Solid particles placed at the interface between hydrogels and biological tissues can create an adhesive joint through the adsorption of macromolecules onto their surfaces. Here, we investigated how this adhesion by particle bridging depends on the wetting of tissue surfaces and on the heterogeneities in tissue composition. peeling experiments were performed using poly(ethylene glycol) films coated with aggregates of silica nanoparticles deposited on the internal tissues of porcine liver. We show that the adhesion produced by particle bridging is altered by the presence of fluid wetting the tissue-hydrogel interface. For both uncoated and coated films, a transition from lubricated to adhesive contact was observed when all the interfacial fluid was drained. The presence of a silica nanoparticle coating shifted the transition towards more hydrated conditions and significantly enhanced adhesion in the adhesive regime. After 5 min of contact, the adhesion energy achieved on liver parenchyma with the coated films (7.7 ± 1.9 J m) was more than twice that of the uncoated films (3.2 ± 0.3 J m) or with a surgical cyanoacrylate glue (2.9 ± 1.9 J m). Microscopic observations during and after peeling revealed different detachment processes through either particle detachment or cohesive fracture in the tissue. These mechanisms could be directly related to the microanatomy of the liver parenchyma. The effects of both interfacial wetting and tissue composition on adhesion may provide guidelines to tailor the design of tissue adhesives using particle bridging.
Download full-text PDF |
Source |
---|---|
http://dx.doi.org/10.1039/d4sm00287c | DOI Listing |
PLoS One
January 2025
School of Civil Engineering, Guizhou University, Guiyang, Guizhou, China.
The mechanical properties of jointed rock bodies are important in guiding engineering design and construction. Using the particle flow software PFC2D, we conducted direct shear test simulations on joints with various inclinations and five different roughness levels to examine the models' crack extension penetration paths, damage modes, and strength characteristics. The findings indicate that the direction of the joint influences the pattern of the rock crack and its penetration route.
View Article and Find Full Text PDFFood Res Int
February 2025
School of Food Science and Engineering, Guangdong Province Key Laboratory for Green Processing of Natural Products and Product Safety, South China University of Technology, Guangzhou 510640, China; School of Chemical Engineering and Energy Technology, Dongguan University of Technology, College Road 1, Dongguan 523808, China.
Water-in-oil high internal phase emulsions (W/O-HIPEs) typically rely on large amounts of surfactants to disperse water droplets and usually use crystalline saturated triacylglycerides (TAGs) to enhance processing properties. However, these practices conflict with consumer demands for 'natural' ingredients. This study seeks to develop novel crystal fractions similar to saturated TAGs for the preparation of W/O-HIPEs as low-calorie fat mimetics, focusing on their mechanical and mouthfeel properties, which have received little attention thus far.
View Article and Find Full Text PDFSci Total Environ
January 2025
Department of Geosciences & Natural Resource Management, Geology, University of Copenhagen, Denmark.
Due to increasing plastic production, the continuous release of primary and secondary nanoplastic particles (NPs, <1 μm) has become an emerging contaminant in terrestrial environments. The fate and transport of NPs in subsurface environments remain poorly understood, largely due to the complex interplay of mineralogical, chemical, biological, and morphological heterogeneity. This study examines interactions between abundant subsurface minerals and NPs under controlled water chemistry (1 mM KCl, pH 5.
View Article and Find Full Text PDFJ Sep Sci
January 2025
Department of Pharmaceutical Sciences, University of Perugia, Perugia, Italy.
The objective of this study is to develop an HPLC-UV method for the cost-effective and quantitative determination of vitamin D3 in food, even in the presence of vitamin D2, with a specific focus on egg yolk. During method development, the performance of three stationary phases in resolving the peak of vitamin D2 from that of vitamin D3 was investigated. The physicochemical properties of these phases differed particularly in the extent of hydrophobicity and silanophilic activity, including a GraceSmart RP C18 column without silanol endcapping, a Robusta RP C18 column with silanol endcapping, and a Waters Xbridge RP C18 column with ethylene-bridged hybrid (BEH) particle technology.
View Article and Find Full Text PDFHeliyon
January 2025
Institute of Ecological Conservation and Restoration, Chinese Academy of Forestry, Beijing, 100091, China.
Railway bridges with lower beam bottom clearances in windblown sand areas tend to accumulate sand particles on the sides of the beams, which seriously impacts railway safety. To investigate the effect of beam clearance height on wind-sand movement near the surface, and to determine the minimum clearance height for railway bridges in such areas, computational fluid dynamics using the Euler-Euler two-phase flow model was employed to simulate the wind-sand flow field beneath bridges with different heights. The results indicated that as clearance height increased, both the high-speed area above the bridge and acceleration area under the bridge increased, while the turbulence area on the leeward side remained unchanged.
View Article and Find Full Text PDFEnter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!