Background: Electromagnetic induction hyperthermia is a promising method to treat the deep-seated tumors such as brain and prostatic tumors. This technique is performed using the induction of electromagnetic waves in the ferromagnetic cores implanted at the solid tumor.
Objective: This study aims at determining the conditions of the optimal thermal distribution in the different frequencies before performing the in vitro cellular study.
Material And Methods: In this experimental study, the i-Cu alloy (70.4-29.6; wt%) was prepared and characterized and then the parameters, affecting the amount of induction heating in the ferromagnetic core, were investigated. Self-regulating cores in 1, 3, 6, and 9 arrangements in the water phantom with a volume of 2 cm were used as a replacement for solid tumor.
Results: Inductively Coupled Plasma (ICP) analysis and Energy Dispersive X-ray Spectroscopy (EDS) show the uniformity of the alloy after 4 times remeling by vacuum arc remelting furnace. The Vibrating Sample Magnetometer (VSM) shows that the Curie temperature (T) of the ferromagnetic core is less than 50 °C. Temperature profile with a frequency of 100-400 kHz for 30 min, was extracted by infrared imaging camera, indicating the increase temperature in the range of 42 °C to 46 °C.
Conclusion: The optimum conditions with used hyperthermia system are supplied in the frequency of 100 kHz, 200 kHz and 400 kHz with 6, 3 and 1 seeds, respectively. It is also possible to induce a temperature up to 50 °C by increasing the number of seeds at a constant frequency and power, or by increasing the applied frequency at a constant number of seeds.
Download full-text PDF |
Source |
|---|---|
| http://www.ncbi.nlm.nih.gov/pmc/articles/PMC10749418 | PMC |
| http://dx.doi.org/10.31661/jbpe.v0i0.2101-1261 | DOI Listing |
Publication Analysis
Top Keywords
Similar Publications
Magnetic vortex: Fundamental physics, developments, and device applications.
J Phys Condens Matter
January 2025
Institute of Engineering & Management, Department of Basic Science and Humanities, Institute of Engineering & Management, Salt Lake Electronics Complex, Sector V, Salt Lake, Kolkata 700091, India, University of Engineering & Management, University Area, Plot No. III, B/5, New Town Road, Action Area III, Newtown, Kolkata 700160, India, Calcutta, West Bengal, 700091, INDIA.
A magnetic vortex (MV) is one of the fundamental and topologically nontrivial spin textures in condensed matter physics. Magnetic vortices are usually the ground states in geometrically restricted ferromagnets with zero magnetocrystalline anisotropy. Magnetic vortices have recently been proposed for use in a variety of spintronics applications due to their resistance to thermal perturbations, flexibility in changing core polarity, simple patterning procedure, and potential uses in magnetic data storage with substantial density, sensors for the magnetic field, devices for logic operations, and other related fields.
View Article and Find Full Text PDFDirect observation of the interface reaction dynamics of the NdCeFeB phase annealing & quenching STEM.
RSC Adv
January 2025
Department of Materials Science and Engineering, University of Texas Dallas 800 W Campbell Rd Richardson TX 75080 USA
Although the Rare Earth (RE)FeB type magnets were invented in the 1980s and are widely used worldwide. Yet, the phase formation and dissolution mechanisms are still not crystal clear. The reaction dynamics between rare earth elements (REE) and the iron-enriched matrix are essential to understanding the formation of hard magnetic REE-Fe-B phase or, conversely, phase dissociation and performance degeneration.
View Article and Find Full Text PDFInvestigating skyrmion stability and core polarity reversal in NdMnGe.
Sci Rep
January 2025
Laboratory for Mesoscopic Systems, Department of Materials, ETH Zurich, 8093, Zurich, Switzerland.
We present a study on nanoscale skyrmionic spin textures in [Formula: see text], a rare-earth complex noncollinear ferromagnet. We confirm, using X-ray microscopy, that [Formula: see text] can host lattices of metastable skyrmion bubbles at room temperature in the absence of a magnetic field, after applying a suitable field cooling protocol. The skyrmion bubbles are robust against temperature changes from room temperature to 330 K.
View Article and Find Full Text PDFA coaxial solid state nonlinear pulse forming line with an exponentially tapered ferrite composite core.
Rev Sci Instrum
December 2024
School of Nuclear Engineering, Purdue University, West Lafayette, Indiana 47907, USA.
The need to optimize size, weight, and power of high-power microwave (HPM) systems has motivated the development of solid-state HPM sources, such as nonlinear transmission lines (NLTLs), which utilize gyromagnetic precession or dispersion to generate RF. One recent development implemented the NLTL as a pulse forming line (PFL) to form a nonlinear pulse forming line (NPFL) system that substantially reduced the system's size by eliminating the need for a separate PFL; however, matching standard loads can be challenging. This paper describes the development of a tapered NPFL using an exponentially tapered composite based ferrite core containing 60% nickel zinc ferrite (by volume) encased in polydimethylsiloxane (PDMS) and encapsulated in a 5% barium strontium titanate shell.
View Article and Find Full Text PDFAntiferromagnetic spin-torque diode effect in a kagome Weyl semimetal.
Nat Nanotechnol
December 2024
The Institute for Solid State Physics, The University of Tokyo, Kashiwa, Japan.
Spintronics based on ferromagnets has enabled the development of microwave oscillators and diodes. To achieve even faster operation, antiferromagnets hold great promise despite their challenging manipulation. So far, controlling antiferromagnetic order with microwave currents remains elusive.
View Article and Find Full Text PDFWant AI Summaries of new PubMed Abstracts delivered to your In-box?
Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!