The production and construction of crumb rubber modified asphalt (RMA) at high temperatures can produce a large amount of toxic fume, which is detrimental to human health and environment. In this study, a series of composite fume suppression and odor elimination agents (CSEAs) with both physical adsorption and chemical capture functions were adopted to reduce the emissions of volatile organic compounds (VOCs) and hydrogen sulfide (HS). The material composition, microstructure, and specific surface area of CSEA were analyzed by using X-ray diffraction (XRD), scanning electron microscopy (SEM), energy dispersive spectroscopy (EDS), and N adsorption-desorption isotherm (BET). The inhibitory effects of adding CSEA on toxic fume emissions from RMA at high temperatures were investigated through a combination of fume emission tests, HS gas detection, gel permeation chromatography (GPC), and gas chromatography-mass spectrometry technology (GC-MS). The adsorption behavior of CSEA on HS was analyzed through adsorption dynamics. Results showed that the physical and chemical properties of CSEA are stable while chemical adsorption dominates the CSEA's effect on HS. ZnO and Ca(OH) exhibit good crystallization effects on the surface of the carrier by forming mesoporous structures mostly above 3.4 nm in size. The incorporation of CSEA significantly reduced the total emissions of RMA fume and the main components of VOCs in which the average inhibition rate of HS can reach 44 % at an initial 30 mins.
Download full-text PDF |
Source |
---|---|
http://dx.doi.org/10.1016/j.scitotenv.2024.173459 | DOI Listing |
Sci Rep
January 2025
Department of Civil, Environmental, and Architectural Engineering, Worcester Polytechnic Institute, Worcester, USA.
Sisal fiber moisture sensitivity and degradation are treated by alkaline and pozzolanic methods, such as silica fume and kaolin surface coating. However, it is novel that the treatment of sisal fiber by calcined bentonite slurry can coat sisal fiber from moisture and protect it from cement hydration by consuming free lime and reducing cement matrix alkalinity. Therefore, the present study treated sisal fibers with calcined bentonite slurry and investigated the effect of using different lengths and doses of treated and raw sisal fibers in a mortar.
View Article and Find Full Text PDFSci Rep
January 2025
Spectroscopy Department, National Research Centre, El Buhouth St., Dokki, Giza, 12622, Egypt.
Due to the high cost of raw materials, this work aims to benefit from metal waste, especially iron (Fe) and silicon bronze, which results from turning workshops and recycling them to obtain nanocomposites for industrial applications. In this respect, Fe/SiBr/SiN/silica fume nanocomposites possessing superior mechanical, wear, and magnetic characteristics have been produced using powder metallurgy (PM) technology. Milled sample particle size, crystal size, and phase composition were investigated using X-ray diffraction (XRD) technique and transmission electron microscopy (TEM).
View Article and Find Full Text PDFMaterials (Basel)
December 2024
Energy School, Xi'an University of Science and Technology, Xi'an 710054, China.
Fly ash-cement composite backfill slurry, prepared by partially replacing cement with fly ash, has been demonstrated to effectively reduce the mine backfill costs and carbon emissions associated with cement production. However, the use of fly ash often results in insufficient early and medium-term strength of the backfill material. To address the demand for high medium-term strength in backfill materials under continuous mining and backfilling conditions, this study developed a silica fume-fly ash-cement composite backfill slurry.
View Article and Find Full Text PDFMaterials (Basel)
December 2024
Institute of Civil Engineering and Architecture, National University of Water and Environmental Engineering, 33028 Rivne, Ukraine.
By volume, cement concrete is one of the most widely used construction materials in the world. This requires a significant amount of Portland cement, and the cement industry, in turn, causes a significant amount of CO emissions. Therefore, the development of concrete with a reduced cement content is becoming an urgent problem for countries with a significant level of production and consumption of concrete.
View Article and Find Full Text PDFMaterials (Basel)
November 2024
Univ. Lille, CNRS, Centrale Lille, Univ. Artois, UMR 8181, UCCS-Unité de Catalyse et Chimie du Solide, F-59000 Lille, France.
Beryllium metal is used as neutron moderator and reflector or multiplier in certain types of fission or fusion reactors. Dismantling of these reactors will produce radioactive beryllium waste, classified as low- or intermediate-level waste, that will need to be stabilised and solidified before being sent to disposal. The cementation process is under consideration because it may offer a good compromise between simplicity of implementation, cost, and quality of the final cemented wasteform.
View Article and Find Full Text PDFEnter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!