This paper presents the results of an extensive investigation into the durability of cold spray repairs to corrosion damage in AA7075-T7351 aluminium alloy specimens where, prior to powder deposition, the surface preparation involved grit blasting. In this context, it is shown that the growth of small naturally occurring cracks in cold spray repairs to simulated corrosion damage can be accurately computed using the Hartman-Schijve crack growth equation in a fashion that is consistent with the requirements delineated in USAF Structures Bulletin EZ-SB-19-01, MIL-STD-1530D, and the US Joint Services Structural Guidelines JSSG2006. The relatively large variation in the / versus Δ curves associated with low values of / highlights the fact that, before any durability assessment of a cold spray repair to an operational airframe is attempted, it is first necessary to perform a sufficient number of tests so that the worst-case small crack growth curve needed to perform the mandated airworthiness certification analysis can be determined.
Download full-text PDF |
Source |
|---|---|
| http://www.ncbi.nlm.nih.gov/pmc/articles/PMC11173465 | PMC |
| http://dx.doi.org/10.3390/ma17112656 | DOI Listing |
Publication Analysis
Top Keywords
Similar Publications
Metal Transfer Behavior and Molten Pool Dynamics in Cold Metal Transfer Pulse Advanced Additive Manufacturing of 7075 Aluminum Alloy.
Micromachines (Basel)
December 2024
The Institute of Technological Sciences, Wuhan University, Wuhan 430072, China.
Wire arc additive manufacturing (WAAM) with a special arc mode of cold metal transfer pulse advanced (CMT-PADV) is an ideal additive manufacturing process for fabricating aerospace components, primarily high-strength aluminum alloys, offering advantages such as high deposition rates and low cost. However, the numerical simulation of the CMT-PADV WAAM process has not been researched until now. In this study, we first developed a three-dimensional fluid dynamics model for the CMT-PADV WAAM of 7075 aluminum alloy, aiming at analyzing the droplet transition and molten pool flow.
View Article and Find Full Text PDFCorrosion Properties of Cold-Sprayed CrC-25(Ni20Cr) Coatings After Heat Treatment.
Materials (Basel)
December 2024
Faculty of Mechatronics and Mechanical Engineering, Kielce University of Technology, Tysiąclecia Państwa Polskiego 7, 25-314 Kielce, Poland.
The corrosion resistance of a CrC-25(Ni20Cr) cermet coating applied to an Al7075 substrate (CrC-25(Ni20Cr)/Al7075) was investigated. The coating was produced using a cold spraying (CS) method. The main aim of the research was to determine the effect of heat treatment on the properties of cermet coatings on the Al7075 substrate.
View Article and Find Full Text PDFThe Effect of Post Heat Treatment on the Microstructure and Mechanical Properties of Cold-Sprayed Zn-6Cu Deposits.
Materials (Basel)
December 2024
Jiangxi Provincial Key Laboratory of Materials Surface Engineering, School of Materials Science and Engineering, Jiujiang University, Jiujiang 332005, China.
To explore the feasibility of preparing Zn alloy bulk, Zn-6Cu deposit was prepared by cold-spraying additive manufacturing. Microstructure, tensile and wear behavior were investigated before and after heat treatment. Cold-sprayed Zn-6Cu deposit was constituted by irregular flattening particles and pores after heat treatment.
View Article and Find Full Text PDFGalactinol synthase gene 5 (MdGolS5) enhances the cold resistance of apples by promoting raffinose family oligosaccharide accumulation.
Plant Physiol Biochem
December 2024
College of Horticulture, Shenyang Agricultural University, Key Lab of Fruit Quality Development and Regulation of Liaoning Province, Shenyang, 110866, China. Electronic address:
Article Synopsis
- Low-temperature stress is a major challenge for apple production, and galactinol acts as a key cryoprotectant.
- Exogenous application of galactinol on apple saplings was shown to reduce damage from cold stress, and transgenic plants overexpressing the MdGolS5 gene exhibited increased cold tolerance.
- The study highlights the potential of galactinol and its biosynthetic pathway in enhancing cold resistance in apples, providing insights for future genetic improvements.
First Report of Postharvest Fruit Rot on Passion Fruit () caused by in the U.S.A.
Plant Dis
January 2025
University of Florida Tropical Research and Education Center, Plant Pathology, 1615 SE 23rd Way, Homestead, Florida, United States, 33031-3314;
The commercial production of passion fruit is geographically limited (California, Florida, and Hawaii), but the development of cold-tolerant varieties could expand it beyond warm-climate states (Stafne et.al. 2023).
View Article and Find Full Text PDFWant AI Summaries of new PubMed Abstracts delivered to your In-box?
Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!