Lidar sensing can be performed by 1572 nm pulsed laser sources. This work presents the development of a fiber amplifier at this wavelength emitting 1 µs FWHM Gaussian pulses at a repetition rate of 7.5 kHz. We obtain the mitigation of stimulated Brillouin scattering (SBS) by shaping the seed laser spectrum into a frequency comb with sinusoidal phase modulation. This frequency comb is compatible with a coherent dual-comb spectroscopy (DCS) method for a targeted lidar sensing application. The effect of the harmonics spacing and relative intensity on the SBS threshold is studied. Laser pulses are amplified up to 182 µJ (182 W peak power) from a single-mode erbium (Er) and ytterbium (Yb) co-doped fiber. Those results hold promise for seeding large mode area Er-Yb co-doped fiber power amplifiers.
Download full-text PDF |
Source |
---|---|
http://dx.doi.org/10.1364/AO.514650 | DOI Listing |
Sensors (Basel)
December 2024
School of Environment and Resources, Southwest University of Science and Technology, Mianyang 621010, China.
The Daguangbao landslide (DGBL), triggered by the 2008 Wenchuan earthquake, is a rare instance of super-giant landslides globally. The post-earthquake evolution of the DGBL has garnered significant attention in recent years; however, its deformation patterns remain poorly characterized owing to the complex local topography. In this study, we present the first observations of the surface dynamics of DGBL by integrating satellite- and ground-based InSAR data complemented by kinematic interpretation using a LiDAR-derived Digital Surface Model (DSM).
View Article and Find Full Text PDFSensors (Basel)
December 2024
Department of Agricultural, Alimentary, Environmental and Forestry Sciences, Biosystem Engineering Division-DAGRI, University of Florence, Piazzale delle Cascine 15, 50144 Florence, Italy.
The present research aimed to evaluate whether two sensors, optical and laser, could highlight the change in olive trees' canopy structure due to pruning. Therefore, two proximal sensors were mounted on a ground vehicle (Kubota B2420 tractor): a multispectral sensor (OptRx ACS 430 AgLeader) and a 2D LiDAR sensor (Sick TIM 561). The multispectral sensor was used to evaluate the potential effect of biomass variability before pruning on sensor response.
View Article and Find Full Text PDFNanoscale Adv
December 2024
Department of Electrical and Electronic Engineering, Bangladesh University of Engineering and Technology Dhaka Bangladesh
Sci Rep
January 2025
Department of Geomorphology and Quaternary Geology, Faculty of Oceanography and Geography, University of Gdańsk, Bażyńskiego 4, 80-952, Gdańsk, Poland.
This study introduces a novel methodology for estimating and analysing coastal cliff degradation, using machine learning and remote sensing data. Degradation refers to both natural abrasive processes and damage to coastal reinforcement structures caused by natural events. We utilized orthophotos and LiDAR data in green and near-infrared wavelengths to identify zones impacted by storms and extreme weather events that initiated mass movement processes.
View Article and Find Full Text PDFNat Commun
January 2025
State Key Laboratory of Extreme Photonics and Instrumentation, College of Optical Science and Engineering, Zhejiang University, Hangzhou, 310058, China.
The continuous push for high-performance photonic switches is one of the most crucial premises for the sustainable scaling of programmable and reconfigurable photonic circuits for a wide spectrum of applications. Conventional optical switches rely on the perturbative mechanisms of mode coupling or mode interference, resulting in inherent bottlenecks in their switching performance concerning size, power consumption and bandwidth. Here we propose and realize a silicon photonic 2×2 elementary switch based on a split waveguide crossing (SWX) consisting of two halves.
View Article and Find Full Text PDFEnter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!