Fluorescence Spectroscopy Based Identification of Pseudomonas Aeruginosa and Escherichia Coli Suspensions.

J Fluoresc

National Institute of Lasers and Optronics College, Pakistan Institute of Engineering and Applied Sciences, 45650, Nilore, Islamabad, Pakistan.

Published: February 2024

In this article, Fluorescence spectroscopy has been employed for the identification of Pseudomonas aeruginosa (PA) and Escherichia coli (E. coli) in water suspension. Emission spectra of PA and E. coli suspensions have been acquired by using excitation wavelengths from 270 to 420 nm with steps of 10 nm to explore their spectral features. It has been found that the emission spectra of tryptophan, tyrosine, NADH and FAD, being the intracellular biomolecules present in both bacteria, can be used as fingerprints for their identification, differentiation and quantification. Both bacterial strains can clearly be differentiated from water and from each other by using λ 270-290 nm through spectral analysis and from λ: 300-500 nm by applying statistical analysis. Furthermore, calibration curves for different bacterial loads of PA and E. coli suspensions have been produced between colonies forming units per ml (CFUs/ml) the integrated intensities of their emission spectra. CFUs/ml of both bacterial suspensions have been determined through plate count method which was used as cross-reference for the analysis of emission spectra of both bacterial suspensions. These curves may be used to estimate CFU/ml of both PA and E. coli in unknown water suspensions by determining the integrating intensity of their emission spectra.

Download full-text PDF

Source
http://dx.doi.org/10.1007/s10895-024-03608-wDOI Listing

Publication Analysis

Top Keywords

emission spectra
20
coli suspensions
12
fluorescence spectroscopy
8
identification pseudomonas
8
pseudomonas aeruginosa
8
aeruginosa escherichia
8
escherichia coli
8
bacterial suspensions
8
coli
6
suspensions
6

Similar Publications

Temperature Characterization of Perovskite LEDs by Electroluminescence.

Nano Lett

December 2024

State Key Laboratory of Extreme Photonics and Instrumentation, College of Optical Science and Engineering; International Research Center for Advanced Photonics, Zhejiang University, Hangzhou 310027, China.

Despite the rapid progress in perovskite light-emitting diodes (PeLEDs), achieving high stability remains an outstanding challenge. PeLEDs produce heat during operation, raising the temperatures, which accelerate device degradation. To determine the PeLED temperatures, a very limited number of techniques represented by infrared thermal imaging (ITI) are employed.

View Article and Find Full Text PDF

Highly energetic boron (B) particles embedded in hydroxyl-terminated polybutadiene (HTPB) thermosetting polymers represent stable solid-state fuel. Laser-heating of levitated B/HTPB and pure HTPB particles in a controlled atmosphere revealed spontaneous ignition of B/HTPB in air, allowing for examination of the exclusive roles of boron. These ignition events are probed via simultaneous spectroscopic diagnostics: Raman and infrared spectroscopy, temporally resolved high-speed optical and infrared cameras, and ultraviolet-visible (UV-vis) spectroscopy.

View Article and Find Full Text PDF

Microscopic mapping of infrared modulated photoluminescence spectra with a spatial resolution of ∼2 μm.

Rev Sci Instrum

December 2024

State Key Laboratory of Infrared Physics, Shanghai Institute of Technical Physics, Chinese Academy of Sciences, 200083 Shanghai, China.

Infrared photoluminescence (PL) spectroscopy with micron-scale spatial resolution is essential for the optoelectronic characterization of narrow-gap microstructures and single defects, yet it poses significant challenges due to the exceedingly weak PL signal and strong background thermal emission. This work introduces an infrared micro-PL (μPL) mapping system that achieves a spatial resolution of ∼2 μm, leveraging the inherent advantages of the step-scan Fourier transform infrared spectrometer-based modulated PL technique in the mid- and far-infrared regions. The configuration of the experimental system is described, and a theoretical upper limit of spatial resolution is derived to be about 1.

View Article and Find Full Text PDF

Identification of the pollution source of surface water in a chemical park was difficult because many industrial enterprises with complex wastewater components and similar characteristics are located there. Therefore, a national-level chemical park in Jiaxing City was studied, and wastewater samples from ten batches of seven key enterprises in the park were collected and analyzed using 3D excitation emission matrix spectrometry (EEMS) and gas chromatography-mass spectrometry (GC-MS). Parallel factor analysis was used to extract common components of EEMS spectra from different batches of drainage in the same enterprise to construct an EEMS characteristic data matrix.

View Article and Find Full Text PDF

This article studies the synthesis, as well as the structural, vibrational, and optical properties of Eu-doped ZnO quantum dots (QDs) and investigates the energy transfer mechanism from the ZnO host to Eu ions using Reisfeld's approximation. Eu-doped ZnO QDs at varying concentrations (0-7%) were successfully prepared using a wet chemical method. The successful doping of Eu ions into the ZnO host lattice, as well as the composition and valence states of the elements present in the sample, were confirmed through X-ray diffraction (XRD) and X-ray photoelectron spectroscopy (XPS) analyses.

View Article and Find Full Text PDF

Want AI Summaries of new PubMed Abstracts delivered to your In-box?

Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!