We present a detailed analysis of multiphysics simulation results to evaluate the threshold for catastrophic optical damage (COD) of high-power laser diodes under misaligned external optical feedback. Three different chip designs are investigated: the non-injecting mirror concept, the non-absorbing mirror concept and the introduction of an additional energy barrier within the waveguide near the front facet. Furthermore, a modification of the external resonator that promises a lower sensitivity towards misalignments is considered. The dependence of the COD threshold on the additional design parameters (bandgap change, modification length, focal length) and the impact of the different approaches on electro-optical efficiency as well as beam quality are analyzed. Compared to the initial design, the different chip design concepts promise an increase of the achievable output power by 8%, 27% and 27% respectively, whereas the modified resonator fully prevents feedback-induced failure.
Download full-text PDF |
Source |
|---|---|
| http://dx.doi.org/10.1364/OE.503081 | DOI Listing |
Publication Analysis
Top Keywords
Similar Publications
Three-Dimensional Stacked Stretchable Thermoelectric Device for Virtual Sensation.
ACS Appl Mater Interfaces
January 2025
School of Materials and Energy, University of Electronic Science and Technology of China, Chengdu 610054, P. R. China.
Stretchable electronics have significant applications in wearable applications. However, the extremely low thermal conductivity of elastic encapsulation hinders heat dissipation, leading to performance degradation. For instance, stretchable thermoelectric devices (TEDs) can be used for skin temperature regulation, but poor thermal management limits their cooling performance.
View Article and Find Full Text PDFStudy of Thermal Effects in Fused-Tapered Pure Passive Fibers and Signal Combiners.
Nanomaterials (Basel)
January 2025
School of Physics and Optoelectronic Engineering, Beijing University of Technology, Beijing 100124, China.
This paper investigates the thermal effects in fused-tapered passive optical fibers under near-infrared absorption. The thermal effect is primarily caused by impurities, such as OH-, which absorb incident light and generate heat. Using the finite element method, the volume changes during fiber tapering were simulated, influencing power density and thermal distribution.
View Article and Find Full Text PDFControlling the Crystallinity and Morphology of Bismuth Selenide via Electrochemical Exfoliation for Tailored Reverse Saturable Absorption and Optical Limiting.
Nanomaterials (Basel)
December 2024
State Key Laboratory of High Power Semiconductor Lasers, School of Physics, Changchun University of Science and Technology, Changchun 130022, China.
As an emerging two-dimensional (2D) Group-VA material, bismuth selenide (BiSe) exhibits favorable electrical and optical properties. Here, three distinct morphologies of BiSe were obtained from bulk BiSe through electrochemical intercalation exfoliation. And the morphologies of these nanostructures can be tuned by adjusting solvent polarity during exfoliation.
View Article and Find Full Text PDFRise in intraluminal temperature during ureteroscopy: Is this a concern?
Investig Clin Urol
January 2025
Department of Urology, Seoul National University Bundang Hospital, Seongnam, Korea.
The global increase in urolithiasis prevalence has led to a shift towards minimally invasive procedures, such as retrograde intrarenal surgery, supported by advancements in laser technologies for lithotripsy. Pulsed lasers, particularly the holmium YAG and the newer thulium fiber laser, have significantly transformed the management of upper urinary tract stones. However, the use of high-power lasers in these procedures introduces risks of heat-related injury.
View Article and Find Full Text PDFChemical Vapor Deposition Growth of 2D Nonlayered CuInSe for Vacancy-Assisted Broadband Photodetection.
Small
January 2025
Hangzhou Institute for Advanced Study, University of Chinese Academy of Sciences, Hangzhou, 310024, China.
The properties and device applications of 2D semiconductors are highly sensitive to intrinsic structural defects due to their ultrathin nature. CuInSe (CIS) materials own excellent optoelectronic properties and ordered copper vacancies, making them widely applicable in photovoltaic and photodetection fields. However, the synthesis of 2D CIS nanoflakes remains challenging due to the nonlayered structure, multielement composition, and the competitive growth of various by-products, which further hinders the exploration of vacancy-related optoelectronic devices.
View Article and Find Full Text PDFWant AI Summaries of new PubMed Abstracts delivered to your In-box?
Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!