimization and characterization of biodegradable containers incorporated with orange peel powder and tamarind seed powder.
J Food Sci Technol
February 2025
Dept. of Food Processing Tech. A. D. Patel Institute of Technology, Charutar Vidya Mandal University, New Vallabh Vidyanagar, Anand, Gujarat India.
Unlabelled: A huge amount of fruits and vegetables is being produced and processed in India and therefore the waste is also generated in high quantities. These wastes are good sources of vitamins, enzymes, cellulose, and many other essential compounds. The non-utilization of these bio-wastes leads to economic loss and also environmental problems.
View Article and Find Full Text PDFInsect farming: A bioeconomy-based opportunity to revalorize plastic wastes.
Environ Sci Ecotechnol
January 2025
Global Centre for Environmental Remediation (GCER), College of Engineering, Science and Environment, University of Newcastle, Callaghan, NSW, 2308, Australia.
Managing plastic waste is one of the greatest challenges humanity faces in the coming years. Current strategies-landfilling, incineration, and recycling-remain insufficient or pose significant environmental concerns, failing to address the growing volume of plastic residues discharged into the environment. Recently, increasing attention has focused on the potential of certain insect larvae species to chew, consume, and partially biodegrade synthetic polymers such as polystyrene and polyethylene, offering novel biotechnological opportunities for plastic waste management.
View Article and Find Full Text PDFChemical upcycling of polybutadiene into size controlled α,ω-dienes and diesters sequential hydrogenation and cross-metathesis.
Chem Sci
January 2025
Centre for Membrane Separations, Adsorption, Catalysis and Spectroscopy for Sustainable Solutions (cMACS), KU Leuven Celestijnenlaan 200F, Post Box 2454 3001 Leuven Belgium
Plastic waste conversion into valuable chemicals is a promising alternative to landfill or incineration. In particular, the chemical upcycling of polybutadiene rubber (PBR) could provide a renewable route towards highly desirable α,ω-dienes with varying chain lengths, which can find ample industrial application. While previous research has shown that the treatment of polybutadiene with a consecutive hydrogenation and ethenolysis reaction can afford long-chain α,ω-dienes, achieving precise control over the product chain length remains an important bottleneck.
View Article and Find Full Text PDFRecycling of Post-Consumer Waste Polystyrene Using Commercial Plastic Additives.
ACS Cent Sci
January 2025
Department of Chemistry, Princeton University, Princeton, New Jersey 08544, United States.
Photothermal conversion can promote plastic depolymerization (chemical recycling to a monomer) through light-to-heat conversion. The highly localized temperature gradient near the photothermal agent surface allows selective heating with spatial control not observed with bulk pyrolysis. However, identifying and incorporating practical photothermal agents into plastics for end-of-life depolymerization have not been realized.
View Article and Find Full Text PDFWant AI Summaries of new PubMed Abstracts delivered to your In-box?
Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!