This research studies natural rubber (NR) composite blends prepared with recycled polyethylene (PE), polyurethane waste (PU), silica (SiO), and aluminum trihydroxide (ATH) under the proper mixing conditions using an internal mixer and a two-roll mill. The mechanical, impact, dynamic mechanical, and thermal properties, together with flammability, were investigated. NR/PU composites filled with a specific SiO/ATH concentration resulted in excellent flame-retardant properties without using PE. Adding PE causes poor flammability, while using PU and SiO prevents flame extensibility of the composites. In addition, SiO and ATH synergistically improved both mechanical and dynamical mechanical properties. This is attributed to the reinforcement of SiO particles inside the matrix, whereas the ATH releases water as a flame retardant. The V-0 composites tested with UL-94 showed acceptable heat resistance, strength, and durability, making them suitable for interior and exterior applications in buildings without the lightweight requirement.
Download full-text PDF |
Source |
---|---|
http://www.ncbi.nlm.nih.gov/pmc/articles/PMC11207980 | PMC |
http://dx.doi.org/10.3390/polym16121657 | DOI Listing |
Environ Sci Ecotechnol
January 2025
Global Centre for Environmental Remediation (GCER), College of Engineering, Science and Environment, University of Newcastle, Callaghan, NSW, 2308, Australia.
Managing plastic waste is one of the greatest challenges humanity faces in the coming years. Current strategies-landfilling, incineration, and recycling-remain insufficient or pose significant environmental concerns, failing to address the growing volume of plastic residues discharged into the environment. Recently, increasing attention has focused on the potential of certain insect larvae species to chew, consume, and partially biodegrade synthetic polymers such as polystyrene and polyethylene, offering novel biotechnological opportunities for plastic waste management.
View Article and Find Full Text PDFMaterials (Basel)
January 2025
Research Team of Quantitative Methods and Spatial Management, Institute of Agriculture and Horticulture, Faculty of Agricultural Sciences, University of Siedlce, B. Prusa 14, 08-110 Siedlce, Poland.
Plastic film, also known as low-density polyethylene (LDPE), poses serious environmental challenges due to mass production, short life cycle, and poor waste management. The main aim of this paper was to examine the suitability of using agricultural waste film as a binder in construction composites instead of the traditional cement slurry. Molten at temperatures of around 120-150 °C wastes was mixed with fine sand and gravel aggregate as filler.
View Article and Find Full Text PDFSci Rep
January 2025
Department of Mechanical Engineering, Government Engineering College, Barton Hill, Thiruvananthapuram, Kerala, India.
Road accidents are a growing concern worldwide, and crash barriers have significantly reduced the severity of these incidents. In its pursuit of developing an eco-friendly crash barrier, India installed the world's first 200 m bamboo crash barrier, on Bombay-Pune Highway. Although its eco-friendly and recyclable design is commendable, using Bambusa balcooa infused with creosote oil and covered with High-density polyethylene (HDPE) raises substantial health and environmental issues due to the presence of toxic and carcinogenic Polycyclic aromatic hydrocarbons (PAHs).
View Article and Find Full Text PDFSci Rep
January 2025
Department of Mechanical and Industrial Engineering, Manipal Institute of Technology, Manipal Academy of Higher Education, Manipal, Karnataka, 576104, India.
To prevent water scarcity, wastewater must be discharged to the surface or groundwater after being treated. Another method is to reuse wastewater in some areas after treatment and evaluate it as much as possible. In this study, it is aimed to recover and reuse the caustic (sodium hydroxide, NaOH) used in the recycling of plastic bottles from polyethylene terephthalate (PET) washing wastewater.
View Article and Find Full Text PDFChem Commun (Camb)
January 2025
Jiangsu Key Laboratory of Function Control Technology for Advanced Materials, School of Environmental and Chemical Engineering Jiangsu Ocean University Lianyungang, Jiangsu 222005, China.
We propose an effective method for selectively extracting the valuable metals from the spent LiNiCoMnO cathode material using an oxalic acid-based deep eutectic solvent. Through regulation of the coordination environment, NiO, CoO, and MnO are stepwise separated and further applied in the electrochemical conversion of raw PET bottles to high-purity formic acid.
View Article and Find Full Text PDFEnter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!