Graphene Quantum Dots as Hole Extraction and Transfer Layer Empowering Solar Water Splitting of Catalyst-Coupled Zinc Ferrite Nanorods.

ACS Appl Mater Interfaces

Department of Condensed Matter Physics and Material Sciences, S. N. Bose National Centre for Basic Sciences, Block JD, Sector-III, Salt Lake, Kolkata, West Bengal 700 106, India.

Published: June 2024

Despite the narrow band gap energy, the performance of zinc ferrite (ZnFeO) as a photoharvester for solar-driven water splitting is significantly hindered due to its sluggish charge transfer and severe charge recombination. This work reports the fabrication of a hybrid nanostructured hydrogenated ZnFeO (ZFO) photoanode with enhanced photoelectrochemical water-oxidation activity through coupling N-doped graphene quantum dots (GQDs) as a hole transfer layer and Co-Pi as a catalyst. The GQDs not only reduce the surface-mediated nonradiative electron-hole pair recombination but also induce a built-in interfacial electric field leading to a favorable band alignment at the ZFO/GQDs interface, helping rapid photogenerated hole separation and serving as a conducting hole transfer highway, improve the hole transportation into the Co-Pi catalyst for enhanced water oxidation reaction kinetics. The optimized ZFO/GQD/Co-Pi hybrid photoanode delivers a 23-fold photocurrent enhancement at 1.23 V versus the reversible hydrogen electrode (RHE) and a significant 360 mV reduction in the onset potential, reaching 0.65 compared with the ZFO photoanode under 1 sun illumination in a neutral electrolytic environment. This investigation underscores the mechanism of synergistic interplay between the hole transport layer and cocatalyst in boosting the solar-illuminated water-splitting activity of the ZFO photoanode.

Download full-text PDF

Source
http://dx.doi.org/10.1021/acsami.4c02723DOI Listing

Publication Analysis

Top Keywords

zfo photoanode
12
graphene quantum
8
quantum dots
8
transfer layer
8
water splitting
8
zinc ferrite
8
hole transfer
8
co-pi catalyst
8
hole
6
dots hole
4

Similar Publications

Zinc ferrite (ZnFeO, ZFO) has gained attention as a candidate material for photoelectrochemical water oxidation. However, champion devices have achieved photocurrents far below that predicted by its bandgap energy. Herein, strong optical interference is employed in compact ultrathin film (8-14 nm) Ti-doped ZFO films deposited on specular back reflectors to boost photoanode performance through enhanced light trapping, resulting in a roughly fourfold improvement in absorption as compared to films deposited on transparent substrates.

View Article and Find Full Text PDF

Graphene Quantum Dots as Hole Extraction and Transfer Layer Empowering Solar Water Splitting of Catalyst-Coupled Zinc Ferrite Nanorods.

ACS Appl Mater Interfaces

June 2024

Department of Condensed Matter Physics and Material Sciences, S. N. Bose National Centre for Basic Sciences, Block JD, Sector-III, Salt Lake, Kolkata, West Bengal 700 106, India.

Despite the narrow band gap energy, the performance of zinc ferrite (ZnFeO) as a photoharvester for solar-driven water splitting is significantly hindered due to its sluggish charge transfer and severe charge recombination. This work reports the fabrication of a hybrid nanostructured hydrogenated ZnFeO (ZFO) photoanode with enhanced photoelectrochemical water-oxidation activity through coupling N-doped graphene quantum dots (GQDs) as a hole transfer layer and Co-Pi as a catalyst. The GQDs not only reduce the surface-mediated nonradiative electron-hole pair recombination but also induce a built-in interfacial electric field leading to a favorable band alignment at the ZFO/GQDs interface, helping rapid photogenerated hole separation and serving as a conducting hole transfer highway, improve the hole transportation into the Co-Pi catalyst for enhanced water oxidation reaction kinetics.

View Article and Find Full Text PDF

Interface designing of efficient Z-scheme Ti-ZnFeO/InO photoanode toward boosting photoelectrochemical water oxidation.

J Colloid Interface Sci

November 2023

Institute of Physical Chemistry, College of Chemistry, Jilin University, Changchun 130012, PR China. Electronic address:

Ti-ZnFeO photoanode has attracted extensive attention in photoelectrochemical (PEC) water oxidation due to its narrow band gap and good photostability. However, its low efficiency limits its development. Herein, we designed and constructed direct Z-scheme Ti-ZnFeO/InO (Ti-ZFO/InO) photoanode.

View Article and Find Full Text PDF

The structural properties of octahedral sites (B ) in spinel oxides (AB O ) play vital roles in the electrochemical performance of oxygen-related reactions. However, the precise manipulation of AB O remains challenging due to the complexity of their crystal structure. Here, a simple and versatile molten-salt-mediated strategy is reported to introduce Ni in B sites intentionally on the surface of zinc ferrite (ZnFe O , ZFO) to promote the active sites for photoelectrochemical (PEC) water splitting.

View Article and Find Full Text PDF

The removal of organic dyes and pathogenic bacteria from contaminated water remains a significant challenge. In the present study, S-type heterojunction AgMoO/ZnFeO (AMO/ZFO) composite nanofibers were synthesized by electrospinning and co-precipitation and fabricated into photoanodes. It is found that the constructed S-type heterojunction of AMO/ZFO composites effectively inhibits the recombination of photogenerated carriers, in addition to the benefits of more exposed active sites and a greater specific surface area.

View Article and Find Full Text PDF

Want AI Summaries of new PubMed Abstracts delivered to your In-box?

Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!