Purpose: Although inertial measurement unit (IMU)-based systems have been validated against optoelectronic systems for recording joint kinematics, the accuracy of each system must be evaluated, and measurements from different systems cannot be easily compared. Therefore, this study compared the joint angles recorded using the IMU-based MyoMotion system and the optoelectronic BTS Smart-DX 700 system during Nordic walking.
Methods: The study subject, a long-time Nordic walking instructor, was assigned to walk 12 m/trial (14 trials with 5 sampled gait cycles) at a velocity preferred for Nordic walking. The trials were simultaneously recorded by both systems. The instantaneous lower (ankle, knee, hip) and upper (shoulder, elbow, wrist) limb joint angles were recorded.
Results: The joint angles from MyoMotion were significantly larger or smaller (depending on the joint and plane) than those from BTS.
Conclusions: Joint angles measured by MyoMotion are not interchangeable with values from BTS, and IMU-recorded values should be interpreted carefully. However, MyoMotion can still provide information about intra-individual changes based on the joint angle profiles, e.g., following Nordic walking training.
Download full-text PDF |
Source |
|---|
Publication Analysis
Top Keywords
Similar Publications
Minimally invasive prone lateral retropleural or retroperitoneal antepsoas approach spinal surgery using the rotatable radiolucent Jackson table.
J Spine Surg
December 2024
Department of Orthopedic Surgery, Chung Shan Hospital, Taipei, Taiwan.
Background: Prone lateral spinal surgery for simultaneous lateral and posterior approaches has recently been proposed to facilitate surgical room efficiency. The purpose of this study is to evaluate the feasibility and outcomes of minimally invasive prone lateral spinal surgery using a rotatable radiolucent Jackson table.
Methods: From July 2021 to June 2023, a consecutive series of patients who received minimally invasive prone lateral spinal surgery for various etiologies by the same surgical team were reviewed.
Guide-wire and K-wire readjustment jig for osteotomy and osteosynthesis: An instrument.
J Clin Orthop Trauma
February 2025
Joints and Spine Clinic, Mahavir Nagar, Kandivali West, Mumbai, 400067, India.
Introduction: Numerous orthopaedic procedures including dynamic hip screw plating and various osteotomies require placement of a reference guide pin or K wire to direct bone cuts or for drilling screw holes. Appropriate positioning of these wires is a critical component of surgery. Irrespective of whether one is a seasoned surgeon or an apprentice, these wires often need repositioning and readjustment.
View Article and Find Full Text PDFLumbopelvic hyperlordosis is linked to higher femoral head coverage, lower femoral anteversion and younger age at periacetabular osteotomy.
Knee Surg Sports Traumatol Arthrosc
January 2025
Center for Orthopaedics, Trauma Surgery and Rehabilitation Medicine, University Medicine Greifswald, Greifswald, Germany.
Purpose: The dynamic alignment of the lumbar spine, pelvis and femur is increasingly studied in hip preservation surgery. However, the interaction between lumbopelvic alignment, acetabular and femoral morphology and its influence on patients' preoperative symptom burden remains poorly understood. The aim of this study was to evaluate whether lumbopelvic malalignment affects osseous hip morphology and exacerbates preoperative patient-reported joint functionality in patients undergoing periacetabular osteotomy (PAO).
View Article and Find Full Text PDFImproving the thermal performance of PVC windows with pultruded thermoplastic reinforcement.
Sci Rep
January 2025
Center for Materials Technologies, Skolkovo Institute of Science and Technology, Moscow, Russia.
Today, composite profiles of constant cross section are widely used in advanced engineering structures. The use of composite profiles in window and door structures can reduce thermal bridging and reduce energy consumption for heating and cooling. This article focuses on the production of new, thermoplastic-based structural pultruded profiles and their application in a PVC (polyvinylchloride) window structure as a reinforcement.
View Article and Find Full Text PDFMachine learning analysis of cervical balance in early-onset scoliosis post-growing rod surgery: a case-control study.
Sci Rep
January 2025
Department of Orthopedic Surgery, Beijing Chao-Yang Hospital, Capital Medical University, GongTiNanLu 8#, Chaoyang District, Beijing, 100020, China.
We aimed to analyze the cervical sagittal alignment change following the growing rod treatment in early-onset scoliosis (EOS) and identify the risk factors of sagittal cervical imbalance after growing-rod surgery of machine learning. EOS patients from our centre between 2007 and 2019 were retrospectively reviewed. Radiographic parameters include the cervical lordosis (CL), T1 slope, C2-C7 sagittal vertical axis (C2-7 SVA), primary curve Cobb angle, thoracic kyphosis (TK), C7-S1 sagittal vertical axis (C7-S1 SVA) and proximal junctional angle (PJA) were evaluated preoperatively, postoperatively and at the final follow-up.
View Article and Find Full Text PDFWant AI Summaries of new PubMed Abstracts delivered to your In-box?
Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!