Enhanced Thermoelectric Performance in Vacancy-Filling Heuslers due to Kondo-Like Effect.

Adv Mater

Interdisciplinary Materials Research Center, School of Materials Science and Engineering, Tongji University, Shanghai, 201804, China.

Published: August 2024

To improve thermoelectric efficiency, various tactics have been employed with considerable success to decouple intertwined material attributes. However, the integration of magnetism, derived from the unique spin characteristic that other methods cannot replicate, has been comparatively underexplored and presents an ongoing intellectual challenge. A previous research has shown that vacancy-filling Heuslers offer a highly adaptable framework for modulating thermoelectric properties. Here, it is demonstrated how intrinsic magnetic-electrical-thermal coupling can enhance the thermoelectric performance of vacancy-filling Heusler alloys. The materials, NbTiFeCrSb with 0 ≤ x ≤ 0.1, feature a fraction of magnetic Cr ions that randomly occupy the vacancy sites of the NbTiFeSb half-Heusler matrix. These alloys achieve a remarkable thermoelectric figure of merit (zT) of 1.21 at 973 K, owing to increased Seebeck coefficient and decreased thermal conductivity. The mechanism is primarily due to the introduction of magnetism, which increases the density-of-states effective mass (reaching levels up to 15 times that of a free electron's mass) and simultaneously reduces the electronic thermal conductivity. Mass and strain-field fluctuations further reduce the lattice thermal conductivity. Even higher zT values can potentially be achieved by carefully balancing electron mobility and effective mass. This work underscores the substantial prospects for exploiting magnetic-electrical-thermal synergies in cutting-edge thermoelectric materials.

Download full-text PDF

Source
http://dx.doi.org/10.1002/adma.202405858DOI Listing

Publication Analysis

Top Keywords

thermal conductivity
12
thermoelectric performance
8
performance vacancy-filling
8
vacancy-filling heuslers
8
effective mass
8
thermoelectric
5
enhanced thermoelectric
4
heuslers kondo-like
4
kondo-like improve
4
improve thermoelectric
4

Similar Publications

This study investigated silicone composites with distributed boron nitride platelets and carbon microfibers that are oriented electrically. The process involved homogenizing and dispersing nano/microparticles in the liquid polymer, aligning the particles with DC and AC electric fields, and curing the composite with IR radiation to trap particles within chains. This innovative concept utilized two fields to align particles, improving the even distribution of carbon microfibers among BN in the chains.

View Article and Find Full Text PDF

Cellulose-Based Materials and Their Application in Lithium-Sulfur Batteries.

Polymers (Basel)

January 2025

Instituto de Investigaciones en Físico-Química de Córdoba (INFIQC), Consejo Nacional de Investigaciones Científicas y Técnicas (CONICET), Córdoba 5000, Argentina.

Lithium-sulfur (Li-S) batteries are promising candidates for next-generation energy storage due to their high energy density, cost-effectiveness, and environmental friendliness. However, their commercialization is hindered by challenges, such as the polysulfide shuttle effect, lithium dendrite growth, and low electrical conductivity of sulfur cathodes. Cellulose, a natural, renewable, and versatile biopolymer, has emerged as a multifunctional material to address these issues.

View Article and Find Full Text PDF

Comparing Hydrolysable and Condensed Tannins for Tannin Protein-Based Foams.

Polymers (Basel)

January 2025

Department of Land, Environment, Agriculture and Forestry, University of Padua, Viale dell'Università 16, 35020 Padua, Italy.

Tannin-based foams have gained attention as a potential bio-based alternative to conventional synthetic foams. Traditionally, namely condensed tannins (CT) have been used, leaving the potential of hydrolysable tannins (HT) largely unexplored. This study compared the performance of chestnut (HT) and quebracho (CT) in tannin-protein-based foams at different tannin ratios.

View Article and Find Full Text PDF

Acoustic, Mechanical, and Thermal Characterization of Polyvinyl Acetate (PVA)-Based Wood Composites Reinforced with Beech and Oak Wood Fibers.

Polymers (Basel)

January 2025

Research Laboratory for Sustainable Development and Health, Department of Applied Physics, Faculty of Sciences and Technics, Cadi Ayyad University, Marrakesh 40000, Morocco.

Considering the growing need for developing ecological materials, this study investigates the acoustic, mechanical, and thermal properties of wood composites reinforced with beech or oak wood fibres. Scanning electron microscopy (SEM) revealed a complex network of interconnected pores within the composite materials, with varying pore sizes contributing to the material's overall properties. Acoustic characterization was conducted using a two-microphone impedance tube.

View Article and Find Full Text PDF

This review examines the recent advancements and unique properties of polymer-inorganic hybrid materials formed through coordination bonding (Class II hybrids), which enable enhanced functionality and stability across various applications. Here, we categorize these materials based on properties gained through complexation, focusing on electrical conductivity, thermal stability, photophysical characteristics, catalytic activity, and nanoscale self-assembly. Two major synthetic approaches to making these hybrids include homogeneous and heterogeneous methods, each with distinct tradeoffs: Homogeneous synthesis is straightforward but requires favorable mixing between inorganic and polymer species, which are predominantly water-soluble complexes.

View Article and Find Full Text PDF

Want AI Summaries of new PubMed Abstracts delivered to your In-box?

Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!