A hydrochromic composite film was fabricated by incorporating silica nanoparticles (SiNPs) with cellulose nanofibers (CNFs). The CNF/SiNP composite film underwent a reversible change in transparency in response to external moisture variation. The CNFs improved the dimensional stability of the CNF/SiNP composite film and induced morphological differences in SiNP agglomerates, which control the water vapor condensation in a porous film. The condensed water in the pores reduced the difference in refractive index over the CNF/SiNP film, enhancing its transparency. The selective transparency of the composite film was challenged by printing CNF/SiNP inks at different composition ratios. The differing susceptibility of the printed patterns to moisture provided selective transparency at specific patterns, which can store dynamic information such as QR or numerical codes by simple water vapor adsorption and desorption.
Download full-text PDF |
Source |
|---|---|
| http://dx.doi.org/10.1016/j.carbpol.2023.121663 | DOI Listing |
Publication Analysis
Top Keywords
Similar Publications
Application of lanthanum-modified silk fibroin/polyvinyl alcohol film for highly selective defluoridation in brick tea infusion.
Int J Biol Macromol
January 2025
State Key Laboratory of Tea Plant Biology and Utilization, Joint Research Center for Food Nutrition and Health of IHM and Anhui Provincial Key Laboratory of Food Safety Monitoring and Quality Control, Anhui Agricultural University, Hefei 230036, PR China; College of Food and Nutrition, Anhui Agricultural University, Hefei 230036, PR China. Electronic address:
To mitigate the risk associated with water-soluble fluoride in tea and to have less influence on the contents of tea infusion, a highly selective lanthanum modified silk fibroin (SF) and polyvinyl alcohol (PVA) composite film (SF/PVA-La) was prepared to remove fluoride from brick tea infusion. Notably, SF/PVA-La could remove about 48 % of the fluoride from in brick tea infusion within 30 min. Importantly, the reduction in total tea polyphenols in brick tea did not exceed 10 %, and the reduction in caffeine was only 0.
View Article and Find Full Text PDFEvolution of Two-Dimensional Perovskite Films Under Atmospheric Exposure and Its Impact on Photovoltaic Performance.
ACS Appl Mater Interfaces
January 2025
Department of Microelectronic Science and Engineering, School of Physical Science and Technology, Ningbo University, Ningbo 315211, China.
Two-dimensional (2D) Ruddlesden-Popper perovskites (RPPs) have garnered significant attention due to their enhanced stability compared with their three-dimensional counterparts. However, the power conversion efficiency (PCE) of 2D perovskite solar cells (2D-PSCs) remains lower than that of 3D-PSCs. Understanding the microstructural evolution of 2D perovskite films during fabrication is essential for improving their performance.
View Article and Find Full Text PDFLignin alkali regulated interfacial polymerization towards ultra-selective and highly permeable nanofiltration membrane.
Nat Commun
January 2025
School of Environmental Science and Engineering, Sun Yat-sen University, Guangzhou, China.
Thin-film composite polyamide (TFC PA) membranes hold promise for energy-efficient liquid separation, but achieving high permeance and precise separation membrane via a facile approach that is compatible with present manufacturing line remains a great challenge. Herein, we demonstrate the use of lignin alkali (LA) derived from waste of paper pulp as an aqueous phase additive to regulate interfacial polymerization (IP) process for achieving high performance nanofiltration (NF) membrane. Various characterizations and molecular dynamics simulations revealed that LA can promote the diffusion and partition of aqueous phase monomer piperazine (PIP) molecules into organic phase and their uniform dispersion on substrate, accelerating the IP reaction and promoting greater interfacial instabilities, thus endowing formation of TFC NF membrane with an ultrathin, highly cross-linked, and crumpled PA layer.
View Article and Find Full Text PDFCu- or Ag-containing Bi-Sb-Te for in-line roll-to-roll patterned thin-film thermoelectrics.
Nat Commun
January 2025
Department of Materials, University of Oxford, Parks Road, Oxford, UK.
The Selective Metallization Technique shows promise for roll-to-roll in-line patterning of flexible electronics using evaporated metals, but challenges arise when applied to sputtering functional materials. This study overcomes these challenges with simultaneous sputtering of Bi-Sb-Te and evaporation of metal (Ag or Cu) for thermoelectric layers when using Selective Metallization Technique. Large-scale manufacturing is demonstrated through roll-to-roll processing of a 0.
View Article and Find Full Text PDFSource Material Design for Realizing >50% Indium-Saving Transparent Electrode toward Sustainable Development of Silicon Heterojunction Solar Cells.
ACS Appl Mater Interfaces
January 2025
School of Materials, Shenzhen Campus of Sun Yat-sen University, No. 66, Gongchang Road, Guangming District, Shenzhen, Guangdong 518107, P.R. China.
Indium (In) reduction is a hot topic in transparent conductive oxide (TCO) research. So far, most strategies have been focused on reducing the layer thickness of In-based TCO films and exploring TCOs. However, no promising industrial solution has been obtained yet.
View Article and Find Full Text PDFWant AI Summaries of new PubMed Abstracts delivered to your In-box?
Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!