Microstructure and Air Trace Defects of the Rapidly Solidified ZK60 Magnesium Alloy Ribbon.

ZK60 alloy metal ribbons were prepared successfully in a carbon dioxide atmosphere by varying the speeds of melt spinning. The thin metal ribbon with different solidification speeds was prepared by controlling different rotation speeds, and the influence of solidification speed on the ZK60 ribbon was studied. The results show that the gas mark has a significant effect on the local structure of the ribbon. The gas mark's proportional area of the ZK60 ribbon increases first and then decreases with the increase in roll speed, and the gas mark proportion area is the smallest at 17.6 m/s. With the increase in the solidification rate, the base texture of the ribbon is enhanced, and the proportion of columnar crystals in the ribbon gradually increases. At the rate of 17.6 m/s, columnar crystals run through the entire side of the ribbon, and uniformly distributed spherical-particle phases are found inside the grain. At the speed of 17.6 m/s, the mechanical properties of different areas of the ribbon are close and different from those of the other two speeds, and the performance of the quenching zone is better than that of the slow-cooling zone.