Reconciling Coulter Counter and laser diffraction particle size analysis for aquaculture monitoring.

The disaggregated inorganic grain size (DIGS) of bottom sediment analyzed with a Coulter Counter (CC) has been used to show that the fraction of sediment deposited in flocs (floc fraction) increased in both the near and far field after the introduction of open cage salmon aquaculture, altering benthic habitat and species composition. As a result, DIGS was identified as a potential indicator of regional environmental changes due to aquaculture. Laser diffraction is an attractive alternative to the CC because of its greater efficiency and larger size range. To determine if a laser diffraction instrument, Beckman-Coulter LS 13 320 (LS), could replace the CC within a Canadian national aquaculture monitoring program, the DIGS of 581 samples from five different regions in eastern Canada were analyzed with an LS and a CC. Results show that the LS could not be used to calculate floc fraction. Instead, % sortable silt and the volume % of inorganic particles < 16 µm were evaluated as alternative proxies for fine sediment properties. LS and CC values for these parameters were correlated, but they were significantly different and the relationship between the instruments was dependent on the area sampled. The LS did not capture variations between areas seen in the CC DIGS data. Where the DIGS from the CC found no sorting in the finest size classes, all the LS samples had similar size distributions characterized by smooth modal peaks. The LS and CC both return values that can be used to monitor changes in the deposition of fine-grained sediment, but the LS cannot determine changes in floc deposition and caution is required if comparing different sedimentary environments.