AI Article Synopsis

  • Achieving the right droplet size for aerial spraying using unmanned aerial spray systems (UASSs) is challenging due to weight and pressure limitations.
  • A study calibrated a UASS to produce droplet sizes of 48 µm for effective dispersal at a height of 23 m, confirming a spray pattern and effective ground coverage over significant distances.
  • Results showed a 13-36% ground deposition of the sprayed material, suggesting aerial adulticiding is viable, but further improvements in atomization techniques and altitude effects on droplet size are needed for operational efficiency.

Article Abstract

Achieving an appropriate droplet size distribution for adulticiding has proved problematic for unmanned aerial spray systems (UASSs). The high-pressure pumping systems utilized on crewed aircraft conflict with the weight constraints of UASSs. The alternative is a lightweight rotary atomizer, which when run at a maximum rpm with a minimal flow rate can achieve the appropriate droplet size distribution. For this study a UASS was calibrated to discharge an appropriate droplet size distribution (Dv0.5 of 48 µm and Dv0.9 of 76 µm). Spray was released from an altitude of 23 m (75 ft). The spray plume was shown to effectively disperse through the sampling zone. To achieve the appropriate application rate, the flight speed was 3 m/sec (6.7 mph) with an assumed swath of 150 m (500 ft). The objective of this project was not to conduct an operational application; instead only 1 flight line was used so that the effective swath width could be confirmed and the appropriate flightline separation defined. This study showed that control was achieved across distances of 100-150 m. Considering a swath width of 150 m (500 ft), ground deposition was 13-36% of applied material. Spray deposition corresponded well with the mortality data, which helped improve confidence in the data. The overall conclusion from this study is that aerial adulticiding is feasible with the system presented here. Further work is required to improve the atomization system to allow operational flight speeds and to determine the interaction between release altitude and droplet size in order to minimize ground deposition of application material.

Download full-text PDF

Source
http://dx.doi.org/10.2987/23-7140DOI Listing

Publication Analysis

Top Keywords

droplet size
16
appropriate droplet
12
size distribution
12
aerial spray
8
spray systems
8
achieve appropriate
8
150 500
8
swath width
8
ground deposition
8
spray
5

Similar Publications

It is crucial to investigate new anti-diabetic agents and therapeutic approaches targeting molecules in potential signaling pathways for the treatment of Type 2 diabetes mellitus (T2DM). The objective of the study was to investigate the total phenolic content, antioxidant capacity, α-glucosidase, and α-amylase inhibitory activities of Bolanthus turcicus (B. turcicus), as well as their cytotoxic, anti-adipogenic, anti-diabetic, apoptotic, and anti-migration potential on adipocytes.

View Article and Find Full Text PDF

Surface-enhanced Raman scattering (SERS) is a powerful optical sensing platform that amplifies the target signals by Raman scattering. Despite SERS enabling a meager detection limit, even at the single-molecule level, SERS also tends to equally enhance unwanted molecules due to the non-specific binding of noise molecules in clinical samples, which complicates its use in complex samples such as bodily fluids, environmental water, or food matrices. To address this, we developed a novel non-fouling biomimetic SERS sensor by self-assembling an anti-adhesive, anti-fouling, and size-selective Lubricin (LUB) coating on gold nanoparticle (AuNP) functionalized glass slide surfaces via a simple drop-casting method.

View Article and Find Full Text PDF

Purpose: This study investigates the impact of various mixing parameters and surfactant combinations on the physical characteristics of nanoemulsions produced using high-speed homogenization. Nanoemulsions are explored for their capacity to enhance transdermal drug delivery in pharmaceutical and cosmetic contexts.

Methods: Employing a standard high-speed homogenizer typical in the cosmetic industry, we tested different combinations of Polysorbate (Tween®) and Sorbitan ester (Span®) surfactants under single and intermittent process configurations.

View Article and Find Full Text PDF

In this research, the emulsification method was used to encapsulate in microparticles of whey protein concentrate (WPC) at different levels (1%, 2%, and 4%) and gum Arabic (GA) at three levels (0/5%, 1%, and 1/5%) and a constant level of sunflower oil (5%). The results showed that emulsions with higher quantities of wall materials exhibited better encapsulation efficiency (67%/57%) and preservation ability at different temperatures, different pH, and presence of 1% bile salt. During the storage time, the droplet size of the emulsion increased more than two times (from 2.

View Article and Find Full Text PDF

During the study of algal diversity in pyroclastic deposits of the Kamchatka Peninsula, Chlorella-like green algae strains VCA-72 and VCA-93 were isolated from samples collected from along the Baydarnaya river bed on the Shiveluch volcano in 2018 and at the outlet of thermal vapors along the edge of the caldera on the southern slope of the Gorely volcano in 2020. Identification of the strains was carried out within the framework of an integrative approach using microscopic and molecular genetic methods, including preliminary taxon identification, obtaining nucleotide sequences of the small subunit and the internal transcribed spacer rRNA, reconstruction of phylogenetic trees and secondary structures of the ITS1 and ITS2 rRNA regions. On the phylogenetic tree, strain VCA-93 was clustered in the Micractinium thermotolerans species clade.

View Article and Find Full Text PDF

Want AI Summaries of new PubMed Abstracts delivered to your In-box?

Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!