Fiber-reinforced phenolic resin aerogel (FRPRA) composite materials are seductive candidates for high-temperature thermal protection owing to their low density, excellent thermostability, and thermal insulation. However, the intrinsic stiffness restricts their further application for high efficiency. We report a homogeneous and chemical bonding strategy for fabricating lightweight and flexible FRPRA with good ablative thermal insulation performance. The compressible (cyclic strain of 60%) and bendable (cyclic strain of 30%) abilities as well as the structural stability during ablation all benefit from the compatibility between the phenolic resin aerogel matrix and the phenolic fiber reinforcement. Additionally, low bulk density and thermal conductivity of 0.20 g cm and 0.043 W m K, respectively, endow the composite with efficient thermal insulation capability. With an 8 mm-thick coupon, the temperature of 200 °C can be decreased to 70.6 °C and the temperature around 1200 °C can be camouflaged to 78 °C through combining with the Al panel. The material also enables a conformal stealth of 600 °C based on its bendability. Hence, the composite has potential in applications of both static and dynamic thermal insulation.
Download full-text PDF |
Source |
|---|---|
| http://dx.doi.org/10.1021/acsami.3c16147 | DOI Listing |
Publication Analysis
Top Keywords
Similar Publications
A magneto-thermoelectric with a high figure of merit in topological insulator BiSb.
Nat Mater
January 2025
Max Planck Institute for Chemical Physics of Solids, Dresden, Germany.
High thermoelectric performance is generally achieved by synergistically optimizing two or even three of the contradictorily coupled thermoelectric parameters. Here we demonstrate magneto-thermoelectric correlation as a strategy to achieve simultaneous gain in an enhanced Seebeck coefficient and reduced thermal conductivity in topological materials. We report a large magneto-Seebeck effect and high magneto-thermoelectric figure of merit of 1.
View Article and Find Full Text PDFSulfur chains glass formed by fast compression.
Nat Commun
January 2025
Center for High Pressure Science and Technology Advanced Research, Beijing, 100093, China.
Due to the sulfur's atoms' propensity to form molecules and/or polymeric chains of various sizes and configuration, elemental sulfur possesses more allotropes and polymorphs than any other element at ambient conditions. This variability of the starting building blocks is partially responsible for its rich and fascinating phase diagram, with pressure and temperature changing the states of sulfur from insulating molecular rings and chains to semiconducting low- and high-density amorphous configurations to incommensurate superconducting metallic atomic phase. Here, using a fast compression technique, we demonstrate that the rapid pressurisation of liquid sulfur can effectively break the molecular ring structure, forming a glassy polymeric state of pure-chain molecules (Am-S).
View Article and Find Full Text PDFEmergent Symmetry and Valley Chern Insulator in Twisted Double-Bilayer Graphene.
Phys Rev Lett
December 2024
Microelectronics Research Center, Department of Electrical and Computer Engineering, The University of Texas at Austin, Austin, Texas 78758, USA.
Theoretical calculations show that twisted double bilayer graphene (TDBG) under a transverse electric field develops a valley Chern number 2 at charge neutrality. Using thermodynamic and thermal activation measurements we report the experimental observation of a universal closing of the charge neutrality gap in the Hofstadter spectrum of TDBG at 1/2 magnetic flux per unit cell, in agreement with theoretical predictions for a valley Chern number 2 gap. Our theoretical analysis of the experimental data shows that the interaction energy, while larger than the flat-band bandwidth in TDBG near 1° does not alter the emergent valley symmetry or the single-particle band topology.
View Article and Find Full Text PDFMolecular orientation of dielectric layers at indigo/dielectric interfaces impacts the ordering of indigo films in organic field-effect transistors.
J Chem Phys
January 2025
Graduate School of Engineering, Chiba University, 1-33, Yayoi-cho, Inage-ku, Chiba, Chiba 263-8522, Japan.
Organic multilayer systems, which are stacked layers of different organic materials, are used in various organic electronic devices such as organic light-emitting diodes (OLEDs) and organic field-effect transistors (OFETs). In particular, OFETs are promising as key components in flexible electronic devices. In this study, we investigated how the inclusion of an insulating tetratetracontane (TTC) interlayer in ambipolar indigo-based OFETs can be used to alter the crystallinity and electrical properties of the indigo charge transport layer.
View Article and Find Full Text PDFFrom Dielectric to Electro-Responsive Thermoplastics: An Approach Based on Electro-Thermal Reorientation and Charged Gas Activation.
ACS Appl Polym Mater
December 2024
IMEM-BRT Group, Departament d'Enginyeria Química, EEBE, Universitat Politécnica de Catalunya, C/Eduard Maristany, 10-14, 08019 Barcelona, Spain.
The transition from insulator to electro-responsive has been successfully achieved by earlier studies for some inorganic materials by applying external stimuli that modify their 3D and/or electronic structures. In the case of insulating polymers, this transition is frequently accomplished by mixing them with other electroactive materials, even though a few physical treatments that induce suitable chemical modifications have also been reported. In this work, a smart approach based on the application of an electro-thermal reorientation process followed by a charged gas activation treatment has been developed for transforming insulating 3D printed polymers into electro-responsive materials.
View Article and Find Full Text PDFWant AI Summaries of new PubMed Abstracts delivered to your In-box?
Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!