Carbonaceous materials from a petrol primary oily sludge: Synthesis and catalytic performance in the wet air oxidation of a spent caustic effluent.

Oil refineries produce annually large quantities of oily sludge and non-biodegradable wastewater during petroleum refining that require adequate management to minimize its environmental impact. The fraction solid of the oily sludge accounts for 25 wt% and without treatment for their valorization. This work is focused on the valorization of these solid particles through their transformation into porous materials with enhanced properties and with potential application in the catalytic wet air oxidation (CWAO) of a non-biodegradable spent caustic refinery wastewater. Hence, dealing with the valorization and treatment of both refinery wastes in a circular approach aligned with the petrol refinery transformations by 2050. The obtained oily sludge carbonaceous materials showed improved surface area (260-762 m/g) and a high Fe content. The good catalytic performance of these materials in CWAO processes has been attributed to the simultaneous presence of surface basic sites and iron species. Those materials with higher content of Fe and basic sites yielded the highest degradation of organic compounds present in the spent caustic refinery wastewater. In particular, the best-performing material ACT-NP 1.1 (non-preoxidated and thermically treated with 1:1 mass ratio KOH:solid) showed a chemical oxygen demand (COD) removal of 60 % after 3 h of reaction and with a higher degradation rate than that achieved with thermal oxidation without catalyst (WAO) and that using an iron-free commercial activated carbon. Moreover, the biodegradability of the treated wastewater increased up to 80% (from ca. 31% initially of the untreated effluent). Finally, this material was reused up to three catalytic cycles without losing metal species and keeping the catalytic performance.