Difunctional Microelectrode Arrays for Single-Cell Electrical Stimulation and pH Detection.

Due to its direct effect on biomolecules and cells, electrical stimulation (ES) is now widely used to regulate cell proliferation, differentiation, and neurostimulation and is even used in the clinic for pain relief, treatment of nerve damage, and muscle rehabilitation. Conventional ES is mostly studied on cell populations, but the heterogeneity of cancer cells results in the inability to access the response of individual cells to ES. Therefore, detecting the extracellular pH change (ΔpHe) after ES at the single-cell level is important for the application of ES in tumor therapy. In this study, cellular ΔpHe after periodic impulse electrostimulation (IES) was monitored in situ by using a polyaniline (PANI)-modified gold microelectrode array. The PANI sensor had excellent sensitivity (53.68 mV/pH) and linear correlation coefficient ( = 0.999) over the pH range of 5.55-7.41. The cells showed different degrees of ΔpHe after the IES with different intervals and stimulation potential. A shorter pulse interval and a higher stimulation potential could effectively enhance stimulation and increase cellular ΔpHe. At 0.5 V potential stimulation, the cellular ΔpHe increased with decreasing pulse interval. However, if the pulse interval was long enough, even at a higher potential of 0.7 V, there was no significant additional ΔpHe due to the insufficient stimulus strength. Based on the above conclusions, the prepared PANI microelectrode arrays (MEAs) were capable of stimulating and detecting single cells, which contributed to the deeper application of ES in tumor therapy.