Utilizing Industrial Sludge Ash in Brick Manufacturing and Quality Improvement.

Materials (Basel)

Department of Resources Engineering, National Cheng Kung University, Tainan City 701, Taiwan.

Published: May 2024

This research demonstrates changes in the behaviors and characteristics of sintered bricks while using industrial sludge ash (ISA) and waste glass (WG) as a replacement for clay in the brick manufacturing procedure. Owing to the limited amount of available land in Taiwan, it is becoming increasingly difficult to locate suitable sites for sanitary landfills, which is a common final disposal method for ash that is produced during thermal treatment in sludge factories. To meet the urgent need for land, the final waste disposal must convert this waste into a new resource. This research investigated the feasibility of using general industrial sludge ash waste, due to its abundance and high potential as a raw material in producing bricks. The result of this study shows that the bricks made from ISA and WG under a certain mixture proportion (ISA50%/WG40%/Clay10%) had excellent industrial potentials, such as compressive strength and water absorption rate. However, owing to the wide variety of components from different sources of ISA, the mixture proportion might vary accordingly. This study also analyzed the incineration index, proportion design, and process improvement, as well as investigating the possibility of increasing the total use of sludge ash as a resource. This study shows the potentials of utilizing wastes as raw materials in industrial manufacturing procedures. Therefore, more wastes can be tested and turned into resources in the future.

Download full-text PDF

Source
http://www.ncbi.nlm.nih.gov/pmc/articles/PMC11173697PMC
http://dx.doi.org/10.3390/ma17112568DOI Listing

Publication Analysis

Top Keywords

sludge ash
16
industrial sludge
12
brick manufacturing
8
isa mixture
8
mixture proportion
8
sludge
5
ash
5
utilizing industrial
4
ash brick
4
manufacturing quality
4

Similar Publications

Effects of sewage sludge ash as a recycled phosphorus source on the soil microbiome.

Curr Opin Biotechnol

January 2025

Department of Soil, Water, and Climate, University of Minnesota, Saint Paul, MN, USA. Electronic address:

Ash byproducts have been used as soil amendments to recycle nutrients and modify soil properties such as pH or density. Interest in these practices has continued with increasing emphasis on sustainability, particularly regarding phosphorus reuse from incinerated sewage sludge. Given recent advancements in microbial analyses, the impacts of these practices can now be studied from the soil microbiome perspective.

View Article and Find Full Text PDF

Stabilisation/Solidification of the Zn-Contaminated Loess Silt in View of the Mechanical Properties.

Materials (Basel)

December 2024

Institute of Civil Engineering, Warsaw University of Life Sciences-SGGW, 166 Nowoursynowska Str., 02-787 Warsaw, Poland.

The effectiveness of the stabilisation/solidification process depends upon a number of factors, the most significant of which are the type of binder, contaminants, and soil undergoing treatment. In accordance with the principles of sustainable construction, alternatives to cement are sought after, with the objective of achieving the lowest environmental impact while maintaining a high level of strength and effective binding of the contaminant. In the study of the stabilisation/solidification of zinc-contaminated loess, incinerated sewage sludge fly ash with reactive magnesia was selected as the binder, and the UCS of the mixtures and microstructure was verified after 28 days of treatment.

View Article and Find Full Text PDF

Compared to the laboratory preparation of biochar, there is less research on the adsorption of antibiotics by industrial production of biochar in water. In this study, three types of industrial production biochar (peanut shell biochar, sludge biochar, and perishable waste biochar) were selected, and their adsorption performance for tetracycline in composite-polluted water was systematically studied. The results indicated that the Freundlich equation could well fit the adsorption isotherms of the three types of biochar for tetracycline.

View Article and Find Full Text PDF
Article Synopsis
  • - The study evaluates the safety of using thermochemically treated sewage sludge from a distillery's wastewater treatment plant as a soil additive by examining its physicochemical properties and the bioaccumulation of heavy metals in maize.
  • - Pyrolysis at 400 °C alters the sludge's characteristics positively, increasing pH, carbon, nitrogen, and ash content, while reducing electrical conductivity, cation exchange capacity, and harmful polycyclic aromatic hydrocarbons.
  • - Results show that adding 1% biochar from the treated sludge improves soil properties and doesn't enhance heavy metal uptake in maize or affect cress seed germination, though it does impact the soil's microbial community.
View Article and Find Full Text PDF

Integrating hydrothermal carbonization and chemical leaching to recover biogenic carbon from sewage sludge.

J Environ Manage

January 2025

Université Grenoble Alpes, CEA, LITEN, DTCH, Laboratoire Réacteurs et Procédés (LRP), F-38000, Grenoble, France. Electronic address:

With more than 10 million dry tons annually produced in the EU and a carbon content of approximately 30% db, sewage sludge (SS) can be a strategic source of biogenic carbon. However, the high moisture content and large amount of ash are strong barriers to sustainable valorisation. This study aims to assess the potential of hydrothermal carbonisation (HTC) as a sustainable alternative to sludge drying.

View Article and Find Full Text PDF

Want AI Summaries of new PubMed Abstracts delivered to your In-box?

Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!