A green chemical analysis of iron (III) in water sample using a smart phone.

MethodsX

Division of Toxicology, Department of Comparative Bioscience, Faculty of Veterinary Medicine, University of Tehran, Tehran, Iran.

Published: June 2024

In this study, a smartphone was used as the photometer for determination of iron (III) by forming a complex with thiocyanate. After color formation at concentrations of, image capture with mobile phone, signal analysis of each sample was performed by the application and converted to the absorption number. The calibration curve was completely linear in the range of 10 to 80 mg L used and the linear coefficient was better than 0.9833. The limits of detection (LOD) and quantification (LOQ) were 0.1 and 0.3 mg L, respectively. Finally, this method was successfully used to measure iron in real samples.•A smartphone was used for the determination of iron (III), showcasing its potential in color compound analysis.•The method demonstrated superior performance in terms of calibration curve range and measurement speed compared to traditional atomic absorption devices.•The technique was successfully applied in the measurement of iron in real samples, indicating its practical applicability.

Download full-text PDF

Source
http://www.ncbi.nlm.nih.gov/pmc/articles/PMC11064597PMC
http://dx.doi.org/10.1016/j.mex.2024.102724DOI Listing

Publication Analysis

Top Keywords

iron iii
12
determination iron
8
calibration curve
8
iron real
8
iron
5
green chemical
4
chemical analysis
4
analysis iron
4
iii water
4
water sample
4

Similar Publications

Ferrous oxalate (FeCO)-based composite has been recognized as an eminent catalyst for Cr(III)-ethylenediamine tetraacetic acid (Cr(III)-EDTA) decomplexation. However, their practical application has been limited by low cycling capacity and an ambiguous mechanism. In this research, a composite catalyst consisting of biotite loaded with nano FeCO (CFS90) was prepared directly from iron-containing silicate tailing.

View Article and Find Full Text PDF

The nonheme iron(II) complexes containing a fluoride anion, Fe(BNPAO)(F) () and [Fe(BNPAOH)(F)(THF)](BF) (), were synthesized and structurally characterized. Addition of dioxygen to either or led to the formation of a fluoride-bridged, dinuclear iron(III) complex [Fe(BNPAO)(F)(μ-F)] (), which was characterized by single-crystal X-ray diffraction, H NMR, and elemental analysis. An iron(II)(iodide) complex, Fe(BNPAO)(I) (), was prepared and reacted with O to give the mononuclear complex -Fe(BNPAO)(OH)(I) ().

View Article and Find Full Text PDF

In this study, 3,4-diaminobenzoic acid (DABA) was introduced into the porphyrin metal-organic framework (PCN-224) for the first time to prepare a ratiometric fluorescent probe (PCN-224-DABA) to quantitatively detect ferric iron (Fe(III)) and selenium (IV) (Se(IV)). The fluorescence attributed to the DABA of PCN-224-DABA at 345 nm can be selectively quenched by Fe(III) and Se(IV), but the fluorescence emission peak attributed to tetrakis (4-carboxyphenyl) porphyrin (TCPP) at 475 nm will not be disturbed. Therefore, the ratio of I/I with an excitation wavelength of 270 nm can be designed to determine Fe(III) and Se(IV).

View Article and Find Full Text PDF

The use of glycerolates of biogenic elements as biocompatible precursors in sol-gel synthesis is an innovative direction and opens up new scientific and practical prospects in chemistry and technology of producing practically important biomedical materials, including hemostatic, antimicrobial, and wound healing materials. Using biocompatible precursors, silicon, zinc, boron, and iron glycerolates, new bioactive nanocomposite hydrogels were obtained by the sol-gel method. The composition and structural features of the hydrogels were studied using a complex of modern analytical techniques, including TEM, XRD, AES, and ESI MS.

View Article and Find Full Text PDF

We are facing a world-wide shortage of clean drinking water which will only be further exacerbated by climate change. The development of reliable and affordable methods for water remediation is thus of utmost importance. Chlorine (which forms active hypochlorites in solution) is the most commonly used disinfectant due to its reliability and low cost.

View Article and Find Full Text PDF

Want AI Summaries of new PubMed Abstracts delivered to your In-box?

Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!