AI Article Synopsis
- The pericardiocentesis procedure is frequently done, typically through the subxiphoid method, but other techniques exist.
- This text discusses a new off-plane technique for ultrasound-guided pericardiocentesis that utilizes an anterior approach with a linear transducer.
- The real-time ultrasound guidance allows for continuous needle tracking, which helps minimize risks like pneumothorax, accidental cardiac puncture, and injury to the left internal mammary artery (LIMA).
Article Abstract
The pericardiocentesis procedure is common, often performed via the subxiphoid approach, although other transthoracic approaches have been described. This short communication describes an off-plane technique ultrasound-guided pericardiocentesis using an anterior approach, performed using a linear transducer and guided in real-time by ultrasound, offering the advantage of continuous needle tracking to reduce complications associated with this approach such as pneumothorax, inadvertent cardiac puncture, and injury to the left internal mammary artery (LIMA).
Download full-text PDF |
Source |
|---|---|
| http://www.ncbi.nlm.nih.gov/pmc/articles/PMC11196483 | PMC |
| http://dx.doi.org/10.1186/s13089-024-00383-4 | DOI Listing |
Publication Analysis
Top Keywords
Similar Publications
A 62 Hz high-Q 4-spiral mechanical resonator fabricated of a silicon wafer.
Rev Sci Instrum
December 2024
Faculty of Physics, Lomonosov Moscow State University, 119991 Moscow, Russia.
High purity silicon is considered as the test mass material for future cryogenic gravitational-wave detectors, in particular Einstein Telescope-low frequency and LIGO Voyager [(LIGO) Laser Interferometer Gravitational-Wave Observatory]. To reduce the thermal noise of the test masses, it is necessary to study the sources of corresponding losses. Mechanical resonators with frequencies 300 Hz-6 kHz are successfully used for studying, for example, losses in optical coatings of the test mass.
View Article and Find Full Text PDFPuncture Cube Patient-Mounted Navigation System versus Freehand Method for CT-Guided Needle Placement: Study on a Neoprene Covered Elliptical Cylinder Gelatin Phantom.
Cardiovasc Intervent Radiol
November 2024
Department of Diagnostic and Interventional Radiology, Marburg University Hospital, Philipps University Marburg, 35043, Marburg, Germany.
Purpose: The study aims to show how the "Puncture Cube" (PC) (Medical Templates, Egg, Switzerland) compares to the freehand method (FHM) for CT-guided punctures.
Methods: The PC is a patient-mounted disassemblable cube consisting of an upper and lower template with multiple holes each to predefine puncture trajectory. A total of 80 punctures (FHM in-plane, FHM off-plane, PC in-plane, PC off-plane) was performed by 4 radiologists on a target 9.
Off-plane technique ultrasound-guided pericardiocentesis via anterior approach: short communication.
Ultrasound J
June 2024
Cirugía Cardiovascular, Hospital Universitario Mayor-Méderi, Bogotá, Colombia.
Article Synopsis
- The pericardiocentesis procedure is frequently done, typically through the subxiphoid method, but other techniques exist.
- This text discusses a new off-plane technique for ultrasound-guided pericardiocentesis that utilizes an anterior approach with a linear transducer.
- The real-time ultrasound guidance allows for continuous needle tracking, which helps minimize risks like pneumothorax, accidental cardiac puncture, and injury to the left internal mammary artery (LIMA).
Producing two-dimensional dust clouds and clusters using a movable electrode for complex plasma and fundamental physics experiments.
Rev Sci Instrum
May 2024
Department of Mechanical Engineering, University of Memphis, Memphis, Tennessee 38152, USA.
We report a Bidirectional Electrode Control Arm Assembly (BECAA) for precisely manipulating dust clouds levitated above the powered electrode in RF plasmas. The reported techniques allow the creation of perfectly 2D dust layers by eliminating off-plane particles by moving the electrode from outside the plasma chamber without altering the plasma conditions. The tilting and moving of electrodes using BECAA also allows the precise and repeatable elimination of dust particles one by one to achieve any desired number of grains N without trial and error.
View Article and Find Full Text PDFSplit-based elevational localization of photoacoustic guidewire tip by 1D array probe using spatial impulse response.
Phys Med Biol
March 2024
Innovative Technology Laboratory, FUJIFILM Healthcare Corporation, Tokyo, Japan.
. Photoacoustic emitters on the tip of a therapeutic device have been intensively studied for echo-guided intervention purposes. In this study, a novel method for localizing the guidewire tip emitter in the elevation direction using a 1D array probe is proposed to resolve the issue of the tip potentially deviating from the ultrasound-imaged plane.
View Article and Find Full Text PDFWant AI Summaries of new PubMed Abstracts delivered to your In-box?
Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!